- 您現在的位置：買賣IC網 > PDF目錄376804 > DM9801E (Electronic Theatre Controls, Inc.) 1M home Phonrline Network Physical Layer Single Chip Transceiver PDF資料下載
參數資料
| 型號： | DM9801E |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | 1M home Phonrline Network Physical Layer Single Chip Transceiver |
| 中文描述： | 100萬家庭Phonrline網絡物理層單芯片收發器 |
| 文件頁數： | 21/61頁 |
| 文件大?。?/td> | 589K |
| 代理商： | DM9801E |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁
DM9801
1M Home Phoneline Network Physical Layer Single Chip Transceiver
Serial Peripheral Interface (SPI) Bus
Preliminary
Version: DM9801-DS-P02
March 20, 2000
21
When INTFSEL is asserted, the DM9801 is
configured to operate in SPI mode. While
configured to operate in SPI mode, the DM9801 can
act as a SPI Slave or SPI Master. Asserting
SMODE places the DM9801 in SPI Slave mode.
Clearing SMODE places the DM9801 in SPI Master
Mode.
The SPI (Serial Peripheral Interface) Bus uses a
four-wired serial interface to obtain and control the
status of the physical layer through the SPI Bus
interface. The serial control interface consists of SI
(serial data input), SO (serial data output), SCLK
(serial clock), and SCS# (serial interface chip
select) signals. When operating in Master mode the
DM9801 drives the SCLK and SCS# signals, when
operating in Slave mode these signals are inputs.
SPI-Slave Mode (Valid only in GPSI Mode)
When SMODE is asserted the DM9801 is
configured for SPI Slave operation. Commands are
issued to the DM9801 by asserting the SCS#
signal, shifting in an 8-bit opcode followed by a
register address and an end delimiter. If the
operation is a write, the address is followed by an 8-
bit data byte. If the operation is a read, the SO pin
will shift out an 8-bit data byte representing the
contents of the register referenced by the address
field. Only one command can be sent in one SCS#
cycle. The DM9801 does not support multiple byte reads
or writes.
SPI-Master Mode (Valid only in GPSI Mode)
When SMODE is cleared the DM9801 is configured
for SPI Master operation. When the DM9801 is
configured for SPI-Master operation, it will load all
programmable registers from an external SPI type
EEPROM. The memory locations loaded may be
offset via the boot page pins, BP[1:0], allowing a
single 256 byte serial EEPROM to hold four distinct
sets of default register values.
After RESET# has cleared the DM9801 will assert
SCS#, shift out a Read opcode (0x03), followed by
the initial address to be read (as modified by the
Boot Page pins). The DM9801 will then shift in the
memory contents, auto incrementing the register
address being programmed every 8-bits. Once all
64-bytes have been read, the DM9801 releases
SCS#. The SCLK continues to run. Opcodes are
shown in Table 1.
Instruction Format
0000 0110
0000 0100
0000 0011
0000 0010
Instruction Name
Set WE
Clear WE
Read
Write
OPCODES
Table 1
相關PDF資料 |
PDF描述 |
|---|---|
| DMA2271 | Consumer IC |
| DMA2280 | Consumer IC |
| DMA2281 | Consumer IC |
| DMA2275 | DMA 2275, DMA 2286 C/D/D2-MAC Descrambler |
| DMA2286 | DMA 2275, DMA 2286 C/D/D2-MAC Descrambler |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DM9B | 功能描述:數字萬用表 4000 COUNT AUTO RoHS:否 制造商:Tektronix 產品:Multimeters 類型:Bench 準確性:0.04 % 電壓范圍:2 V to 2 kV 電阻范圍: 電容范圍: 顯示計數: 頻率:10 Hz to 45 Hz, 850 Hz to 1 MHz 測距: 真均方根值: 數據保持: |
| D-M9B | 制造商:SMC Corporation of America 功能描述:Sensor, solid state, direct mount, grommet connection, for MX/MH/CQ2/NCQ2/NCQ8 制造商:SMC 功能描述:2-Wire Auto Switch for 24Vdc Relay/PLC |
| D-M9BA | 制造商:SMC Corporation of America 功能描述:Autoswitch, water resistant, 2 wire, horizontal |
| D-M9BAL | 制造商:SMC Corporation of America 功能描述:AUTOSWITCH, DIRECT MT, SOLID STATE, GROMMET ENTRY, 3M LEADWIRE |
| D-M9BAVL | 制造商:SMC Corporation of America 功能描述:Autoswitch, water resistant, 2 wire, vertical |
發布緊急采購，3分鐘左右您將得到回復。