參數資料
| 型號： | EFM32TG222F32 |
| 廠商： | Energy Micro |
| 文件頁數： | 20/136頁 |
| 文件大小： | 0K |
| 描述： | IC MCU 32BIT 32KB FLASH 48LQFP |
| 特色產品： | EFM32 Tiny Gecko |
| 標準包裝： | 1 |
| 系列： | Tiny Gecko |
| 核心處理器： | ARM? Cortex?-M3 |
| 芯體尺寸： | 32-位 |
| 速度： | 32MHz |
| 連通性： | I²C，IrDA，智能卡，SPI，UART/USART |
| 外圍設備： | 欠壓檢測/復位，DMA，I²S，POR，PWM，WDT |
| 輸入/輸出數： | 37 |
| 程序存儲器容量： | 32KB（32K x 8） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 4K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 1.8 V ~ 3.8 V |
| 數據轉換器： | A/D 4x12b，D/A 1x12b |
| 振蕩器型： | 外部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 48-TQFP |
| 包裝： | 標準包裝 |
| 其它名稱： | 914-1029-6 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁
...the world's most energy friendly microcontrollers
2011-02-04 - d0002_Rev1.00
116
www.energymicro.com
Bits
Name
Function
0 = MPU is disabled during hard fault, NMI, and FAULTMASK handlers, regardless of the value
of the ENABLE bit
1 = the MPU is enabled during hard fault, NMI, and FAULTMASK handlers.
When the MPU is disabled, if this bit is set to 1 the behavior is Unpredictable.
[0]
ENABLE
Enables the MPU:
0 = MPU disabled
1 = MPU enabled.
When ENABLE and PRIVDEFENA are both set to 1:
For privileged accesses, the default memory map is as described in Section 2.2 (p. 14) . Any access
by privileged software that does not address an enabled memory region behaves as defined by the
default memory map.
Any access by unprivileged software that does not address an enabled memory region causes a
memory management fault.
XN and Strongly-ordered rules always apply to the System Control Space regardless of the value of
the ENABLE bit.
When the ENABLE bit is set to 1, at least one region of the memory map must be enabled for the system
to function unless the PRIVDEFENA bit is set to 1. If the PRIVDEFENA bit is set to 1 and no regions
are enabled, then only privileged software can operate.
When the ENABLE bit is set to 0, the system uses the default memory map. This has the same memory
attributes as if the MPU is not implemented, see Table 2.11 (p. 16) . The default memory map applies
to accesses from both privileged and unprivileged software.
When the MPU is enabled, accesses to the System Control Space and vector table are always permitted.
Other areas are accessible based on regions and whether PRIVDEFENA is set to 1.
Unless HFNMIENA is set to 1, the MPU is not enabled when the processor is executing the handler for
an exception with priority –1 or –2. These priorities are only possible when handling a hard fault or NMI
exception, or when FAULTMASK is enabled. Setting the HFNMIENA bit to 1 enables the MPU when
operating with these two priorities.
4.5.3 MPU Region Number Register
The RNR selects which memory region is referenced by the RBAR and RASR registers. See the register
summary in Table 4.38 (p. 114) for its attributes. The bit assignments are:
Reserved
31
8 7
0
REGION
Table 4.41. RNR bit assignments
Bits
Name
Function
[31:8]
-
Reserved.
[7:0]
REGION
Indicates the MPU region referenced by the RBAR and RASR registers.
The MPU supports 8 memory regions, so the permitted values of this field are 0-7.
Normally, you write the required region number to this register before accessing the RBAR or RASR.
However you can change the region number by writing to the RBAR with the VALID bit set to 1, see
Section 4.5.4 (p. 117) . This write updates the value of the REGION field.
相關PDF資料 |
PDF描述 |
|---|---|
| DB9-USB-D5-M | MOD USB UART EMBDED 5V MALE |
| DB9-USB-D3-M | MOD USB UART EMBDED 3.3V MALE |
| 3E106-2230KV | CONN PLUG IEEE 1394 R/A UPRIGHT |
| DB9-USB-D5-F | MOD USB UART EMBDED 5V FEMAL |
| XM4M-2432-5012 | CONN DVI 24POS 1.5A 40V DIGITAL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EFM32TG222F32-QFP48 | 制造商:Energy Micro AS 功能描述:TINY GECKO MCU - Tape and Reel 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 32KB FLASH 48TQFP |
| EFM32TG222F32-QFP48T | 制造商:Energy Micro AS 功能描述:TINY GECKO MCU - Trays |
| EFM32TG222F32-QFP48-T | 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 32KB FLASH 48TQFP |
| EFM32-TG222F32-SK | 功能描述:IC MICRO KIT GECKO 48LQFP RoHS:是 類別:套件 >> 半導體產品 - IC 元件分類 系列:Tiny Gecko 其它有關文件:NXPLOGIC2-KIT-ND Contents 標準包裝:1 系列:74AUP 套件類型:邏輯 值:180 件 - 18 種值各 10 件 包裝:- 安裝類型:表面貼裝 包括封裝:6-XSON，8-XSON，8-XQFN 產品目錄頁面:2653 (CN2011-ZH PDF) 工具箱內容:(10) 568-4391-1-ND - IC GATE MULT-FUNC CONFIG 6-XSON(10) 568-4390-1-ND - IC CONFIG MULT-FUNC GATE 6-XSON(10) 568-4389-1-ND - IC GATE DUAL FUNCTION 8-XSON(10) 568-4388-1-ND - IC GATE DUAL FUNCTION 8-XQFN(10) 568-4387-1-ND - IC F-F D-TYPE POS EDGE 8-XSON(10) 568-4386-1-ND - IC F-F D-TYPE POS EDGE 8-XQFN(10) 568-4385-1-ND - IC CONFIG MULTI-FUNC GATE 6-XSON(10) 568-4384-1-ND - IC EX-OR GATE 3-IN 6-XSON(10) 568-4383-1-ND - IC F-F D-TYPE POS EDGE 6-XSON(10) 568-4382-1-ND - IC LATCH D-TYPE 6-XSON更多... 其它名稱:NXPLOGIC2-KIT |
| EFM32TG222F32-T | 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 32KB FLASH 48TQFP |
發布緊急采購，3分鐘左右您將得到回復。