- 您現在的位置：買賣IC網 > PDF目錄370311 > GCIXF1002EC Controller Miscellaneous - Datasheet Reference PDF資料下載
參數資料
| 型號： | GCIXF1002EC |
| 英文描述： | Controller Miscellaneous - Datasheet Reference |
| 中文描述： | 控制器雜項-數據表參考 |
| 文件頁數： | 14/128頁 |
| 文件大?。?/td> | 1262K |
| 代理商： | GCIXF1002EC |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁
Intel
IXF1002 Dual Port Gigabit Ethernet Controller
14
Datasheet
eop/eop_rxf
I/O
End of packet.
In full-64 mode and in narrow mode (eop
–
I/O):
When asserted during transmit, indicates that the final data in the packet is
written to the transmit FIFO. During receive, eop is asserted when the final
data of the packet is transferred from the receive FIFO to the IX Bus.
In split mode (eop_rxf
–
output):
During receive, eop_rxf is asserted when the final data of the packet is
transferred from the receive FIFO to the IX Bus. In the following FIFO
access cycle, the packet status is driven onto the bus (see
Section 4.3.1.1
).
End of packet.
In full-64 mode and in narrow mode:
This signal is not in use and should be connected to a pull up resistor.
In split mode:
During transmit, indicates that the final data in the packet is written to the
transmit FIFO.
VLAN tag.
When asserted during transmit before sop assertion, VLAN tag will be appended
to the transmitted packet. When asserted during transmit together with sop
assertion, VLAN tag will be stripped from the transmitted packet. When asserted
during transmit before and also together with sop assertion, VLAN tag will be
replaced. See
Section 4.2.2
for more details.
NOTE:
In case of VLAN tag append, strip or replace, the frame check sequence
(FCS) field will be calculated by the IXF1002 (see
Section 4.2.2.1
).
Transmit as is/Transmit error.
When asserted during transmit, upon transfer of the packet
’
s first data (together
with sop assertion), no padding and/or CRC is appended to the packet even if
the port was programmed to do so. When asserted upon transfer of the packet
’
s
final data (together with eop assertion), the packet is transmitted with a CRC
error (if the port is programmed to append CRC), and a GMII error or a symbol
error (GPCS mode).
Receive packet failure.
This signal is asserted if a packet was received with errors, had started to appear
on the IX Bus, and was discarded from the receive FIFO.
Receive abort.
This signal forces a received packet, that is currently being transferred to the IX
Bus, to be aborted and flushed from the receive FIFO. May be asserted only with
rxsel_l assertion. Any following packets loaded onto the receive FIFO are not
affected by rxabt assertion.
Flow control.
When asserted, a flow-control packet with the programmed pause time is
transmitted. Upon deassertion, a flow-control packet with time equal to 0 is sent
if programmed accordingly. For correct latch of flct pin in the chip - signal flct_{i}
should be valid until 1 cycle after flct_lat deassertion.
Flow control pin enable
When asserted the flct_{i} pin will be sampled by the IXF1002. When deasserted,
the IXF1002 will latch the value of the flct_{i} pin, ignoring subsequent changes
to the flct_{i} pin.
Transmit control enable.
When asserted, this pin enables the txrdy_{i} output drivers to report the transmit
FIFO status.
Receive control enable.
When asserted, this pin enables the rxrdy_{i} output drivers to report the receive
FIFO status.
eop_txf
I
vtg
I
txasis/txerr
I
rxfail
O
rxabt
I
flct_{i}
I
flct_lat
I
txctl_l
I
rxctl_l
I
Table 2. Signal Descriptions (Sheet 4 of 6)
Signal Name
I/O
Pin Description
相關PDF資料 |
PDF描述 |
|---|---|
| GCIXF1002ED | Controller Miscellaneous - Datasheet Reference |
| GCIXF1002EDT | Controller Miscellaneous - Datasheet Reference |
| GCIXF440AC | Controller Miscellaneous - Datasheet Reference |
| GCIXF440ACT | Controller Miscellaneous - Datasheet Reference |
| GCIXP1250-166 | Microprocessor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GCIXF1002ED | 功能描述:IC 2PORT GIGBIT ETHNT MAC 304BGA RoHS:否 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A |
| GCIXF1002EDT | 制造商:Intel 功能描述:Ethernet CTLR Single Chip 1000Mbps 3.3V 304-Pin ESBGA |
| GCIXF1012EC.A3-884560 | 功能描述:IC ETHERNET MAC 12PORT 672-BGA RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:2,450 系列:- 控制器類型:SPI 總線至 I²C 總線橋接 接口:I²C，串行，SPI 電源電壓:2.4 V ~ 3.6 V 電流 - 電源:11mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-HVQFN（4x4） 包裝:托盤 配用:568-3511-ND - DEMO BOARD SPI TO I2C 其它名稱:935286452157SC18IS600IBSSC18IS600IBS-ND |
| GCIXF1012ECA3 | 制造商:Cortina Systems Inc 功能描述: 制造商:Intel 功能描述: |
| GCIXF1024EC.A3-884561 | 功能描述:IC ETHERNET MAC 24PORT 672-BGA RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A |
發布緊急采購，3分鐘左右您將得到回復。