- 您現在的位置：買賣IC網 > PDF目錄97868 > DS2423X (DALLAS SEMICONDUCTOR) SPECIALTY MEMORY CIRCUIT, UUC PDF資料下載
參數資料
| 型號： | DS2423X |
| 廠商： | DALLAS SEMICONDUCTOR |
| 元件分類： | Memory IC:Other |
| 英文描述： | SPECIALTY MEMORY CIRCUIT, UUC |
| 封裝： | CHIP SCALE PKG |
| 文件頁數： | 22/25頁 |
| 文件大小： | 579K |
| 代理商： | DS2423X |
DS2422/DS2423
6 of 25
Read Scratchpad Command [AAH]
This command is used to verify scratchpad data and target address. After issuing the Read Scratchpad
command, the master begins reading. The first 2 bytes will be the target address. The next byte will be the
ending offset/data status byte (E/S) followed by the scratchpad data beginning at the byte offset (T4: T0).
The master may read data until the end of the scratchpad after which the data read will be all logic 1s.
Copy Scratchpad [5AH]
This command is used to copy data from the scratchpad to memory. After issuing the Copy Scratchpad
command, the master must provide a 3-byte authorization pattern which can be obtained by reading the
scratchpad for verification. This pattern must exactly match the data contained in the three address
registers (TA1, TA2, E/S, in that order). If the pattern matches, the AA (Authorization Accepted) flag
will be set and the copy will begin. A pattern of alternating 1s and 0s will be transmitted after the data has
been copied until a reset pulse is issued by the master. Any attempt to reset the part will be ignored while
the copy is in progress. Copy typically takes 30 s. The data to be copied is determined by the three
address registers. The scratchpad data from the beginning offset through the ending offset will be copied
to memory, starting at the target address. Anywhere from 1 to 32 bytes may be copied to memory with
this command. The AA flag will be cleared only by executing a Write Scratchpad command.
相關PDF資料 |
PDF描述 |
|---|---|
| DS2423 | 4K X 1 STANDARD SRAM, PDSO6 |
| DS2422 | 1K X 1 STANDARD SRAM, PDSO6 |
| DS2430AP | 256 X 1 1-WIRE SERIAL EEPROM, PDSO6 |
| DS2430A | 32 X 8 1-WIRE SERIAL EEPROM, PBCY3 |
| DS2430AX | 32 X 8 1-WIRE SERIAL EEPROM, UUC2 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS243 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| DS2430 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:256-Bit 1-Wire EEPROM |
| DS2430A | 功能描述:電可擦除可編程只讀存儲器 RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| DS2430A R | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:256-Bit 1-Wire EEPROM |
| DS2430A T | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:256-Bit 1-Wire EEPROM |
發布緊急采購，3分鐘左右您將得到回復。