參數資料
型號: AM79C961AVIW
廠商: ADVANCED MICRO DEVICES INC
元件分類: 微控制器/微處理器
英文描述: PCnet⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA
中文描述: 2 CHANNEL(S), 10M bps, LOCAL AREA NETWORK CONTROLLER, PQFP144
封裝: TQFP-144
文件頁數: 83/206頁
文件大?。?/td> 1507K
代理商: AM79C961AVIW
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁當前第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁
Am79C961A
83
there are link beat pulses or valid frames present. This
LED0 pin can be used to drive a LED and/or external
hardware that directly controls the SLEEP pin of the
PCnet-ISA II controller. This configuration effectively
wakes the system when there is any activity on the
10BASE-T link.
Access Operations (Software)
We begin by describing how byte and word data are
addressed on the ISA bus, including conversion cycles
where 16-bit accesses are turned into 8-bit accesses
because the resource accessed did not support 16-bit
operations. Then we describe how registers and other
resources are accessed. This section is for the device
programmer, while the next section (bus cycles) is for
the hardware designer.
I/O Resources
The PCnet-ISA II controller has both I/O and memory
resources. In the I/O space the resources are orga-
nized as indicated in the following table:
The PCnet-ISA II controller does not respond to any
addresses outside of the offset range 0-17h. I/O offsets
18h and up are not used by the PCnet-ISA II controller.
I/O Register Access
The register address port (RAP) is shared by the regis-
ter data port (RDP) and the ISACSR data port (IDP) to
save registers. To access the Ethernet controller
s RDP
or IDP, the RAP should be written first, followed by the
read or write access to the RDP or IDP. I/O register
accesses should be coded as 16-bit accesses, even if
the PCnet-ISA II controller is hardware configured for
8-bit I/O bus cycles. It is acceptable (and transparent)
for the motherboard to turn a 16-bit software access
into two separate 8-bit hardware bus cycles. The moth-
erboard accesses the low byte before the high byte and
the PCnet-ISA II controller has circuitry to specifically
support this type of access.
The reset register causes a reset when read. Any value
will be accepted and the cycle may be 8 or 16 bits wide.
Writes are ignored.
All PCnet-ISA II controller register accesses should be
coded as 16-bit operations.
Note that the RAP is cleared on Reset.
IEEE Address Access
The address PROM may be an external memory
device that contains the node
s unique physical Ether-
net address and any other data stored by the board
manufacturer. The software accesses must be 16-bit.
This information may be stored in the EEPROM.
Boot PROM Access
The boot PROM is an external memory resource
located by the address selected by the EEPROM or the
BPAM input in
slave
mode. It may be software
accessed as an 8-bit or 16-bit resource but the latter is
recommended for best performance.
Static RAM Access
The static RAM is only present in the Bus Slave mode.
In the Bus Slave mode, two SRAM access schemes
are available. When the Shared Memory architecture
mode is selected, the SRAM is accessed using ISA
memory cycles to the address range selected by the
SMAM input. It may be accessed as an 8 or 16-bit
resource but the latter is recommended for best perfor-
mance. When the Programmed I/O architecture mode
is selected, the SRAM is accessed through ISACSR0
and ISACSR1 using the RAP and IDP.
Bus Cycles (Hardware)
The PCnet-ISA II controller supports both 8-bit and
16-bit hardware bus cycles. The following sections out-
line where any limitations apply based upon the archi-
tecture mode and/or the resource that is being
accessed (PCnet-ISA II controller registers, address
PROM, boot PROM, or shared memory SRAM). For
completeness, the following sections are arranged by
architecture (Bus Master Mode or Bus Slave Mode).
SRAM resources apply only to Bus Slave Mode.
All resources (registers, PROMs, SRAM) are pre-
sented to the ISA bus by the PCnet-ISA II controller.
With few exceptions, these resources can be config-
ured for either 8-bit or 16-bit bus cycles. The I/O
resources (registers, address PROM) are width con-
figured using the EEPROM. The memory resources
(boot PROM, SRAM) are width configured by external
hardware.
For 16-bit memory accesses, hardware external to the
PCnet-ISA II controller asserts MEMCS16 when either
of the two memory resources is selected. The ISA bus
requires that all memory resources within a block of
128 Kbytes be the same width, either 8- or 16-bits. The
reason for this is that the MEMCS16 signal is generally
a decode of the LA
17-23
address lines. 16-bit memory
capability is desirable since two 8-bit accesses take the
same amount of time as four 16-bit accesses.
All accesses to 8-bit resources (which do not return
MEMCS16 or IOCS16) use SD0-7. If an odd byte is
accessed, the Current Master swap buffer turns on.
Offset
#Bytes
Register
0h
16
IEEE Address
10h
2
RDP
12h
2
RAP(shared by RDP and IDP)
14h
2
Reset
16h
2
IDP
相關PDF資料
PDF描述
Am79C965A PCnet?-32 Single-Chip 32-Bit Ethernet Controller
AM79C970AKCW PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product
AM79C970AKC PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product
AM79C970A PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product
AM79C970AVCW PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product
相關代理商/技術參數
參數描述
AM79C961AWW WAF 制造商:Advanced Micro Devices 功能描述:
AM79C961KC 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnetTM-ISA+ Jumperless Single-Chip Ethernet Controller for ISA
AM79C961KC/W 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnetTM-ISA+ Jumperless Single-Chip Ethernet Controller for ISA
AM79C965A 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet?-32 Single-Chip 32-Bit Ethernet Controller