- 您現在的位置：買賣IC網 > PDF目錄16566 > EVAL-CN0217-EB1Z (Analog Devices Inc)EVAL BOARD FOR CN0217 PDF資料下載
參數資料
| 型號： | EVAL-CN0217-EB1Z |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 24/40頁 |
| 文件大?。?/td> | 0K |
| 描述： | EVAL BOARD FOR CN0217 |
| 設計資源： | CN-0217 Circuit Eval Board |
| 標準包裝： | 1 |
| 系列： | Circuits from the Lab™ |
| 主要目的： | 阻抗轉換器 |
| 已用 IC / 零件： | AD5933，AD5934，AD8606 |
| 主要屬性： | 網絡分析器 |
| 次要屬性： | I²C 接口 |
| 已供物品： | 板 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
AD5933
Data Sheet
Rev. E | Page 30 of 40
TYPICAL APPLICATIONS
MEASURING SMALL IMPEDANCES
The AD5933 is capable of measuring impedance values up to
10 MΩ if the system gain settings are chosen correctly for the
impedance subrange of interest.
If the user places a small impedance value (≤500 Ω over the
sweep frequency of interest) between the VOUT and VIN pins,
it results in an increase in signal current flowing through the
impedance for a fixed excitation voltage in accordance with
Ohm’s law. The output stage of the transmit side amplifier
available at the VOUT pin may not be able to provide the
required increase in current through the impedance. To have a
unity gain condition about the receive side I-V amplifier, the
user needs to have a similar small value of feedback resistance
for system calibration as outlined in the Gain Factor Setup
Configuration section. The voltage presented at the VIN pin is
hard biased at VDD/2 due to the virtual earth on the receive
side I-V amplifier. The increased current sink/source
requirement placed on the output of the receive side I-V
amplifier may also cause the amplifier to operate outside of
the linear region. This causes significant errors in subsequent
impedance measurements.
at the VOUT pin must be taken into account when measuring
small impedances (ZUNKNOWN), specifically when the value of
the output series resistance is comparable to the value of the
impedance under test (ZUNKNOWN). If the ROUT value is unac-
counted for in the system calibration (that is, the gain factor
calculation) when measuring small impedances, there is an
introduced error into any subsequent impedance measurement
that takes place. The introduced error depends on the relative
magnitude of the impedance being tested compared to the value
of the output series resistance.
05324-
048
PGA
I-V
VDD/2
RFB
VIN
AD8531
AD820
AD8641
AD8627
VDD
20k
1F
VDD/2
VOUT
ROUT
RFB
DDS
2V p-p
R1
R2
ZUNKNOWN
TRANSMIT SIDE
OUTPUT AMPLIFIER
Figure 35. Additional External Amplifier Circuit for Measuring Small
Impedances
The value of the output series resistance depends upon the
selected output excitation range at VOUT and has a tolerance
from device to device like all discrete resistors manufactured in
a silicon fabrication process. Typical values of the output series
resistance are outlined in Table 17.
Table 17. Output Series Resistance (ROUT) vs. Excitation Range
Parameter
Value (Typ)
Output Series Resistance Value
Range 1
2 V p-p
200 typ
Range 2
1 V p-p
2.4 k typ
Range 3
0.4 V p-p
1.0 k typ
Range 4
0.2 V p-p
600 typ
Therefore, to accurately calibrate the AD5933 to measure small
impedances, it is necessary to reduce the signal current by
attenuating the excitation voltage sufficiently and also account
for the ROUT value and factor it into the gain factor calculation
(see the Gain Factor Calculation section).
Measuring the ROUT value during device characterization is
achieved by selecting the appropriate output excitation range at
VOUT and sinking and sourcing a known current at the pin
(for example, ±2 mA) and measuring the change in dc voltage.
The output series resistance can be calculated by measuring the
inverse of the slope (that is, 1/slope) of the resultant I-V plot.
A circuit that helps to minimize the effects of the issues
previously outlined is shown in Figure 35. The aim of this
circuit is to place the AD5933 system gain within its linear
range when measuring small impedances by using an additional
external amplifier circuit along the signal path. The external
amplifier attenuates the peak-to-peak excitation voltage at
VOUT by a suitable choice of resistors (R1 and R2), thereby
reducing the signal current flowing through the impedance and
minimizing the effect of the output series resistance in the
impedance calculations.
output series resistance of the external amplifier which is
typically much less than 1 Ω with feedback applied depending
AD8531) as well as the load current, bandwidth, and gain.
相關PDF資料 |
PDF描述 |
|---|---|
| V375C48T75BF3 | CONVERTER MOD DC/DC 48V 75W |
| HBC12DRTF-S13 | CONN EDGECARD 24POS .100 EXTEND |
| HCC13DREN-S13 | CONN EDGECARD 26POS .100 EXTEND |
| V375C48E150BG2 | CONVERTER MOD DC/DC 48V 150W |
| V375C48E150BF | CONVERTER MOD DC/DC 48V 150W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EVAL-CN0218-SDPZ | 功能描述:BOARD CFTL AD8212 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:Circuits from the Lab™ 標準包裝:1 系列:- 主要目的:電信，線路接口單元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要屬性:T1/J1/E1 LIU 次要屬性:- 已供物品:板，電源，線纜，CD 其它名稱:82EBV2081 |
| EVAL-CN0221-EB1Z | 功能描述:EVAL MONITOR W/ADUCM360 UCTRL RoHS:否 類別:編程器，開發系統 >> 通用嵌入式開發板和套件（MCU、DSP、FPGA、CPLD等） 系列:* 標準包裝:1 系列:PICDEM™ 類型:MCU 適用于相關產品:PIC10F206，PIC16F690，PIC16F819 所含物品:板，線纜，元件，CD，PICkit 編程器 產品目錄頁面:659 (CN2011-ZH PDF) |
| EVAL-CN0225-SDPZ | 功能描述:其他開發工具 EVAL-CN0225-SDPZ RoHS:否 制造商:Parallax 產品:ELEV-8 Hex Upgrade Kits 類型:Robotics 工具用于評估:ELEV-8 Quadcopter 工作電源電壓: |
| EVAL-CN0227-HSCZ | 制造商:Analog Devices 功能描述:HIGH PERFORMANCE WIDEBAND RECEIVER - Boxed Product (Development Kits) 制造商:Analog Devices 功能描述:BOARD EVAL WIDEBAND RECEIVER 制造商:Analog Devices 功能描述:EVAL BOARD CFTL WIDEBAND REC 制造商:Analog Devices 功能描述:EVAL BOARD, CFTL, WIDEBAND RECEIVER 制造商:Analog Devices 功能描述:EVAL BOARD, 16BIT 250MSPS WIDEBAND RECEIVER; Silicon Manufacturer:Analog Devices; Silicon Core Number:ADL5562, AD9467; Kit Application Type:Communication; Application Sub Type:IF Receiver |
| EVAL-CN0229-SDPZ | 功能描述:EVAL-CN0229-SDPZ RoHS:否 類別:編程器，開發系統 >> 評估演示板和套件 系列:* 標準包裝:1 系列:- 主要目的:電信，線路接口單元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要屬性:T1/J1/E1 LIU 次要屬性:- 已供物品:板，電源，線纜，CD 其它名稱:82EBV2081 |
發布緊急采購，3分鐘左右您將得到回復。