參數資料
型號： ADV7342BSTZ
廠商： ANALOG DEVICES INC
元件分類： DAC
英文描述： Multiformat Video Encoder Six, 11-Bit, 297 MHz DACs
中文描述： SERIAL INPUT LOADING, 11-BIT DAC, QFP64
封裝： ROHS COMPLIANT, MS-026BCD, LQFP-64
文件頁數： 60/88頁
文件大小： 1053K
代理商： ADV7342BSTZ
ADV7342/ADV7343
When changing the adaptive filter mode to Mode B
(Subaddress 0x35, Bit 6), the output shown in Figure 76
can be obtained.
Rev. 0 | Page 60 of 88
0
Figure 76. Output Signal from ED/HD Adaptive Filter (Mode B)
SD DIGITAL NOISE REDUCTION
Subaddress 0xA3 to Subaddress 0xA5
Digital noise reduction (DNR) is applied to the Y data only.
A filter block selects the high frequency, low amplitude compo-
nents of the incoming signal (DNR input select). The absolute
value of the filter output is compared to a programmable
threshold value (DNR threshold control). There are two DNR
modes available, DNR mode and DNR sharpness mode.
In DNR mode, if the absolute value of the filter output is smaller
than the threshold, it is assumed to be noise. A programmable
amount (coring gain border, coring gain data) of this noise
signal is subtracted from the original signal. In DNR sharpness
mode, if the absolute value of the filter output is less than the
programmed threshold, it is assumed to be noise. Otherwise, if
the level exceeds the threshold, now identified as a valid signal,
a fraction of the signal (coring gain border, coring gain data) is
added to the original signal to boost high frequency components
and sharpen the video image.
In MPEG systems, it is common to process the video information
in blocks of 8 pixels × 8 pixels for MPEG2 systems, or 16 pixels ×
16 pixels for MPEG1 systems (block size control). DNR can be
applied to the resulting block transition areas that are known to
contain noise. Generally, the block transition area contains two
pixels. It is possible to define this area to contain four pixels
(border area).
It is also possible to compensate for variable block positioning
or differences in YCrCb pixel timing with the use of the DNR
block offset.
The digital noise reduction registers are three 8-bit registers.
They are used to control the DNR processing.
BLOCK SIZE CONTROL
BORDER AREA
BLOCK OFFSET
CORING GAIN DATA
CORING GAIN BORDER
GAIN
DNR CONTROL
FILTER
OUTPUT
> THRESHOLD
INPUT FILTER
BLOCK
FILTER OUTPUT
< THRESHOLD
DNR OUT
+
+
MAIN SIGNAL PATH
ADD SIGNAL
ABOVE
THRESHOLD
RANGE FROM
ORIGINAL SIGNAL
DNR
SHARPNESS
MODE
NOISE
SIGNAL PATH
Y DATA
INPUT
BLOCK SIZE CONTROL
BORDER AREA
BLOCK OFFSET
CORING GAIN DATA
CORING GAIN BORDER
GAIN
DNR CONTROL
FILTER
OUTPUT
< THRESHOLD
INPUT FILTER
BLOCK
FILTER OUTPUT
> THRESHOLD
DNR OUT
MAIN SIGNAL PATH
SUBTRACT
SIGNAL IN
THRESHOLD
RANGE FROM
ORIGINAL SIGNAL
DNR MODE
NOISE
SIGNAL PATH
Y DATA
INPUT
–
+
0
Figure 77. SD DNR Block Diagram
Coring Gain Border—Subaddress 0xA3, Bits[3:0]
These four bits are assigned to the gain factor applied to border
areas. In DNR mode, the range of gain values is 0 to 1 in
increments of 1/8. This factor is applied to the DNR filter
output that lies below the set threshold range. The result is then
subtracted from the original signal.
In DNR sharpness mode, the range of gain values is 0 to 0.5 in
increments of 1/16. This factor is applied to the DNR filter
output that lies above the threshold range. The result is added to
the original signal.
Coring Gain Data—Subaddress 0xA3, Bits[7:4]
These four bits are assigned to the gain factor applied to the luma
data inside the MPEG pixel block. In DNR mode, the range of
gain values is 0 to 1 in increments of 1/8. This factor is applied
to the DNR filter output that lies below the set threshold range.
The result is then subtracted from the original signal.
In DNR sharpness mode, the range of gain values is 0 to 0.5 in
increments of 1/16. This factor is applied to the DNR filter
output that lies above the threshold range. The result is added to
the original signal.
相關PDF資料
PDF描述
ADV7343 Multiformat Video Encoder Six, 11-Bit, 297 MHz DACs
ADV7344 Multiformat Video Encoder Six 14-Bit Noise Shaped Video DACs
ADV7344BSTZ Multiformat Video Encoder Six 14-Bit Noise Shaped Video DACs
ADV7390 Low Power, Chip Scale 10-Bit SD/HD Video Encoder
ADV7390BCPZ Low Power, Chip Scale 10-Bit SD/HD Video Encoder
相關代理商/技術參數
參數描述
ADV7343 制造商:AD 制造商全稱:Analog Devices 功能描述:Multiformat Video Encoder Six, 11-Bit, 297 MHz DACs
ADV7343BSTZ 功能描述:IC ENCODER VIDEO W/DAC 64-LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 編碼器，解碼器，轉換器 系列:- 產品變化通告:Development Systems Discontinuation 26/Apr/2011 標準包裝:1 系列:- 類型:編碼器 應用:DVB-S.2 系統 電壓 - 電源，模擬:- 電壓 - 電源，數字:- 安裝類型:- 封裝/外殼:模塊 供應商設備封裝:模塊 包裝:散裝 其它名稱:Q4645799
ADV7343WBSTZ 功能描述:IC ENCODER VID 12BIT DAC 64LQFP 制造商:analog devices inc. 系列:- 包裝:托盤 零件狀態:在售 類型:視頻編碼器 應用:DVD，Blu-Ray 電壓 - 電源，模擬:2.6 V ~ 3.46 V 電壓 - 電源，數字:1.71 V ~ 1.89 V 安裝類型:表面貼裝 封裝/外殼:64-LQFP 供應商器件封裝:64-LQFP（10x10） 標準包裝:1
ADV7343WBSTZ-RL 功能描述:Video Encoder IC DVD, Blu-Ray 64-LQFP (10x10) 制造商:analog devices inc. 系列:- 包裝:帶卷（TR） 零件狀態:有效 類型:視頻編碼器 應用:DVD，Blu-Ray 電壓 - 電源，模擬:2.6 V ~ 3.46 V 電壓 - 電源，數字:1.71 V ~ 1.89 V 安裝類型:表面貼裝 封裝/外殼:64-LQFP 供應商器件封裝:64-LQFP（10x10） 標準包裝:1,500
ADV7344 制造商:AD 制造商全稱:Analog Devices 功能描述:Multiformat Video Encoder Six 14-Bit Noise Shaped Video DACs
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*