- 您現在的位置：買賣IC網 > PDF目錄385091 > AK4366VT (Asahi Kasei Microsystems Co.,Ltd) Low Power 24-Bit 2ch DAC with HP-AMP PDF資料下載
參數資料
| 型號： | AK4366VT |
| 廠商： | Asahi Kasei Microsystems Co.,Ltd |
| 英文描述： | Low Power 24-Bit 2ch DAC with HP-AMP |
| 中文描述： | 低功耗24位2通道DAC，具有惠普腺苷 |
| 文件頁數： | 28/31頁 |
| 文件大?。?/td> | 349K |
| 代理商： | AK4366VT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁第29頁第30頁第31頁
ASAHI KASEI
[AK4366]
MS0248-E-01
2004/03
- 28 -
1. Grounding and Power Supply Decoupling
The AK4366 requires careful attention to power supply and grounding arrangements. VDD and HVDD are usually
supplied from the analog power supply in the system. When VDD and HVDD are supplied separately, VDD must be
powered-up at the same time or earlier than HVDD. When the AK4366 is powered-down, HVDD must be powered-down
at the same time or later than VDD. VSS must be connected to the analog ground plane. System analog ground and digital
ground should be connected together near to where the supplies are brought onto the printed circuit board. Decoupling
capacitors should be as close to the AK4366 as possible, with the small value ceramic capacitors being the nearest.
2. Voltage Reference
The input voltage to VDD sets the analog output range. A 0.1
μ
F ceramic capacitor and a 10
μ
F electrolytic capacitor is
connected between VDD and VSS, normally. VCOM is a signal ground of this chip (0.45 x VDD). An electrolytic 2.2
μ
F
in parallel with a 0.1
μ
F ceramic capacitor attached between VCOM and VSS eliminates the effects of high frequency
noise. No load current may be drawn from VCOM pin. All signals, especially clock, should be kept away from VDD and
VCOM in order to avoid unwanted coupling into the AK4366.
3. Analog Outputs
The analog outputs are single-ended outputs and 0.47xVDD Vpp(typ)@
4.8dBFS centered on the VCOM voltage. The
input data format is 2’s compliment. The output voltage is a positive full scale for 7FFFFFH(@24bit) and negative full
scale for 800000H(@24bit). The ideal output is VCOM voltage for 000000H(@24bit).
DC offsets on the analog outputs is eliminated by AC coupling since the analog outputs have a DC offset equal to VCOM
plus a few mV.
相關PDF資料 |
PDF描述 |
|---|---|
| AK4366 | Low Power 24-Bit 2ch DAC with HP-AMP |
| AK4367VN | Low Power 24-Bit 2ch DAC with HP-AMP & Output Mixer |
| AK4368EG | DAC with built-in PLL & HP-AMP |
| AK4370 | 24-Bit 2ch DAC with HP-AMP & Output Mixer |
| AK4370VN | 24-Bit 2ch DAC with HP-AMP & Output Mixer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AK4367 | 制造商:AKM 制造商全稱:AKM 功能描述:Low Power 24-Bit 2ch DAC with HP-AMP & Output Mixer |
| AK4367_05 | 制造商:AKM 制造商全稱:AKM 功能描述:Low Power 24-Bit 2ch DAC with HP-AMP & Output Mixer |
| AK4367VN | 制造商:AKM 制造商全稱:AKM 功能描述:Low Power 24-Bit 2ch DAC with HP-AMP & Output Mixer |
| AK4367VNP-L | 制造商:Asahi Kasei Microsystems Co Ltd 功能描述: |
| AK4368 | 制造商:AKM 制造商全稱:AKM 功能描述:PLL & HP-AMP DAC |
發布緊急采購，3分鐘左右您將得到回復。