- 您現在的位置：買賣IC網 > PDF目錄384280 > EDE5116AJBG-6E-E (ELPIDA MEMORY INC) 512M bits DDR2 SDRAM PDF資料下載
參數資料
| 型號： | EDE5116AJBG-6E-E |
| 廠商： | ELPIDA MEMORY INC |
| 元件分類： | DRAM |
| 英文描述： | 512M bits DDR2 SDRAM |
| 中文描述： | 32M X 16 DDR DRAM, 0.45 ns, PBGA84 |
| 封裝： | ROHS COMPLIANT, FBGA-84 |
| 文件頁數： | 41/77頁 |
| 文件大?。?/td> | 589K |
| 代理商： | EDE5116AJBG-6E-E |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁當前第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁
EDE5108AJBG, EDE5116AJBG
Preliminary Data Sheet E1044E20 (Ver. 2.0)
41
Extended Mode Register Set for OCD Impedance Adjustment
OCD impedance adjustment can be done using the following EMRS mode. In drive mode all outputs are driven out
by DDR2 SDRAM and drive of RDQS is dependent on EMRS bit enabling RDQS operation. In Drive (1) mode, all
DQ, DQS (and RDQS) signals are driven high and all /DQS signals are driven low. In drive (0) mode, all DQ, DQS
(and RDQS) signals are driven low and all /DQS signals are driven high.
In adjust mode, BL = 4 of operation code data must be used. In case of OCD calibration default, output driver
characteristics follow approximate nominal V/I curve for 18
Ω
output drivers, but are not guaranteed. If tighter control
is required, which is controlled within 18
Ω
±
3
Ω
driver impedance range, OCD must be used.
OCD applies only to normal full strength output drive setting defined by EMRS (1) and if reduced strength is set,
OCD default output driver characteristics are not applicable. When OCD calibration adjust mode is used, OCD
default output driver characteristics are not applicable.
[OCD Mode Set Program]
A9
A8
A7
Operation
0
0
0
OCD calibration mode exit
0
0
1
Drive (1) DQ, DQS, (RDQS) high and /DQS low
0
1
0
Drive (0) DQ, DQS, (RDQS) low and /DQS high
1
0
Adjust mode
1
1
1
OCD calibration default
OCD Impedance Adjustment
To adjust output driver impedance, controllers must issue the ADJUST EMRS command along with a 4bit burst code
to DDR2 SDRAM as in OCD Adjustment Program table. For this operation, burst length has to be set to BL = 4 via
MRS command before activating OCD and controllers must drive this burst code to all DQs at the same time. DT0 in
OCD Adjustment Program table means all DQ bits at bit time 0, DT1 at bit time 1, and so forth. The driver output
impedance is adjusted for all DDR2 SDRAM DQs simultaneously and after OCD calibration, all DQs and DQS's of a
given DDR2 SDRAM will be adjusted to the same driver strength setting. The maximum step count for adjustment is
16 and when the limit is reached, further increment or decrement code has no effect. The default setting may be any
step within the 16-step range. When Adjust mode command is issued, AL from previously set value must be
applied.
[OCD Adjustment Program]
4bits burst data inputs to all DQs
Operation
DT0
DT1
DT2
DT3
Pull-up driver strength
Pull-down driver strength
0
0
0
0
NOP
NOP
0
0
0
1
Increase by 1 step
NOP
0
0
1
0
Decrease by 1 step
NOP
0
1
0
0
NOP
Increase by 1 step
1
0
0
0
NOP
Decrease by 1 step
0
1
0
1
Increase by 1 step
Increase by 1 step
0
1
1
0
Decrease by 1 step
Increase by 1 step
1
0
0
1
Increase by 1 step
Decrease by 1 step
1
0
1
0
Decrease by 1 step
Decrease by 1 step
Other combinations
Reserved
相關PDF資料 |
PDF描述 |
|---|---|
| EDE5116AJBG-8E-E | 512M bits DDR2 SDRAM |
| EDE702 | Serial LCD Interface IC |
| EDI8808CB | HIGH SPEED, LOW POWER 64K MONOLITHIC SRAM |
| EDI8F32256C | HIGH SPEED EIGHT MEGABIT SRAM MODULE |
| EDI8L32512C | 512K X 32 CMOS HIGH SPEED STATIC RAM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EDE5116AJBG-6ELI-E | 制造商:ELPIDA 制造商全稱:Elpida Memory 功能描述:512M bits DDR2 SDRAM WTR (Wide Temperature Range) |
| EDE5116AJBG-8E-E | 制造商:ELPIDA 制造商全稱:Elpida Memory 功能描述:512M bits DDR2 SDRAM |
| EDE5116AJBG-LI | 制造商:ELPIDA 制造商全稱:Elpida Memory 功能描述:512M bits DDR2 SDRAM WTR (Wide Temperature Range) |
| EDE5116AJSE | 制造商:ELPIDA 制造商全稱:Elpida Memory 功能描述:512M bits DDR2 SDRAM |
| EDE5116AJSE-6E-E | 制造商:ELPIDA 制造商全稱:Elpida Memory 功能描述:512M bits DDR2 SDRAM |
發布緊急采購，3分鐘左右您將得到回復。