- 您現在的位置：買賣IC網 > PDF目錄384297 > EN29LV040A (Electronic Theatre Controls, Inc.) 4 Megabit (512K x 8-bit ) Uniform Sector, CMOS 3.0 Volt-only Flash Memory PDF資料下載
參數資料
| 型號： | EN29LV040A |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | 4 Megabit (512K x 8-bit ) Uniform Sector, CMOS 3.0 Volt-only Flash Memory |
| 中文描述： | 4兆位（為512k × 8位）統一部門，3.0伏的CMOS只閃存 |
| 文件頁數： | 7/35頁 |
| 文件大?。?/td> | 257K |
| 代理商： | EN29LV040A |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁
This Data Sheet may be revised by subsequent versions 2003 Eon Silicon Solution, Inc., www.essi.com.tw
or modifications due to changes in technical specifications.
Rev. A, Issue Date: 2005/08/16
EN29LV040A
whichever happens later. All data is latched on the rising edge of WE# or CE#, whichever happens
first. The system is not required to provide further controls or timings. The device automatically
provides internally generated program / erase pulses and verifies the programmed /erased cells’
margin. The host system can detect completion of a program or erase operation by reading the
DQ[7] (Data# Polling) and DQ[6] (Toggle) status bits.
The ‘Command Definitions’ section of this document provides details on the specific device
commands implemented in the EN29LV040A.
Sector Protection/Unprotection
The hardware sector protection feature disables both program and erase operations in any sector. The
hardware sector unprotection feature re-enables both program and erase operations in previously
protected sectors.
Sector protection/unprotection is intended only for programming equipment. This method requires
V
ID
be applied to both OE# and A9 pin and non-standard microprocessor timings are used. This
method is described in a separate document called EN29LV040A Supplement,
which can be
obtained by contacting a representative of Eon Silicon Solution, Inc.
Automatic Sleep Mode
The automatic sleep mode minimizes Flash device energy consumption. The device automatically
enables this mode when addresses remain stable for t
acc
+ 30ns. The automatic sleep mode is
independent of the CE#, WE# and OE# control signals. Standard address access timings provide
new data when addresses are changed. While in sleep mode, output is latched and always
available to the system. ICC
4
in the DC Characteristics table represents the automatic sleep more
current specification.
相關PDF資料 |
PDF描述 |
|---|---|
| EP300 | EP300 PowerPC Bus Arbiter |
| EPA025A-70 | High Efficiency Heterojunction Power FET |
| EPA040A-70 | High Efficiency Heterojunction Power FET |
| EPA080A-70 | High Efficiency Heterojunction Power FET |
| EPA090A | High Efficiency Heterojunction Power FET |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EN29LV160AB-70TCP | 制造商:EON-CFEON 功能描述: |
| EN29LV160AT-70TCP | 制造商:EON SILICON SOLUTION INC 功能描述:EN29LV160A Series, 16 Mbit 70 NS 48 TSOP Top Boot Sector 3 V NOR Flash |
| EN29LV160BB-70BIP | 制造商:EON SILICON SOLUTION INC 功能描述:EN29LV160 Series 16 Mbit (2 M x 8) 3.6 V 70 ns Boot Sector NOR Flash 制造商:Eon Silicon Solution Inc 功能描述:EN29LV160 Series 16 Mbit (2 M x 8) 3.6 V 70 ns Boot Sector NOR Flash |
| EN29LV160BT-70TIP | 制造商:EON SILICON SOLUTION INC 功能描述:EN29LV160 Series 16 Mbit (2 M x 8) 3.6 V 70 ns Boot Sector NOR Flash |
| EN29LV160CB-70TIP | 制造商:EON SILICON SOLUTION INC 功能描述:FLASH, 3V Read Program Erase 16 Megabit (2M x 8 / 1M x 16) 70ns TSOP |
發布緊急采購，3分鐘左右您將得到回復。