參數資料
型號： GT3200
廠商： SMSC Corporation
英文描述： USB2.0 PJY IC
中文描述： USB2.0接口PJY集成電路
文件頁數： 33/51頁
文件大?。?/td> 1462K
代理商： GT3200
USB2.0 PHY IC
SMSC GT3200, SMSC USB3250
28
Revision 1.3 (10-05-04)
DATASHEET
8.2
OPMODES
The OPMODE[1:0] pins allow control of the operating modes.
The OPMODE[1:0] signals are normally changed only when the transmitter and the receiver are
quiescent, i.e. when entering a test mode or for a device initiated resume.
When using OPMODE[1:0] = 10 (state 2), OPMODES are set, and then 5 60MHz clocks later,
TXVALID is asserted. In this case, the SYNC and EOP patterns are not transmitted.
The only exception to this is when OPMODE[1:0] is set to state 2 while TXVALID has been asserted
(the transceiver is transmitting a packet), in order to flag a transmission error. In this case, the PHY
has already transmitted the SYNC pattern so upon negation of TXVALID the EOP must also be
transmitted to properly terminate the packet. Changing the OPMODE[1:0] signals under all other
conditions, while the transceiver is transmitting or receiving data will generate undefined results.
Under no circumstances should the device controller change OPMODE while the DP/DM lines are still
transmitting or unpredictable changes on DP/DM are likely to occur. The same applies for
TERMSELECT and XCVRSELECT.
8.3
Test Mode Support
8.4
SE0 Handling
For FS operation, IDLE is a J state on the bus. SE0 is used as part of the EOP or to indicate reset.
When asserted in an EOP, SE0 is never asserted for more than 2 bit times. The assertion of SE0 for
more than 2.5us is interpreted as a reset by the device operating in FS mode.
Table 8.2 Operational Modes
MODE[1:0]
STATE#
STATE NAME
DESCRIPTION
00
0
Normal Operation
Transceiver operates with normal USB data encoding
and decoding
01
1
Non-Driving
Allows the transceiver logic to support a soft disconnect
feature which tri-states both the HS and FS transmitters,
and removes any termination from the USB making it
appear to an upstream port that the device has been
disconnected from the bus
10
2
Disable Bit
Stuffing and NRZI
encoding
Disables bitstuffing and NRZI encoding logic so that 1's
loaded from the TXDATA bus become 'J's on the DP/DM
and 0's become 'K's
11
3
Reserved
N/A
Table 8.3 USB2.0 Test Mode to Macrocell Mapping
USB2.0 TEST MODES
GT3200, SMSC USB3250 SETUP
OPERATIONAL MODE
SIE TRANSMITTED
DATA
XCVRSELECT &
TERMSELECT
SE0_NAK
Normal
No transmit
HS
J
Disable
All '1's
HS
K
Disable
All '0's
HS
Test_Packet
Normal
Test Packet data
HS
相關PDF資料
PDF描述
GT3200-ABZJ USB2.0 PJY IC
GT3200-JD Aluminum Electrolytic Radial Leaded General Purpose Capacitor; Capacitance: 33uF; Voltage: 16V; Case Size: 5x11 mm; Packaging: Bulk
GT3200-JN USB2.0 PJY IC
GT3200-JV USB2.0 PJY IC
GTF701-HS3 2-Line EMI-Filter with ESD -Protection
相關代理商/技術參數
參數描述
GT3200_06 制造商:SMSC 制造商全稱:SMSC 功能描述:USB2.0 PHY IC
GT3200-ABZJ 制造商:SMSC 制造商全稱:SMSC 功能描述:USB2.0 PJY IC
GT3200-JD 制造商:Rochester Electronics LLC 功能描述:GAIN TECHNOLOGY - Bulk
GT3200-JN 制造商:SMSC 制造商全稱:SMSC 功能描述:USB2.0 PJY IC
GT3200-JV 制造商:Microchip Technology 功能描述:PHY 1-CH 12Mbps/480Mbps
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*