參數資料
型號: D6571E
廠商: Electronic Theatre Controls, Inc.
英文描述: Chip for an All-Digital Telephone Answering Machine with Flash Memory Interface
中文描述: 芯片的全數字電話應答機與快閃記憶體介面
文件頁數: 21/117頁
文件大?。?/td> 551K
代理商: D6571E
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁
D6571E Data Sheet
DS6571E.2
DSP GROUP, INC., 3120 SCOTT BOULEVARD
SANTA CLARA, CA 95054 PH: 408 986-4300 FAX: 408 986-4490
21
Minimum Level Emin
- minimum input signal energy
level that is amplified to optimum value Eopt. For
signals greater than Emin the AGC gain is calculated as
G = Eopt/Einput
Maximum gain Gmax = Eopt/Emin
Gain Threshold Level Eatt -
signals smaller than Emin
and larger than Eatt are amplified by maximum gain Gmax
Silence Threshold Level Es il
- signals lower than Esil
are considered silence. The gain for such signals = 1.
Signals greater than Esil but smaller than Eatt will be
amplified by the gain linearly growing from 1 to Gmax.
Hold Time Thold
- this parameter the hold time of the
AGC gain during the pause in the speech. The intent of
the decay time is to “bridge” the gaps between syllables
and words resulting in stable gain.
Decay Time Tdec
- this parameter defines the rate by
which the gain increases after hold time elapsed.
Default values of the parameters are presented in the
following table.
Parameter
Default
Value
(decimal)
Eopt
4 dB
Emin
22 dB
Eatt
36 dB
Esil
46 dB
Thold
100
Tdecay
10
* -
Calculated as (3 - Value) dBm
Default
Value (hex)
Default Value
(Physical
meaning)
- 1 dBm*
- 19 dBm*
- 33 dBm*
- 43 dBm*
2.0 sec
1.0 sec
0004
0016
0024
002E
0064
000A
0
1
E
sil
E
att
E
min
E
opt
Gain function
G
Submode 011
= HPF configuration
Submode 3 enables low pass filter (enabled by default).
The performance of this mode is the same in case of
“cold” and “warm start.”
Submode 100
= FSK configuration
This submode allows to control sensitivity of the FSK
detector.
7) Volume Control (Test Mode = 1000)
This mode allows setting of the signal level playing to
the Codec. The default value is 0 dB and the volume
may be set in 2 dB steps from -42 to +16 dB or may be
muted.
This command allows the HOST to read the current
volume setting without changing it (bit 7 = 0), or set new
volume (bit 7 = 1) specified in bits 0 through 4. The
status will reflect the current volume setting.
The Volume Control command can be issued in Record,
Playback, Voice Prompt and Line Monitor Mode without
interrupting these modes. When issued in one of these
modes, the status will be the status of the current
operating mode. Therefore, current volume setting can
not be read during operating modes.
The performance of this mode is the same in case of
“cold” and “warm start.”
8) Storage Configuration (Test Mode = 1001)
This mode allows to define necessary space of the
General Purpose Storage. GPS can occupy up to 16
sectors 3200 bytes each sector. By default GPS is not
available (0 sectors).
9) Program DTMF, VOX, CPT, CAS Sensitivity (Test
Mode = 1010)
The mode allows independent setting of the sensitivity
of the DTMF detection, CAS detection, VOX detection,
and Call Progress Tone detection. The default
sensitivity level is 0 dB and each sub-system may be
adjusted in 2 dB steps from -16 dB (most sensitive) to
+42 dB (least sensitive)or can be disabled.
This command also allows the HOST to read the current
sensitivity setting of the selected signaling subsystem
(specified in bits 6 - 7) without changing this setting (bit
5 = 0). When bit 5 = 1, the command sets the new
相關PDF資料
PDF描述
D658S14SEITE1BIS5 SCR / Diode Presspacks
D659S14SEITE1BIS5 SCR / Diode Presspacks
D6694ZOV301RA300
D6694ZOV102RA720
D6694ZOV131RA140
相關代理商/技術參數
參數描述
D65792-000 制造商:TE Connectivity 功能描述:Fuse Chip 0.75A Fast 2-Pin Solder Pad Surface Mount T/R 制造商:TE Connectivity 功能描述:1206SFF075F/63-2 - Tape and Reel 制造商:TE Connectivity 功能描述:FUSE 0.75A 63V FAST SMD 1206 制造商:TE Connectivity / Raychem 功能描述:FUSE 0.75A 63V FAST SMD 1206 制造商:TE CONNECTIVITY RAYCHEM-POLYSWITCH 功能描述:El Fuse / 1206SFF075F/63-2
D657ZOV271RA140 制造商:Maida Development Company 功能描述:
D-658 制造商:Triad Magnetics 功能描述:
D6582ZOV681RX260/CL 制造商:Maida Development Company 功能描述:
D65840GJ029 制造商:NEC Electronics Corporation 功能描述:ELECTRONIC COMPONENT