參數資料
型號： DS21348GN
英文描述： 3.3V E1/T1/J1 Line Interface
中文描述： 3.3 E1/T1/J1線路接口
文件頁數： 44/73頁
文件大小： 551K
代理商： DS21348GN
DS21348/Q348
44 of 73
8.2.3 Analog Loopback (LLB)
Setting ALB (CCR6.4) to a one puts the DS21348 in Analog Loopback. Signals at TTIP and TRING will
be internally connected to RTIP and RRING. The incoming signals at RTIP and RRING will be ignored.
The signals at TTIP and TRING will be transmitted as normal. See for more details.
8.2.4 Dual Loopback (DLB)
Setting both CCR6.7 and CCR6.6 to a one, LLB and RLB respectively, puts the DS21348 into Dual
Loopback operation. The TCLK and TPOS/TNEG signals will be looped back through the jitter
attenuator (if enabled) and output at RCLK and RPOS/RNEG. Clock and data recovered from RTIP and
RRING will be looped back to the transmit-side and output at TTIP and TRING. This mode of operation
is not available when implementing hardware operation. See for more details.
8.3 PRBS Generation and Detection
Setting TPRBSE (CCR3.4) = 1 enables the DS21348 to transmit a 2
15
- 1 (E1) or a 2
20
- 1 (T1) Pseudo
Random Bit Sequence (PRBS) depending on the ETS bit setting in CCR1.7. The receive-side of the
DS21348 will always search for these PRBS patterns independent of CCR3.4. The PRBS Bit Error
Output (PBEO) will remain high until the receiver has synchronized to one of the two patterns (64 bits
received without an error) at which time PBEO will go low and the PRBSD bit in the Status Register
(SR) will be set. Once synchronized, any bit errors received will cause a positive going pulse at PBEO,
synchronous with RCLK. This output can be used with external circuitry to keep track of bit error rates
during the PRBS testing. Setting CCR6.0 (ECRS) = 1 will allow the PRBS errors to be accumulated in
the 16-bit counter in registers ECR1 and ECR2. The PRBS synchronizer will remain in sync until it
experiences 6 bit errors or more within a 64 bit span. Both PRBS patterns comply with the ITU-T O.151
specifications.
8.4 Error Counter
Error Count Register 1 (ECR1) is the most significant word and ECR2 is the least significant word of a
user selectable 16-bit counter that records incoming errors including BiPolar Violations (BPV), Code
Violations (CV), Excessive Zero violations (EXZ) and/or PRBS Errors. See Table 8-3 and Table 8-4 and
Figure 3-2 for details.
DEFINITION OF RECEIVED ERRORS
Table 8-3
ERROR
E1 OR T1
BPV
E1/T1
Two consecutive marks with the same polarity. Will ignore BPVs due to
HDB3 and B8ZS zero suppression when CCR2.3 = 0. Typically used with
AMI coding (CCR2.3 = 1). ITU-T O.161.
CV
E1
When HDB3 is enabled (CCR2.3 = 0) and the receiver detects two
consecutive BPVs with the same polarity. ITU-T O.161.
EXZ
E1
When four or more consecutive zeros are detected.
EXZ
T1
When receiving AMI coded signals (CCR2.3 = 1), detection of 16 or more
zeros or a BPV. ANSI T1.403 1999.
When receiving B8ZS coded signals (CCR2.3 = 0), detection of 8 or more
zeros or a BPV. ANSI T1.403 1999.
PRBS
E1/T1
A bit error in a received PRBS pattern. See section 8.3 for details.
ITU-T O.151.
DEFINITION OF RECEIVED ERRORS
相關PDF資料
PDF描述
DS21348 3.3V E1/T1/J1 Line Interface
DS21348T 3.3V E1/T1/J1 Line Interface
DS21348TN 3.3V E1/T1/J1 Line Interface
DS21352 3.3V DS21352 and 5V DS21552 T1 Single-Chip Transceivers
DS21352L 3.3V DS21352 and 5V DS21552 T1 Single-Chip Transceivers
相關代理商/技術參數
參數描述
DS21348GN+ 功能描述:網絡控制器與處理器 IC 3.3V E1/T1/J1 Line Interface RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS21348GNB 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS21348GN-C01 功能描述:網絡控制器與處理器 IC 3.3V E1/T1/J1 Line Interface RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS21348T 功能描述:網絡控制器與處理器 IC 3.3V E1/T1/J1 Line Interface RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS21348T+ 功能描述:網絡控制器與處理器 IC 3.3V E1/T1/J1 Line Interface RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*