- 您現在的位置：買賣IC網 > PDF目錄366900 > CS1301 PDF資料下載
參數資料
| 型號： | CS1301 |
| 文件頁數： | 13/25頁 |
| 文件大?。?/td> | 542K |
| 代理商： | CS1301 |
Revision 2.2
13
www.national.com
G
Signal Definitions
(Continued)
2.2
SIGNAL DESCRIPTIONS
2.2.1
System Interface Signals
Signal Name
Ball
No.
Type
Description
TRI_CLKIN
L20
I
Main Input Clock.
The SDRAM clock outputs (MM_CLK0 and
MM_CLK1) can be set to 2x or 3x this frequency. The on-chip DSPCPU
clock (DSPCPU_CLK) can be set to 1x, 5/4, 4/3, 3/2 or 2x the SDRAM
clock frequency. The maximum recommended ppm level is ±100 ppm or
lower to improve jitter on generated clocks. The duty cycle should not
exceed 30/70% asymmetry.
The operating limits of the internal PLLs are:
27 MHz < Output of the SDRAM PLL < 200 MHz
33 MHz < Output of the CPU PLL < 266 MHz
These are not the speed grades of the chips, just the PLL limits.
TRI_USERIRQ
G20
I
General Purpose Level/Edge Interrupt Input.
Vectored interrupt
source number 4.
TRI_TIMER_CLK
H19
I
External General Purpose Clock Source for Timers
. Maximum 40
MHz.
TRI_RESET#
G19
I
CS1301/CS1311 RESET Input.
This pin can be tied to the PCI_RST#
signal in the PCI bus systems. Upon releasing RESET, CS1301/CS1311
initiates its boot protocol.
VREF_PCI
F2
PWR
PCI Voltage Reference.
Determines the mode of operation of the PCI
pins. VREF_PCI must be connected to V
SS
(0V) for use in 3.3V PCI sig-
naling environment, as is the case for a Geode SCx200 system.
The supply to this pin should be AC bypassed and provide 40 mA of DC
sink or source capability.
VREF_PERIPH
C18
PWR
Peripheral Voltage Reference.
Determines the mode of operation of
the I/O pins listed in Section 2.3 "Reference Voltages" on page 22.
VREF_PERIPH must be connected to 5.0V if the designated I/O pins
listed in Section 2.3 should be 5.0V input voltage capable.
VREF_PERIPH must be connected to V
SS
(0V) if the designated I/O
pins listed in Section 2.3 are 3.3V only inputs.
The supply to this pin should be AC bypassed and provide 40 mA of DC
sink or source capability.
相關PDF資料 |
PDF描述 |
|---|---|
| CS1311 | |
| CS142 | Phase Control Thyristors |
| CS1501-7R | 100 Watt DC-DC Converters |
| CS1001-7R | 100 Watt DC-DC Converters |
| CS1301-7R | 100 Watt DC-DC Converters |
相關代理商/技術參數 |
參數描述 |
|---|---|
| C-S-130-14T | 制造商:MOLEX 制造商全稱:Molex Electronics Ltd. 功能描述:Krimptite? Temp-Term Ring Tongue Terminal for 10 to 12 AWG Wire, Stud Size 1/4,Mylar Tape Carrier |
| CS1301-7R | 功能描述:EURO-CASSETTE 100W 12V RoHS:否 類別:電源 - 外部/內部（非板載） >> DC DC Converters 系列:* 標準包裝:1 系列:Quint 類型:隔離 輸入電壓:24V 輸出:24V 輸出數:1 輸出 - 1 @ 電流（最大）:24 VDC @ 50A 輸出 - 2 @ 電流（最大）:- 輸出 - 3 @ 電流（最大）:- 輸出 - 4 @ 電流（最大）:- 功率（瓦特）:1200W 安裝類型:底座安裝 工作溫度:0°C ~ 40°C 效率:- 封裝/外殼:模塊 尺寸/尺寸:4.33" L x 9.09" W x 6.14" H（110mm x 231mm x 156mm） 包裝:散裝 電源（瓦特）- 最大:1200W 批準:- 其它名稱:277-69722866365-NDQUINT-BAT/24DC/12AH |
| CS1301-9ER | 制造商:Power-One 功能描述:DCDC - Bulk |
| CS1301-9ERB1 | 功能描述:DC/DC CONVERTER 12V 8A 制造商:bel power solutions 系列:Melcher S 包裝:散裝 零件狀態:有效 類型:隔離 電壓 - 輸入:28 ~ 140 V 輸出:12V 輸出數:1 不同電流時的輸出（最大值） - 1:12 VDC @ 8A 不同電流時的輸出（最大值） - 2:- 不同電流時的輸出（最大值） - 3:- 不同電流時的輸出（最大值） - 4:- 功率（W）:96W 應用:ITE（商業），鐵路 安裝類型:底座安裝 工作溫度:-40°C ~ 71°C 效率:83% 封裝/外殼:- 大小/尺寸:6.73" 長 x 4.37" 寬 x 1.86" 高（171.0mm x 111.0mm x 47.2mm） 功率（W） - 最大值:96W 認可:cCSAus，CE，TUV 標準包裝:1 |
| CS13035 | 制造商:UNBRANDED 功能描述:HEADSET + MIC FOLDABLE |
發布緊急采購，3分鐘左右您將得到回復。