- 您現在的位置：買賣IC網 > PDF目錄17106 > DC1684A-B (Linear Technology)BOARD DAC LTC2752 PDF資料下載
參數資料
| 型號： | DC1684A-B |
| 廠商： | Linear Technology |
| 文件頁數： | 11/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD DAC LTC2752 |
| 軟件下載： | QuikEval System |
| 設計資源： | DC1684A Design File DC1684A Schematic |
| 標準包裝： | 1 |
| 系列： | QuikEval™, SoftSpan™ |
| DAC 的數量： | 2 |
| 位數： | 16 |
| 數據接口： | 串行，SPI? |
| 設置時間： | 2µs |
| DAC 型： | 電流 |
| 工作溫度： | 0°C ~ 70°C |
| 已供物品： | 板 |
| 已用 IC / 零件： | LTC2752 |
| 相關產品： | DC590B-ND - BOARD DEMO USB SERIAL CONTROLLER LTC2752BILX#PBF-ND - IC DAC 16BIT DUAL CUR OUT 48LQFP LTC2752AILX#PBF-ND - IC DAC 16BIT DUAL CUR OUT 48LQFP LTC2752BCLX#PBF-ND - IC DAC 16BIT DUAL CUR OUT 48LQFP LTC2752ACLX#PBF-ND - IC DAC 16BIT DUAL CUR OUT 48LQFP |
LTC2752
2752f
operaTion
The offset adjust pin VOSADJX can be used to null unipolar
offset or bipolar zero error. The offset change expressed
in LSB is the same for any output range:
V LSB
V
OS
VOSADJX
RINX
[ ]= –
512
A 5V control voltage applied to VOSADJX produces VOS =
–512 LSB in any output range, assuming a 5V reference
voltage at RINX.
In voltage terms, the offset delta is attenuated by a factor
of 32, 64 or 128, depending on the output range. (These
functions hold regardless of reference voltage.)
VOS = –(1/128)VOSADJX
[0V to 5V, ±2.5V spans]
VOS = –(1/64)VOSADJX
[0V to 10V, ±5V, –2.5V to
7.5V spans]
VOS = –(1/32)VOSADJX
[±10V span]
The gain error adjust pins GEADJX can be used to null
gain error or to compensate for reference errors. The
gain error change expressed in LSB is the same for any
output range:
GE
V
GEADJX
RINX
=
512
The gain-error delta is non-inverting for positive reference
voltages.
Note that this pin compensates the gain by altering the
invertedreferencevoltageVREFX.Involtageterms,theVREFX
delta is inverted and attenuated by a factor of 128.
VREFX = –(1/128)GEADJX
The nominal input range of these pins is ±5V; other volt-
ages of up to ±15V may be used if needed. However, do
not use voltages divided down from power supplies; ref-
erence-quality, low-noise inputs are required to maintain
the best DAC performance.
The VOSADJX pins have an input impedance of 1.28MΩ.
These pins should be driven with a Thevenin-equivalent
impedance of 10k or less to preserve the settling perfor-
mance of the LTC2752. They should be shorted to GND
if not used.
The GEADJXpinshaveaninputimpedanceof2.56MΩ,and
are intended for use with fixed reference voltages only.
They should be shorted to GND if not used.
Power-On Reset and Clear
When power is first applied to the LTC2752, all DACs
power-up in unipolar 5V mode (S3 S2 S1 S0 = 0000). All
internal DAC registers are reset to 0 and the DAC outputs
initialize to zero volts.
If the part is configured for manual span operation, all
DACs will be set into the pin-strapped range at the first
Update command. This allows the user to simultaneously
update span and code for a smooth voltage transition into
the chosen output range.
When the CLR pin is taken low, a system clear results.
The DAC buffers are reset to 0 and the DAC outputs are
all reset to zero volts. The Input buffers are left intact, so
that any subsequent Update command (including the use
of LDAC) restores the addressed DACs to their respective
previous states.
If CLR is asserted during an instruction, i.e., when CS/LD
is low, the instruction is aborted. Integrity of the relevant
Input buffers is not guaranteed under these conditions,
therefore the contents should be checked using readback
or replaced.
The RFLAG pin is used as a flag to notify the system of a
loss of data integrity. The RFLAG output is asserted low
at power-up, system clear, or if the supply VDD dips below
approximately2V;andstaysasserteduntilanyvalidUpdate
command is executed.
相關PDF資料 |
PDF描述 |
|---|---|
| 0210390927 | CABLE JUMPER 1MM .102M 23 POS |
| REC3-2412DRWZ/H6/A | CONV DC/DC 3W 9-36VIN +/-12VOUT |
| GBM18DSAH | CONN EDGECARD 36POS R/A .156 SLD |
| SCRH5D28-180 | INDUCTOR SMD 18UH 0.95A 10KHZ |
| 0210390942 | CABLE JUMPER 1MM .030M 25POS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DC1687A | 制造商:Linear Technology 功能描述:EVAL BOARD, LTC3115 BUCK-BOOST CONVERTER, Silicon Manufacturer:Linear Technology, Silicon Core Number:LTC3115, Kit Application Type:Power Management - Voltage Regulator, Application Sub Type:Synchronous Buck-Boost Converter , RoHS Compliant: NA |
| DC1691A01XY_D4X WAF | 制造商:Fairchild Semiconductor Corporation 功能描述: |
| DC1691A01XY-D4X WAF | 制造商:Fairchild Semiconductor Corporation 功能描述: |
| DC1692C17XX_D4X WAF | 制造商:Fairchild Semiconductor Corporation 功能描述: |
| DC1692C18AX-D4X WAF | 制造商:Fairchild Semiconductor Corporation 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。