- 您現在的位置：買賣IC網 > PDF目錄10902 > AMIS30585C5852RG (ON Semiconductor)IC MODEM S-FSK HALFDUPLEX 28PLCC PDF資料下載
參數資料
| 型號： | AMIS30585C5852RG |
| 廠商： | ON Semiconductor |
| 文件頁數： | 5/17頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MODEM S-FSK HALFDUPLEX 28PLCC |
| 標準包裝： | 750 |
| 波特率： | 14.4k |
| 電源電壓： | 3 V ~ 3.6 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-LCC（J 形引線） |
| 供應商設備封裝： | 28-PLCC（11.51x11.51） |
| 包裝： | 帶卷 (TR) |
AMIS30585
http://onsemi.com
13
Table 13. RECEIVER EXTERNAL PARAMETERS: Pin RX_IN, RX_OUT, REF_OUT
Parameter
Description
Condition
Min.
Max.
Unit
VOFFS_RX_IN
Input offset voltage 42 dB
AGC gain = 42 dB
5
mV
VOFFS_RX_IN
Input offset voltage 0 dB
AGC gain = 0 dB
50
mV
VMAX_RX_IN
Max. peak input voltage (corresponding to 62.5%
of the SD full scale)
AGC gain = 0 dB
(Note 16)
0.85
1.15
Vp
NFRX_IN
Input referred noise of the analog receiver path
AGC gain = 42 dB
150
NV/#Hz
ILE_RX_IN
Input leakage current of receiver input
1
mA
IMax_REF_OUT
Max. current delivered by REF_OUT
300
+300
mA
PSRRLPF_OUT
Power supply rejection ratio of the receiver input
section
AGC gain = 42 dB
10
(Note 18)
35
(Note 19)
dB
AGCstep
AGC gain step
5.7
6.3
dB
AGCrange
AGC range
39.9
44.1
dB
VREF_OUT
Analog ground reference output voltage
1.57
1.73
V
SNAD_OUT
Signal to noise ratio at 62.5% of the SD full scale
54
dB
VCLIP_AGC_IN
Clipping level at the output of the gain stage
1.15
1.65
Vp
16.Input at RX_IN, no other external components.
17.This parameter will be characterized on a limited number of prototypes and will not be tested in production.
18.A sinusoidal signal of 10 kHz and 100 mV ptp is injected between VDDA and VSSA. The signal level at the differential LPF_OUT and
REF_OUT output is measured to determine the parameter.
19.A sinusoidal signal of 50 Hz and 100 mV ptp is injected between VDDA and VSSA. The signal level at the differential LPF_OUT output is
measured to determine the parameter.
20.These parameters will be tested in production with an input signal of 95 kHz and 1 Vp by reading out the digital samples at the point AD_OUT
with the default settings of T_RX_MOD[7], SDMOD_TYP, DEC_TYP, and COR_F_ENA. The AGC gain is switched to 0 dB.
The receive LPF filter + AGC + low noise amplifier must
have a frequency characteristic between the limits listed
below. The absolute output level depends on the operating
condition. In production the measurement will be done for
relative output levels where the 0 dB reference value is
measured at 50 kHz with a signal amplitude of 100 mV.
Table 14. RECEIVER FREQUENCY
CHARACTERISTICS
Frequency (kHx)
Min. (dB)
Max. (dB)
10
0.5
95
1.3
0.5
130
4.5
2.0
165
3.0
330
18.0
660
36.0
1000
50
2000
50
相關PDF資料 |
PDF描述 |
|---|---|
| AMIS49587C5871G | IC MODEM PLC 50/60MHZ 28PLCC |
| VE-24X-IX-F3 | CONVERTER MOD DC/DC 5.2V 75W |
| VE-24X-IX-F2 | CONVERTER MOD DC/DC 5.2V 75W |
| SI3015-KS | IC SI2400 LINE-SIDE DAA 16SOIC |
| SI2400-KS | IC ISOMODEM SYSTEM-SIDE 16SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AMIS30585GEVK | 功能描述:電源管理IC開發工具 EVK PLC MODEM 1200 BAUD RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| AMIS305XXGEVK | 功能描述:電源管理IC開發工具 AMIS30542 eval kit mother board RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| AMIS-30600 | 制造商:AMI 制造商全稱:AMI 功能描述:LIN Transceiver |
| AMIS30600AGA | 制造商:AMI 制造商全稱:AMI 功能描述:LIN Transceiver |
| AMIS30600LINI1G | 功能描述:LIN 收發器 LIN TRANSCEIVER RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
發布緊急采購，3分鐘左右您將得到回復。