- 您現在的位置：買賣IC網 > PDF目錄9314 > DS2415X (Maxim Integrated Products)IC TIME CHIP 1-WIRE CSP PDF資料下載
參數資料
| 型號： | DS2415X |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 12/14頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TIME CHIP 1-WIRE CSP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 10,000 |
| 類型： | 二進制計數器 |
| 特點： | 唯一 ID |
| 時間格式： | 二進制 |
| 數據格式： | 二進制 |
| 接口： | 1 線 串行 |
| 電源電壓： | 2.5 V ~ 5.5 V |
| 電壓 - 電源，電池： | 2.5 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 6-XBGA，F(xiàn)CBGA |
| 供應商設備封裝： | 6-覆晶（2.82x2.54） |
| 包裝： | 帶卷 (TR) |
DS2415
7 of 14
HARDWARE CONFIGURATION Figure 6
1-WIRE BUS SYSTEM
The 1-Wire bus is a system that has a single bus master and one or more slaves. In all instances the
DS2415 behaves as a slave. The discussion of this bus system is broken down into three topics: hardware
configuration, transaction sequence, and 1-Wire signaling (signal types and timing). A 1-Wire protocol
defines bus transactions in terms of the bus state during specified time slots that are initiated on the falling
edge of sync pulses from the bus master. For a more detailed protocol description, refer to Chapter 4 of
the Book of DS19xx iButton Standards.
Hardware Configuration
The 1-Wire bus has only a single line by definition; it is important that each device on the bus be able to
drive it at the appropriate time. To facilitate this, each device attached to the 1-Wire bus must have open
drain or 3-state outputs. The 1-Wire input of the DS2415 is open drain with an internal circuit equivalent
to that shown in Figure 6. A multidrop bus consists of a 1-Wire bus with multiple slaves attached. The 1-
Wire bus has a maximum data rate of 16.3kbits per second and requires a pullup resistor of approximately
5k
W.
The idle state for the 1-Wire bus is high. If for any reason a transaction needs to be suspended, the bus
must be left in the idle state if the transaction is to resume. If this does not occur and the bus is left low
for more than 120
ms, one or more of the devices on the bus may be reset. Since the DS2415 gets all its
energy for operation through its VBAT pin it will not perform a power-on reset if the 1-Wire bus is low for
an extended time period.
Transaction Sequence
The protocol for accessing the DS2415 via the 1-Wire port is as follows:
§ Initialization
§ ROM Function Command
§ Clock Function Command
相關PDF資料 |
PDF描述 |
|---|---|
| DS2417P/T&R | IC TIMECHIP W/INTRPT 1WIRE 6TSOC |
| VI-BN2-IU-F2 | CONVERTER MOD DC/DC 15V 200W |
| AD5247BKSZ5-RL7 | IC POT DGTL 5K 128POS SC70-6 |
| DS1501WSN | IC RTC WDOG Y2KC 3.3V IND 28SOIC |
| DS1500YE | IC RTC Y2KC W/NV CTRL 5V 32TSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS2416FP00K | 制造商:Thomas & Betts 功能描述:200A,CON,3P4W,MG,416,3P208V,CC |
| DS2416FR000 | 制造商:Thomas & Betts 功能描述:200A,REC,3P4W,MG,416,3P208V,SC |
| DS2416FRAB0 | 制造商:Thomas & Betts 功能描述:200A,REC.,3P4W,3PHASE,208V |
| DS2416MP000 | 制造商:Thomas & Betts 功能描述:DS2416MP000 200A,PLG,3P4W,MG,416 制造商:Thomas & Betts 功能描述:200A,PLG,3P4W,MG,416,3P208V |
| DS2416MP00K | 制造商:Thomas & Betts 功能描述:200A,PLG,3P4W,MG,416,3P208V,CC |
發布緊急采購，3分鐘左右您將得到回復。