- 您現在的位置：買賣IC網 > PDF目錄385094 > AK5352-VF (Asahi Kasei Microsystems Co.,Ltd) 96kHz Sampling 20bit ADC PDF資料下載
參數資料
| 型號： | AK5352-VF |
| 廠商： | Asahi Kasei Microsystems Co.,Ltd |
| 英文描述： | 96kHz Sampling 20bit ADC |
| 中文描述： | 96kHz采樣20位模數轉換器 |
| 文件頁數： | 16/19頁 |
| 文件大?。?/td> | 174K |
| 代理商： | AK5352-VF |
ASAHI KASEI
[AK5352]
0155-E-00
1997/1
- 16 -
Grounding and Power Supply Decoupling
The AK5352 requires careful attention to power supply and grounding arrangements. The VA and VB are
connected together through the chip substrate and have several ohm resistance. The power to VB should
come up at the same time or faster than the power to VD, when they are fed separately to the device (Figure 5 ).
As to the connections of decoupling capacitors, refer to Figure 5 . The 0.1uF of decoupling capacitors
connected power supply pins should be as near as possible to the power supply pin.
As AINL
±
pins is near VD pin, ground pattern should be inserted between VD line and AINL
±
lines to avoid
digital noise coupling. Refer to evaluation board manual of AKD5352/1 Rev.B about board layout.
Analog connections
Analog signal is differentially input into the modulator via the AIN+ and the AIN- pins. The input voltage is the
difference between AIN+ and AIN- pins. The full-scale of each pin is
±
3.47Vp-p on its reference
voltage(VREF). In case that the positive input is more than its full-scale, the AK5352 outputs positive
7FFFFH(Hex, Full-scale). In case that the negative input is more than its full-scale, the AK5352 outputs
negative 80000H(Hex, Full- scale). In case of an ideal value of no input, outputs 00000H(@20bit). DC offset is
removed by internal HPF.
AK5352 samples the analog inputs at 3.072MHz with fs=48kHz. The digital filter rejects all noise between
26.5kHz and 3.0455MHz. However, the filter will not reject frequencies right around 3.072MHz ( and multiples
of 3.072MHz). Most audio signals do not have significant noise energy at 3.072MHz. Hence, a simple RC filter
is sufficient to attenuate any noise energy at 3.072MHz.
The reference voltage for A/D converter is supplied from the VREF pin at VA reference. In order to eliminate
the effects of high frequency noise on the VREF pin, a 10uF or less electrolytic capacitor and a 0.1uF ceramic
capacitor should be connected parallel between the VREF and the VA pins. No current should be driven from
the VREF pin.
The AK5352 accepts +5V supply voltage. Any voltage which exceeds the upper limit of (VA+)+0.3V and lower
limit of AGND-0.3V and any current beyond 10mA for the analog input pins(AINL
±
, AINR
±
) should be avoided.
Excessive currents to the input pins may damage the device. Hence input pins must be protected from signals
at or beyond these limits.
Use caution specially in case of using
±
15V in surrounding analog circuit.
Digital Connections
To minimize digital originated noise, connect the ADC digital outputs only to CMOS inputs. Logic families of
4000B, 74HC, 74AC, 74ACT and 74HCT series are suitable.
Multiple AK5352
In systems where multiple ADC's are required, care must be taken to insure the internal clocks are synchronized
between converters to make simultaneous sampling. In slave mode, synchronous sampling is achieved by supplying
the same MCLK and LRCK to all converters. In master mode, the same PD signal is supplied to each ADC. The PD
state is released at the first rising edge of MCLK after bringing PD into high. Hence, if the rising edge of PD and rising
edge of MCLK coincides together the sampling difference among the ADC's modulator would occur. The difference
could be 1/256fs in the sampling clock(64fs) of the modulator, typically 81ns at fs=48kHz.
相關PDF資料 |
PDF描述 |
|---|---|
| AK5353 | 96kHz ΔΣ 24bit ADC with Single-ended Input(帶寬采樣率4KHz到96KHz和單端輸入的24位立體聲ΔΣA/D轉換器) |
| AK5353VT | 96kHz 24BIT ADC WITH SIGLE-ENDED INPUT |
| AK5354 | Lowe Power 20Bit ΔΣ ADC with PGA(帶可編程增益放大器的低電壓20位ΔΣA/D轉換器) |
| AK5354VT | Circular Connector; No. of Contacts:55; Series:MS27484; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:16; Circular Contact Gender:Socket; Circular Shell Style:Straight Plug; Insert Arrangement:16-35 RoHS Compliant: No |
| AK5355VN | Low Power 16bit ツヒ ADC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AK5353 | 制造商:AKM 制造商全稱:AKM 功能描述:EVALUATION BOARD REV.B FOR AK5353 |
| AK5353VT | 制造商:AKM 制造商全稱:AKM 功能描述:96kHz 24BIT ADC WITH SIGLE-ENDED INPUT |
| AK5353VTP-E2 | 制造商:Asahi Kasei Microsystems Co Ltd 功能描述:24BIT 96K 96DB |
| AK5354 | 制造商:AKM 制造商全稱:AKM 功能描述:EVALUATION BOARD REV.A FOR AK5354 |
| AK5354_04 | 制造商:AKM 制造商全稱:AKM 功能描述:Low Power 20bit ツヒ ADC with PGA |
發布緊急采購，3分鐘左右您將得到回復。