- 您現在的位置：買賣IC網 > PDF目錄10366 > D2-24044-MR-T (Intersil)IC DGTL AMP AUDIO PWR D 38HTSSOP PDF資料下載
參數資料
| 型號： | D2-24044-MR-T |
| 廠商： | Intersil |
| 文件頁數： | 18/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DGTL AMP AUDIO PWR D 38HTSSOP |
| 標準包裝： | 2,500 |
| 系列： | D2Audio™ |
| 類型： | D 類 |
| 輸出類型： | 2-通道（立體聲）或 4 通道（四路） |
| 在某負載時最大輸出功率 x 通道數量： | 30W x 2 @ 8 歐姆 |
| 電源電壓： | 9 V ~ 26 V |
| 安裝類型： | 表面貼裝 |
| 供應商設備封裝： | 38-HTSSOP |
| 封裝/外殼： | 38-TFSOP （0.173"，4.40mm 寬）裸露焊盤 |
| 包裝： | 帶卷 (TR) |
7
FN7678.0
September 3, 2010
13
PWM7
I
3.3
PWM Input. Routes to output channel, dependent on output configuration settings.
14
PWM8
I
3.3
PWM Input. Routes to output channel, dependent on output configuration settings.
15
PWMGND2
GND
0
PWMGND and PWMGND2 are to tie together to the same ground.
16
nERRORA
O
3.3
Overcurrent protection output, channel A output stage. Open drain, 16mA drive strength
output with pull-up. Pulls low when active from overcurrent detection of output stage.
17
nERRORB
O
3.3
Overcurrent protection output, channel B output stage. Open drain, 16mA drive strength
output with pull-up. Pulls low when active from overcurrent detection of output stage.
18
nERRORC
O
3.3
Overcurrent protection output, channel C output stage. Open drain, 16mA drive strength
output with pull-up. Pulls low when active from overcurrent detection of output stage.
19
nERRORD
O
3.3
Overcurrent protection output, channel D output stage. Open drain, 16mA drive strength
output with pull-up. Pulls low when active from overcurrent detection of output stage.
20
HVDDD
P
HV
Output stage D high voltage supply power. A separate power pin connection is provided
for each of the output stages. All of the HVDD[A:D] pins and the VDDHV pin connect to
the system “HV” power source.
21
HGNDD
GND
HV
Output stage D high voltage supply ground. A separate ground pin connection is provided
for each of the output stages. All of the HGND[A:D] pins connect to system “HV” power
ground (also see Note 8).
22
OUTD
O
HV
PWM power amplifier output, channel D.
23
HSBSD
I
HV
High side boot strap input, output channel D. Capacitor couples to OUTD amplifier output.
24
HSBSC
I
HV
High side boot strap input, output channel C. Capacitor couples to OUTC amplifier output.
25
OUTC
O
HV
PWM power amplifier output, channel C.
26
HGNDC
GND
HV
Output stage C high voltage supply ground. A separate ground pin connection is provided
for each of the output stages. All of the HGND[A:D] pins connect to system “HV” power
ground (also see Note 8).
27
HVDDC
P
HV
Output stage C high voltage supply power. A separate power pin connection is provided
for each of the output stages. All of the HVDD[A:D] pins and the VDDHV pin connect to
the system “HV” power source.
28
IREF
I
-
Overcurrent reference analog input. Used in setting the overcurrent error detect
externally-set threshold. The pin needs to be connected to a 100kΩ resistor to ground to
set the overcurrent threshold according to the specified limits.
29
VDDHV
P
+HV
High Voltage internal driver supply power. All of the HVDD[A:D] pins and the VDDHV pin
connect to the system “HV” power source. The internal +5V supply regulators also
operate from this VDDHV input.
30
REG5V
P
5
5V internal regulator filter connect. A +5V supply is internally generated from the voltage
source provided at the VDDHV pin. REG5V is used for external connection of a decoupling
capacitor.
31
HVDDB
P
HV
Output stage B high voltage supply power. A separate power pin connection is provided
for each of the output stages. All of the HVDD[A:D] pins and the VDDHV pin connect to
the system “HV” power source.
32
HGNDB
GND
HV
Output stage B high voltage supply ground. A separate ground pin connection is provided
for each of the output stages. All of the HGND[A:D] pins connect to system “HV” power
ground (also see Note 8).
33
OUTB
O
HV
PWM power amplifier output, channel B.
34
HSBSB
I
HV
High side boot strap input, output channel B. Capacitor couples to OUTB amplifier output.
35
HSBSA
I
HV
High side boot strap input, output channel A. Capacitor couples to OUTA amplifier output.
36
OUTA
O
HV
PWM power amplifier output, channel A.
Pin Description (Continued)
PIN
PIN NAME
(Note 7)
TYPE
VOLTAGE
LEVEL
(V)
DESCRIPTION
D2-24044
相關PDF資料 |
PDF描述 |
|---|---|
| VE-J1B-MX | CONVERTER MOD DC/DC 95V 75W |
| VE-J14-MX | CONVERTER MOD DC/DC 48V 75W |
| ISL54006IRTZ-T | IC AMP AUDIO PWR 1.23W AB 20TQFN |
| 17984-7PG-300 | CONN RCPT 7POS PNL MNT PIN |
| VE-J1K-MX | CONVERTER MOD DC/DC 40V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| D224E | 制造商:MPD 制造商全稱:MicroPower Direct, LLC 功能描述:Low Cost, 2W SIP Single & Dual Output DC/DC Converters |
| D224ED | 制造商:MPD 制造商全稱:MicroPower Direct, LLC 功能描述:Very Low Cost, 2W SIP Dual Isolated Output DC/DC Converters |
| D224EI | 制造商:MPD 制造商全稱:MicroPower Direct, LLC 功能描述:Low Cost, 2W SIP High Isolation DC/DC Converters |
| D224ERW | 制造商:MPD 制造商全稱:MicroPower Direct, LLC 功能描述:Low Cost, Miniature 2W SIP, Wide Input DC/DC Con vert ers |
| D224I | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:High Isolation Miniature, 2W SIP DC/DC Converters |
發布緊急采購，3分鐘左右您將得到回復。