- 您現在的位置：買賣IC網 > PDF目錄11201 > ADUC832BCPZ-REEL (Analog Devices Inc)IC MCU 62K FLASH ADC/DAC 56LFCSP PDF資料下載
參數資料
| 型號： | ADUC832BCPZ-REEL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 69/92頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MCU 62K FLASH ADC/DAC 56LFCSP |
| 標準包裝： | 2,500 |
| 系列： | MicroConverter® ADuC8xx |
| 核心處理器： | 8052 |
| 芯體尺寸： | 8-位 |
| 速度： | 16MHz |
| 連通性： | EBI/EMI，I²C，SPI，UART/USART |
| 外圍設備： | PSM，溫度傳感器，WDT |
| 輸入/輸出數： | 34 |
| 程序存儲器容量： | 62KB（62K x 8） |
| 程序存儲器類型： | 閃存 |
| EEPROM 大?。?/td> | 4K x 8 |
| RAM 容量： | 2.25K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 2.7 V ~ 5.5 V |
| 數據轉換器： | A/D 8x12b，D/A 2x12b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 56-VFQFN 裸露焊盤，CSP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁當前第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁
Data Sheet
ADuC832
Rev. B | Page 71 of 92
TCON (Timer/Counter 0 and Timer/Counter 1 Control
Register)
SFR Address:
88H
Power-On Default Value:
00H
Bit Addressable:
Yes
TIMER/COUNTER 0 AND TIMER/COUNTER 1 DATA
REGISTERS
Each timer consists of two 8-bit registers. These can be used as
independent registers or combined to be a single 16-bit register,
depending on the timer mode configuration.
TH0 and TL0
TH0 is the Timer 0 high byte and TL0 is the low byte. The SFR
addresses for TH0 and TL0 are 8CH and 8AH, respectively.
TH1 and TL1
TH1 is the Timer 1 high byte and TH0 is the low byte. The SFR
addresses for TH1 and TL1 are 8DH and 8BH, respectively.
Table 37. TCON SFR Bit Designations
Bit
Name
Description
[7]
TF1
Timer 1 overflow flag.
Set by hardware on a Timer/Counter 1 overflow.
Cleared by hardware when the program counter (PC) vectors to the interrupt service routine.
[6]
TR1
Timer 1 run control bit.
Set by the user to turn on Timer/Counter 1.
Cleared by the user to turn off Timer/Counter 1.
[5]
TF0
Timer 0 overflow flag.
Set by hardware on a Timer/Counter 0 overflow.
Cleared by hardware when the PC vectors to the interrupt service routine.
[4]
TR0
Timer 0 run control bit.
Set by the user to turn on Timer/Counter 0.
Cleared by the user to turn off Timer/Counter 0.
[3]
External Interrupt 1 (INT1) flag.
Set by hardware by a falling edge or zero level being applied to external interrupt Pin INT1, depending on the state of Bit IT1.
Cleared by hardware when the PC vectors to the interrupt service routine only if the interrupt was transition-activated. If
level-activated, the external requesting source controls the request flag, rather than the on-chip hardware.
[2]
IT11
External Interrupt 1 (IE1) trigger type.
Set by software to specify edge-sensitive detection (that is, a 1-to-0 transition).
Cleared by software to specify level-sensitive detection (that is, zero level).
[1]
External Interrupt 0 (INT0) flag.
Set by hardware by a falling edge or zero level being applied to external interrupt Pin INT0, depending on the state of Bit IT0.
Cleared by hardware when the PC vectors to the interrupt service routine only if the interrupt was transition-activated.
If level-activated, the external requesting source controls the request flag, rather than the on-chip hardware.
[0]
IT01
External Interrupt 0 (IE0) trigger type.
Set by software to specify edge-sensitive detection (that is, 1-to-0 transition).
Cleared by software to specify level-sensitive detection (that is, zero level).
1
These bits are not used in the control of Timer/Counter 0 and Timer/Counter 1, but are used instead in the control and monitoring of the external INT0 and INT1
interrupt pins.
相關PDF資料 |
PDF描述 |
|---|---|
| ATSAM3A8CA-AU | IC MCU 2X256KB CORTEX-M3 100-QFP |
| NS5B1G384DTT1G | IC ANLG SWITCH SPST NC SC-70-5 |
| M74VHC1GT66DFT2G | IC SWITCH SPST SOT353 |
| ADUC824BCPZ | IC MCU 8K FLASH ADC/DAC 56LFCSP |
| IDTQS4A215Q1G8 | IC MUX/DEMUX DUAL 4X1 48QVSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADUC832BS | 制造商:Analog Devices 功能描述:MCU 8-Bit ADuC8xx 8052 CISC 62KB Flash 3.3V/5V 52-Pin MQFP 制造商:Rochester Electronics LLC 功能描述:8BIT CISC 62KB FLASH 16.78MHZ 3.3/5V 52MQFP - Bulk 制造商:Analog Devices 功能描述:8BIT MCU +12BIT ADC LQFP52 832 |
| ADUC832BS-REEL | 制造商:Analog Devices 功能描述:MCU 8-Bit ADuC8xx 8052 CISC 62KB Flash 3.3V/5V 52-Pin MQFP T/R |
| ADUC832BSZ | 功能描述:IC ADC/DAC 12BIT W/MCU 52MQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC8xx 標準包裝:250 系列:56F8xxx 核心處理器:56800E 芯體尺寸:16-位 速度:60MHz 連通性:CAN，SCI，SPI 外圍設備:POR，PWM，溫度傳感器，WDT 輸入/輸出數:21 程序存儲器容量:40KB（20K x 16） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:6K x 16 電壓 - 電源 (Vcc/Vdd):2.25 V ~ 3.6 V 數據轉換器:A/D 6x12b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:48-LQFP 包裝:托盤 配用:MC56F8323EVME-ND - BOARD EVALUATION MC56F8323 |
| ADUC832BSZ-REEL | 功能描述:IC MCU 62K FLASH ADC/DAC 52MQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC8xx 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA，UART/USART 外圍設備:欠壓檢測/復位，LED，POR，PWM，WDT 輸入/輸出數:16 程序存儲器容量:4KB（4K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC（0.295"，7.50mm 寬） 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND |
| ADUC832QS-U1 | 制造商:Analog Devices 功能描述:EVAL KIT - Bulk |
發布緊急采購，3分鐘左右您將得到回復。