- 您現在的位置：買賣IC網 > PDF目錄375799 > FIN24A (Fairchild Semiconductor Corporation) Low Voltage 24-Bit Bi-Directional Serializer/Deserializer with Multiple Frequency Ranges (Preliminary) PDF資料下載
參數資料
| 型號： | FIN24A |
| 廠商： | Fairchild Semiconductor Corporation |
| 英文描述： | Low Voltage 24-Bit Bi-Directional Serializer/Deserializer with Multiple Frequency Ranges (Preliminary) |
| 中文描述： | 低電壓24位雙向串行器/有多個頻率范圍串器（初步） |
| 文件頁數： | 4/20頁 |
| 文件大?。?/td> | 1758K |
| 代理商： | FIN24A |
Preliminary
www.fairchildsemi.com
4
F
TABLE 1. Control Logic Circuitry
Power-Down Mode: (Mode 0)
Mode 0 is used for powering down and resetting the
device. When both of the mode signals are driven to a
LOW state the PLL and references will be disabled, differ-
ential input buffers will be shut off, differential output buffers
will be placed into a HIGH impedance state, LVCMOS out-
puts will be placed into a HIGH impedance state and
LVCMOS inputs will be driven to a valid level internally.
Additionally all internal circuitry will be reset. The loss of
CKREF state is also enabled to insure that the PLL will only
power-up if there is a valid CKREF signal.
In a typical application mode signals of the device will typi-
cally not change states other than between the desired fre-
quency range and the power-down mode. This allows for
system level power-down functionality to be implemented
via a single wire for a SerDes pair. The S1 and S2 selection
signals that have their operating mode driven to a
“
logic 0
”
should be hardwired to GND. The S1 and S2 signals that
have their operating mode driven to a
“
logic 1
”
should be
connected to a system level power-down signal.
Serializer Operation Mode
The serializer configurations are described in the following
sections. The basic serialization circuitry works essentially
identical in these modes but the actual data and clock
streams will differ dependent on if CKREF is the same as
the STROBE signal or not. When it is stated that
CKREF
STROBE this means that the CKREF and
STROBE signals have an identical frequency of operation
but may or may not be phase aligned. When it is stated that
CKREF does not equal STROBE then each signal is dis-
tinct and CKREF must be running at a frequency high
enough to avoid any loss of data condition. CKREF must
never be a lower frequency than STROBE.
Serializer Operation: (Figure 1)
Modes 1, 2, or 3
DIRI equals 1
CKREF equals STROBE
The PLL must receive a stable CKREF signal in order to
achieve lock prior to any valid data being sent. The CKREF
signal can be used as the data STROBE signal provided
that data can be ignored during the PLL lock phase.
Once the PLL is stable and locked the device can begin to
capture and serialize data. Data will be captured on the ris-
ing edge of the STROBE signal and then serialized. The
serialized data stream is synchronized and sent source
synchronously with a bit clock with an embedded word
boundary. When operating in this mode the internal deseri-
alizer circuitry is disabled including the serial clock, serial
data input buffers, the bi-directional parallel outputs and the
CKP word clock. The CKP word clock will be driven HIGH.
Serializer Operation: (Figure 2)
DIRI equals 1
CKREF does not equal STROBE
If the same signal is not used for CKREF and STROBE,
then the CKREF signal must be run at a higher frequency
than the STROBE rate in order to serialize the data cor-
rectly. The actual serial transfer rate will remain at 26 times
the CKREF frequency. A data bit value of zero will be sent
when no valid data is present in the serial bit stream. The
operation of the serializer will otherwise remain the same.
The exact frequency that the reference clock needs to run
at will be dependent upon the stability of the CKREF and
STROBE signal. If the source of the CKREF signal imple-
ments spread spectrum technology then the maximum fre-
quency of this spread spectrum clock should be used in
calculating the ratio of STROBE frequency to the CKREF
frequency. Similarly if the STROBE signal has significant
cycle-to-cycle variation then the maximum cycle-to-cycle
time needs to be factored into the selection of the CKREF
frequency.
Serializer Operation: (Figure 3)
DIRI equals 1
No CKREF
A third method of serialization can be done by providing a
free running bit clock on the CKSI signal. This mode is
enabled by grounding the CKREF signal and driving the
DIRI signal HIGH.
At power-up the device is configured to accept a serializa-
tion clock from CKSI. If a CKREF is received then this
device will enable the CKREF serialization mode. The
device will remain in this mode even if CKREF is stopped.
To re-enable this mode the device must be powered down
and then powered back up with a
“
logic 0
”
on CKREF.
Mode
0
0
1
0
Description
0
1
x
1
Power-Down Mode
24-Bit Serializer
2MHz to 5MHz CKREF
24-Bit Deserializer
24-Bit Serializer
5MHz to 15MHz CKREF
24-Bit Deserializer
24-Bit Serializer
10MHz to 30MHz CKREF
24-Bit Deserializer
0
1
1
0
0
1
2
1
1
0
1
0
1
3
1
1
0
相關PDF資料 |
PDF描述 |
|---|---|
| FIN24AGFX | Low Voltage 24-Bit Bi-Directional Serializer/Deserializer with Multiple Frequency Ranges (Preliminary) |
| FIN24AMLX | Low Voltage 24-Bit Bi-Directional Serializer/Deserializer with Multiple Frequency Ranges (Preliminary) |
| FIN24C | uSerDes Low Voltage 24-Bit Bi-Directional Serializer/Deserializer |
| FIN24CGFX | uSerDes Low Voltage 24-Bit Bi-Directional Serializer/Deserializer |
| FIN24CMLX | uSerDes Low Voltage 24-Bit Bi-Directional Serializer/Deserializer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FIN24AC | 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:USerDesTM 22-Bit Bi-Directional Serializer/Deserializer |
| FIN24AC_07 | 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:22-Bit Bi-Directional Serializer/Deserializer |
| FIN24ACGFX | 功能描述:LVDS 接口集成電路 FINISHED GOOD MSL 2 RoHS:否 制造商:Texas Instruments 激勵器數量:4 接收機數量:4 數據速率:155.5 Mbps 工作電源電壓:5 V 最大功率耗散:1025 mW 最大工作溫度:+ 85 C 封裝 / 箱體:SOIC-16 Narrow 封裝:Reel |
| FIN24ACMLX | 功能描述:LVDS 接口集成電路 SerDes22-Bit Bi-Dirc Serilizr/Deserilizr RoHS:否 制造商:Texas Instruments 激勵器數量:4 接收機數量:4 數據速率:155.5 Mbps 工作電源電壓:5 V 最大功率耗散:1025 mW 最大工作溫度:+ 85 C 封裝 / 箱體:SOIC-16 Narrow 封裝:Reel |
| FIN24AGFX | 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:Low Voltage 24-Bit Bi-Directional Serializer/Deserializer with Multiple Frequency Ranges (Preliminary) |
發布緊急采購，3分鐘左右您將得到回復。