- 您現在的位置：買賣IC網 > PDF目錄1922 > FT232BL-REEL (FTDI, Future Technology Devices International Ltd)IC USB FS SERIAL UART 32-LQFP PDF資料下載
參數資料
| 型號： | FT232BL-REEL |
| 廠商： | FTDI, Future Technology Devices International Ltd |
| 文件頁數： | 14/34頁 |
| 文件大小： | 0K |
| 描述： | IC USB FS SERIAL UART 32-LQFP |
| 產品培訓模塊： | USB Introduction |
| 標準包裝： | 1 |
| 系列： | USBmadeEZ-UART |
| 通道數： | 1，UART |
| FIFO's： | 256 字節 |
| 規程： | RS232，RS422，RS485 |
| 電源電壓： | 4.35V ~ 5.25V |
| 帶自動流量控制功能： | 是 |
| 帶調制解調器控制功能： | 是 |
| 帶CMOS： | 是 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-LQFP |
| 供應商設備封裝： | 32-LQFP |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 634 (CN2011-ZH PDF) |
| 其它名稱： | 768-1009-6 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
Copyright 2011 Future Technology Devices International Limited
21
Document No.: FT_000329
FT232BL
/BQ USB UART IC Datasheet Version 2.2
Clearance No.: FTDI#
171
6.4 Bus Powered Circuit (<=100mA) with Power Control
Figure 6.5 Bus Powered with Power Switching Configuration
USB Bus powered circuits need to be able to power down in USB suspend mode in order to meet the <=
500uA total suspend current requirement (including external logic). This limit is 2.5mA for devices that
support remote wake-up. Some external logic can power itself down into a low current state by
monitoring the PWREN# pin. For external logic that cannot power itself down in that way, the FT232B
provides a simple but effective way of turning off power to external circuitry during USB suspend.
Figure 8.3 shows how to use a discrete P-Channel Logic Level MOSFET to control the power to external
logic circuits. A suitable device could be a Fairchild NDT456P, or International Rectifier IRLML6402, or
equivalent. It is recommended that a “soft start” circuit consisting of a 1K series resistor and a 0.1 uF
capacitor are used to limit the current surge when the MOSFET turns on. Without the soft start circuit
there is a danger that the transient power surge of the MOSFET turning on will reset the FT232B, or the
USB host / hub controller. The values used here allow attached circuitry to power up with a slew rate of
~12.5 V per millisecond, in other words the output voltage will transition from GND to 5V in
approximately 400 microseconds.
Alternatively, a dedicated power switch i.c. with inbuilt “soft-start” can be used instead of a MOSFET. A
suitable power switch I.C. for such an application would be a Micrel (www.micrel.com) MIC2025-2BM or
equivalent.
Please note the following points in connection with power controlled designs –
a) The logic to be controlled must have its own reset circuitry so that it will automatically reset itself
when power is re-applied on coming out of suspend.
b) Set the Pull-down on Suspend option in the FT232B’s EEPROM.
c) For USB high-power bus powered device (one that consumes greater than 100 mA, and up to 500
mA of current from the USB bus), the power consumption of the device should be set in the max
power field in the EEPROM. A high-power bus powered device must use this descriptor in the
EEPROM to inform the system of its power requirements.
d) For 3.3V power controlled circuits VCCIO must not be powered down with the external circuitry
(PWREN# gets its VCC supply from VCCIO). Either connect the power switch between the output
of the 3.3V regulator and the external 3.3V logic OR if appropriate power VCCIO from the
3V3OUT pin of the FT232B.
相關PDF資料 |
PDF描述 |
|---|---|
| FT232HL-REEL | IC HS USB TO UART/FIFO 48LQFP |
| FT232RL-REEL | IC USB FS SERIAL UART 28-SSOP |
| FT245BL-REEL | IC USB FS PARALLEL FIFO 32-LQFP |
| FT245RL-REEL | IC USB TO PARALLEL FIFO 28-SSOP |
| FT4232HQ-REEL | IC USB HS QUAD UART/SYNC 64-QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FT232BL-TRAY | 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB-to-UART 1-CH 128Byte FIFO 5V 32-Pin LQFP Tray |
| FT232BM | 功能描述:UART 接口集成電路 Obsolete FT232BL RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| FT232BQ | 制造商:FTDI 制造商全稱:FTDI 功能描述:USB UART ( USB - Serial) I.C. |
| FT232BQ-REEL | 功能描述:USB 接口集成電路 USB to Serial UART IC QFN-32 RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| FT232HL | 制造商:FTDI 制造商全稱:FTDI 功能描述:FT232H Single Channel Hi-Speed USB to Multipurpose UART/FIFO IC |
發布緊急采購，3分鐘左右您將得到回復。