- 您現在的位置：買賣IC網 > PDF目錄376928 > DRP3510 (Electronic Theatre Controls, Inc.) Digital Receiver Front-end PDF資料下載
參數資料
| 型號： | DRP3510 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | Digital Receiver Front-end |
| 中文描述： | 數字接收機前端 |
| 文件頁數： | 8/30頁 |
| 文件大?。?/td> | 450K |
| 代理商： | DRP3510 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
DRX 3960A
ADVANCE INFORMATION
8
Micronas
2. Functional Description
2.1. Input Amplifier with TOP Setting
The first block of the DRX 3960A is a low-noise pre-
amplifier. It has a setable gain between 0 and 20 dB for
setting
the Tuner take Over Point voltage (TOP). This
adjustment is responsible for optimal tuner operation.
Note:
The TOP is the tuner input voltage at which the
IF circuit (e.g. the DRX 3960A) begins to reduce the
tuner gain. Thus, above this voltage the tuner output
voltage remains nearly constant. Of course, the gain of
the tuner is only allowed to be reduced if the S/N is suf-
ficiently high. A level of 60...70 dB
μ
V at the antenna
input is a typical value for the starting point of gain
reduction.
2.2. Carrier Recovery
A digital PLL performs the tracking of the picture car-
rier and therefore synchronous demodulation.
The lock in range refers to the desired IF frequency
which is chosen according to the programmed TV
standard (e.g. 32.9 MHz at L
’
or 38.9 MHz at all other
standards).
The PLL incorporates its own AFC function and pro-
vides the frequency offset from the desired IF fre-
quency for external use (CR_FREQ). A special digital
validation algorithm allows long frequency lock at
100% modulation. Additionally, the PLL aligns the digi-
tal calculated Nyquist slope to the picture carrier fre-
quency.
Due to its digital implementation, the carrier recovery
is absolutely offset-free, alignment-free, drift-free, and
quartz-accurate.
2.3. Channel Filtering and Audio/Video Splitting
According to the selected standard, channel filtering
(suppression of not wanted signals) is performed inter-
nally by digital filters. These filters additionally sepa-
rate the video and sound components of the desired
channel and transfer them to the according output. The
processing is competitive to conventional QSS sys-
tems.
2.4. Video and Tuner AGC
The video AGC controls the CVBS amplitude to a
given value (VID_AMP). This value may be set via I
2
C
bus.
In positive modulation mode, an adaptive back porch
control (BPC) is activated. If the detected BP reference
is higher than 38% of the CVBS amplitude, or lower
than 17%, it is set to the according limit.
If the video AGC gain is to low, the tuner AGC
increases its output current. Thus, the tuner reduces
its gain.
The actual gain value of both control loops can be read
out (VID_GAIN, TAGC_I) as information about the
input signal strength.
2.5. Group Delay Equalizing
The group delay is set to compensate the pre-distor-
tion of the transmitter. Additionally, the standard set-
tings can be changed by means of four coefficients to
optimize the complete signal path (EQU_0, EQU_1,
EQU_2, EQU_3).
2.6. Peaking
To shape the frequency response, a peaking filter is
implemented. The following figure indicates the possi-
ble frequency responses:
Fig. 2
–
1:
Peaking filter frequency response
The peaking value is setable via I
2
C (VID_PEAK).
2.7. SIF AGC
The SIF AGC controls the level of the sound carrier
output. Four different reference amplitude values are
available (SIF_REF) .
The actual gain (SIF_GAIN) can be read out and set
via I
2
C.
According to the standard, the time constant is
switched to FM/NICAM (fast AGC) or AM (slow AGC).
2.8. Output Ports
Six general purpose output ports can be switched to
high or low level.
1
2
3
5
-7.5
-5
-2.5
0
2.5
5
7.5
10
Video Response [dB]
Frequency [MHz]
相關PDF資料 |
PDF描述 |
|---|---|
| DRX3960 | Digital Receiver Front-end |
| DRX3960A | Digital Receiver Front-end |
| DRR1-23XX | Digital Radio Receiver Down Converter Modules for 21.2 to 23.6 GHz(應用在 21.2 至23.6 GHz的數字收音接收下變頻模塊) |
| DRS251 | 25 Amp Automotive Rectifier 100 to 600 Volts |
| DRS252 | 25 Amp Automotive Rectifier 100 to 600 Volts |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DR-P400-2P11 | 制造商:Drobo 功能描述:DROBO AC ADAPTER FOR STORAGE ARRAY |
| DRP-480 | 功能描述:DIN導軌式電源 RoHS:否 制造商:Mean Well 產品:Linear Supplies 商用/醫用:Commercial 輸出功率額定值:960 W 輸入電壓:180 VAC to 264 VAC, 254 VDC to 370 VDC 輸出端數量:1 輸出電壓（通道 1）:48 V 輸出電流（通道 1）: 輸出電壓（通道 2）: 輸出電流（通道 2）: 輸出電壓（通道 3）: 輸出電流（通道 3）: 尺寸:150 mm L x 110 mm W |
| DRP-480_09 | 制造商:MEANWELL 制造商全稱:Mean Well Enterprises Co., Ltd. 功能描述:480W Single Output Industrial DIN RAIL with PFC Function |
| DRP-480_11 | 制造商:MEANWELL 制造商全稱:Mean Well Enterprises Co., Ltd. 功能描述:480W Single Output Industrial DIN RAIL with PFC Function |
| DRP480-1AR | 功能描述:DIN導軌式電源 24V@20A RoHS:否 制造商:Mean Well 產品:Linear Supplies 商用/醫用:Commercial 輸出功率額定值:960 W 輸入電壓:180 VAC to 264 VAC, 254 VDC to 370 VDC 輸出端數量:1 輸出電壓（通道 1）:48 V 輸出電流（通道 1）: 輸出電壓（通道 2）: 輸出電流（通道 2）: 輸出電壓（通道 3）: 輸出電流（通道 3）: 尺寸:150 mm L x 110 mm W |
發布緊急采購，3分鐘左右您將得到回復。