- 您現在的位置：買賣IC網 > PDF目錄376539 > D6571E (Electronic Theatre Controls, Inc.) Chip for an All-Digital Telephone Answering Machine with Flash Memory Interface PDF資料下載
參數資料
| 型號： | D6571E |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | Chip for an All-Digital Telephone Answering Machine with Flash Memory Interface |
| 中文描述： | 芯片的全數字電話應答機與快閃記憶體介面 |
| 文件頁數： | 12/117頁 |
| 文件大?。?/td> | 551K |
| 代理商： | D6571E |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁
D6571E Data Sheet
DS6571E.2
DSP GROUP, INC., 3120 SCOTT BOULEVARD
SANTA CLARA, CA 95054 PH: 408 986-4300 FAX: 408 986-4490
12
OPERATIONAL DESCRIPTION
INITIAL PROCEDURE
No operation should be performed with the new flash
before it is initialized once. Any flash access before
initialization may destroy information about bad blocks
and make flash unusable.
After power up, the
PDN
signal (pin 22) should be set
high followed by the RESET pulse (Refer to Figure 4 for
the timing). Upon detecting falling edge of the RESET
pulse, the D6571E checks some predefined locations in
the Flash Memory to determine if Flash was initialized
and responds to one of the following situations:
1. Flash memory was previously initialized -
“warm start”. The D6571E restores the
previous conditions and system parameters. The
message directory and all messages remain saved.
The D6571E returns garbage collection status
with the “cold start” bit reset (0).
2. Flash memory was not previously initialized -
“cold start”. The D6571E returns garbage
collection status with the “cold start” bit set (1).
After sending Garbage Collection status the D6571E
will enter Idle mode. After sending RESET the Host
should wait for ACK pin to become low and then read
status. No command should be sent to the D6571E until
host reads the Garbage Collection Status.
If this is a “cold start” only commands that do not
require flash access are available: Idle, Line Monitor,
Read Memory Status, SpeakerPhone, Tone Generation
(16 standard DTMF tones only), Data Pump, and Self
Test and Initialization. If any other command is issued,
the D6571E will stay in Idle mode and return Idle status.
The D6571E behaves in the same manner if the flash is
not initialized (
“cold start”
condition) or there is no
flash in the system (
“no flash”
condition).
To initialize flash memory Flash Hardware Selection
(Test Mode = 0101) be issued first because no other Self
Test and Initialization command will be accepted until
this command is issued! After Flash Hardware Selection
only Test Mode = 0011 (Fast Self Test) and Test Mode
= 0001 (Flash Initialization) are available.
The Flash Hardware Selection and the Fast Self Test
command can be issued to confirm the configuration of
the flash if necessary. Fast Test will destroy the
contents of the memory except for the voice prompt
sectors, tone table, and bad block table.
Normally the Flash Hardware Selection and then the
Flash Initialization command may be sent to perform the
Initialization. All memory will be initialized except for the
voice prompt sectors and bad block table.
MODES OF OPERATION
The D6571E is normally in Idle mode. Each time a
command other than Idle is issued, the system will enter
the new mode. From some of the modes, the system will
automatically return to Idle mode after completion of the
operation. Other modes (Record, Playback, Tone
Generation, Line Monitoring, Voice Prompt Generation
and SpeakerPhone) require an Idle command to return to
Idle mode.
There are 16 modes of operation. Each of these modes
is entered from the monitor program through Idle mode.
The 16 modes are as follows:
0.
Idle
- The D6571E performs command polling. It
checks the command register in the HOST-D6571E
interface and transfers to the requested operating
mode.
1.
Record
- The D6571E performs speech compression
and records a message into the Flash memory.*
2.
Playback
- The D6571E performs message playback
using compressed speech data stored in the Flash
memory.*
3.
Read Memory Status
- The D6571E returns
information on the Memory status to the HOST,
e.g., the number of messages stored in the Flash
memory, memory full condition, program ROM
checksum status, voice prompt checksum status
and if Garbage collection is recommended.
4.
Write Data to Storage
- In this mode the D6571E
receives data from the HOST and stores it either in
the Telephone Number Storage, or Non-Erasable
Storage, or General Purpose Storage in the flash
under index number given by the HOST.
5.
Read Data from Storage
- The D6571E returns to
the HOST data stored in Telephone Number
Storage, or Non-Erasable Storage, or General
Purpose Storage under the index number given by
the HOST.
6.
Tone Generation
- The D6571E generates a single
or double tone with programmable parameters. *
相關PDF資料 |
PDF描述 |
|---|---|
| D658S14SEITE1BIS5 | SCR / Diode Presspacks |
| D659S14SEITE1BIS5 | SCR / Diode Presspacks |
| D6694ZOV301RA300 | |
| D6694ZOV102RA720 | |
| D6694ZOV131RA140 | |
相關代理商/技術參數 |
參數描述 |
|---|---|
| D65792-000 | 制造商:TE Connectivity 功能描述:Fuse Chip 0.75A Fast 2-Pin Solder Pad Surface Mount T/R 制造商:TE Connectivity 功能描述:1206SFF075F/63-2 - Tape and Reel 制造商:TE Connectivity 功能描述:FUSE 0.75A 63V FAST SMD 1206 制造商:TE Connectivity / Raychem 功能描述:FUSE 0.75A 63V FAST SMD 1206 制造商:TE CONNECTIVITY RAYCHEM-POLYSWITCH 功能描述:El Fuse / 1206SFF075F/63-2 |
| D657ZOV271RA140 | 制造商:Maida Development Company 功能描述: |
| D-658 | 制造商:Triad Magnetics 功能描述: |
| D6582ZOV681RX260/CL | 制造商:Maida Development Company 功能描述: |
| D65840GJ029 | 制造商:NEC Electronics Corporation 功能描述:ELECTRONIC COMPONENT |
發布緊急采購，3分鐘左右您將得到回復。