- 您現在的位置：買賣IC網 > PDF目錄370428 > HB288016MM1 (Hitachi,Ltd.) MultiMediaCard 16 MByte PDF資料下載
參數資料
| 型號： | HB288016MM1 |
| 廠商： | Hitachi,Ltd. |
| 英文描述： | MultiMediaCard 16 MByte |
| 中文描述： | 多媒體16字節 |
| 文件頁數： | 51/79頁 |
| 文件大?。?/td> | 233K |
| 代理商： | HB288016MM1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁當前第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁
HB288016MM1
51
Bus Transfer Protection
Every MultiMediaCard token transferred on the bus is protected by CRC bits. In SPI mode, the
MultiMediaCard offers a non protected mode which enables systems built with reliable data links to
exclude the hardware or firmware required for implementing the CRC generation and verification
functions. In the non-protected mode the CRC bits of the command, response and data tokens are still
required in the tokens. However, they are defined as “don’t care” for the transmitter and ignored by the
receiver. The SPI interface is initialized in the non protected mode. The host can turn this option on and
off using the CRC_ON_OFF command (CMD59).
Data Read Overview
The SPI mode supports single block read operations only (CMD17 in the MultiMediaCard protocol). Upon
reception of a valid read command the card will respond with a response token followed by a data token of
the length defined in a previous SET_BLOCKLEN (CMD16) command (refer to Figure “Read
Operation”).
Data in
Data out
command
response
data block CRC
command
from
host
to card
from
card
to host
data from card
to host
Next
commnand
Read Operation
A valid data block is suffixed with a 16 bit CRC generated by the standard CCITT polynomial
x
16
+ x
12
+ x
5
+1.
The maximum block length is given by READ_BL_LEN, defined in the CSD. If partial blocks are allowed
(i.e. the CSD parameter READ_BL_PARTIAL equals 1), the block length can be any number between 1
and the maximum block size. Otherwise, the only valid block length for data read is given by
READ_BL_LEN. The start address can be any byte address in the valid address range of the card. Every
block, however, must be contained in a single physical card sector. In case of a data retrieval error, the card
will not transmit any data. Instead, a special data error token will be sent to the host. Figure “Read
Operation-Data Error” shows a data read operation which terminated with an error token rather than a data
block.
相關PDF資料 |
PDF描述 |
|---|---|
| HB288096C5 | CompactFlash(閃速CompactFlash 卡) |
| HB288160C5 | CompactFlash(閃速CompactFlash 卡) |
| HB2881000A5 | FLASH ATA Card 1 GByte |
| HB2881000A6 | FLASH ATA Card |
| HB288160A5 | FLASH ATA Card |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HB288032A5 | 制造商:HITACHI 制造商全稱:Hitachi Semiconductor 功能描述:FLASH ATA Card |
| HB288032A6 | 制造商:HITACHI 制造商全稱:Hitachi Semiconductor 功能描述:FLASH ATA Card |
| HB288032C5 | 制造商:HITACHI 制造商全稱:Hitachi Semiconductor 功能描述:CompactFlash⑩ |
| HB288032C6 | 制造商:HITACHI 制造商全稱:Hitachi Semiconductor 功能描述:CompactFlash⑩ |
| HB288032MM1 | 制造商:HITACHI 制造商全稱:Hitachi Semiconductor 功能描述:MultiMediaCard 32 MByte |
發布緊急采購，3分鐘左右您將得到回復。