- 您現在的位置：買賣IC網 > PDF目錄22057 > DSP56301AG80 (Freescale Semiconductor)IC DSP 24BIT 80MHZ GP 208-LQFP PDF資料下載
參數資料
| 型號： | DSP56301AG80 |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 31/124頁 |
| 文件大小： | 0K |
| 描述： | IC DSP 24BIT 80MHZ GP 208-LQFP |
| 產品變化通告： | DSP56301 Discontinuation 12/Nov/2009 |
| 標準包裝： | 36 |
| 系列： | DSP563xx |
| 類型： | 定點 |
| 接口： | 主機接口，SSI，SCI |
| 時鐘速率： | 80MHz |
| 非易失內存： | ROM（9 kB） |
| 芯片上RAM： | 24kB |
| 電壓 - 輸入/輸出： | 3.30V |
| 電壓 - 核心： | 3.30V |
| 工作溫度： | -40°C ~ 100°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 208-LQFP |
| 供應商設備封裝： | 208-LQFP |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁當前第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁
DSP56301 Technical Data, Rev. 10
1-10
Freescale Semiconductor
Signals/Connections
1.7 Host Interface (HI32)
The Host Interface (HI32) provides fast parallel data to a 32-bit port directly connected to the host bus. The HI32
supports a variety of standard buses and directly connects to a PCI bus and a number of industry-standard
microcomputers, microprocessors, DSPs, and DMA hardware.
1.7.1
Host Port Usage Considerations
Careful synchronization is required when the system reads multiple-bit registers that are written by another
asynchronous system. This is a common problem when two asynchronous systems are connected (as they are in the
Host port). The considerations for proper operation are discussed in Table 1-10.
MODD
IRQD
Input
Mode Select D
Selects the initial chip operating mode during hardware reset and becomes a
level-sensitive or negative-edge-triggered, maskable interrupt request input
IRQD during normal instruction processing. MODA, MODB, MODC, and
MODD select one of sixteen initial chip operating modes, latched into the OMR
when the RESET signal is deasserted.
External Interrupt Request D
Internally synchronized to CLKOUT. If IRQD is asserted synchronous to
CLKOUT, multiple processors can be re-synchronized using the WAIT
instruction and asserting IRQD to exit the Wait state. If the processor is in the
Stop stand-by state and IRQD is asserted, the processor exits the Stop state.
These inputs are 5 V tolerant.
RESET
Input
Reset
Deassertion of RESET is internally synchronized to the clock out (CLKOUT).
When asserted, the chip is placed in the Reset state and the internal phase
generator is reset. The Schmitt-trigger input allows a slowly rising input (such
as a capacitor charging) to reset the chip reliably. If RESET is deasserted
synchronous to CLKOUT, exact start-up timing is guaranteed, allowing
multiple processors to start synchronously and operate together in “l(fā)ock-step.”
When the RESET signal is deasserted, the initial chip operating mode is
latched from the MODA, MODB, MODC, and MODD inputs. The RESET
signal must be asserted after power-up.
This input is 5 V tolerant.
Table 1-10.
Host Port Usage Considerations
Action
Description
Asynchronous read of
receive byte registers
When reading the receive byte registers, Receive register High (RXH), Receive register Middle (RXM), or
Receive register Low (RXL), use interrupts or poll the Receive register Data Full (RXDF) flag that indicates
data is available. This assures that the data in the receive byte registers is valid.
Asynchronous write to
transmit byte registers
Do not write to the transmit byte registers, Transmit register High (TXH), Transmit register Middle (TXM), or
Transmit register Low (TXL), unless the Transmit register Data Empty (TXDE) bit is set, indicating that the
transmit byte registers are empty. This guarantees that the transmit byte registers transfer valid data to the
Host Receive (HRX) register.
Table 1-9.
Interrupt and Mode Control (Continued)
Signal Name
Type
State During
Reset
Signal Description
相關PDF資料 |
PDF描述 |
|---|---|
| ECC13DCMT-S288 | CONN EDGECARD 26POS .100 EXTEND |
| VE-21X-EU | CONVERTER MOD DC/DC 5.2V 200W |
| DSP56301AG100 | IC DSP 24BIT 100MHZ GP 208-LQFP |
| MMBD4148 | DIODE 100V 200MA SOT23 |
| VE-21B-EU | CONVERTER MOD DC/DC 95V 200W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DSP56301AG80B1 | 功能描述:數字信號處理器和控制器 - DSP, DSC 24 BIT DSP RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| DSP56301CE2K30A | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:DSP56301 Digital Signal Processor |
| DSP56301PW100 | 功能描述:數字信號處理器和控制器 - DSP, DSC 100Mhz/100MMACS RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| DSP56301PW80 | 功能描述:數字信號處理器和控制器 - DSP, DSC 80Mhz/80MMACS RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| DSP56301UMAD | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DSP56301 Users Manual Addendum |
發布緊急采購，3分鐘左右您將得到回復。