參數資料
型號： AD9788BSVZ
廠商： Analog Devices Inc
文件頁數： 37/64頁
文件大?。?/td> 0K
描述： IC DAC 16BIT 800MSPS 100TQFP
產品培訓模塊： Data Converter Fundamentals
DAC Architectures
設計資源： Powering the AD9788 Using ADP2105 for Increased Efficiency (CN0141)
標準包裝： 1
系列： TxDAC®
位數： 16
數據接口： 串行
轉換器數目： 2
電壓電源： 模擬和數字
功率耗散（最大）： 450mW
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 100-TQFP 裸露焊盤
供應商設備封裝： 100-TQFP-EP（14x14）
包裝： 托盤
輸出數目和類型： 4 電流，單極；4 電流，雙極
采樣率（每秒）： 800M
產品目錄頁面： 785 (CN2011-ZH PDF)
AD9785/AD9787/AD9788
Rev. A | Page 42 of 64
DEVICE SYNCHRONIZATION
System demands may impose two different requirements for
synchronization. Some systems require multiple DACs to be
synchronized to each other, for example, a system that supports
transmit diversity or beamforming, where multiple antennas are
used to transmit a correlated signal. In this case, the DAC outputs
need to be phase aligned with each other, but there may not be a
requirement for the DAC outputs to be aligned with a system-
level reference clock. In systems with a time division multiplexing
transmit chain, one or more DACs may be required to be
synchronized with a system-level reference clock.
Multiple devices are considered synchronized to each other
when the state of the clock generation state machines is
identical for all parts and the NCO phase accumulator is
identical for all parts. Devices are considered synchronized to a
system clock when there is a fixed and known relationship
between the clock generation state machine and the NCO phase
accumulator of the device to a particular clock edge of the
system clock. The AD9785/AD9787/AD9788 support two
modes of operation, pulse mode and PN code mode, for
synchronizing devices under these two conditions.
SYNCHRONIZATION LOGIC OVERVIEW
Figure 60 shows a block diagram of the on-chip synchronization
receive logic. There are two different modes of operation for the
multichip synchronization feature: pulse mode and pseudorandom
noise code (PN code) modulation/demodulation mode. The basic
function of these two modes is to initialize the internal clock
generation state machine and the NCO phase accumulator
upon the application of external signals to the device.
The receive logic responsible for initializing the clock gener-
ation state machine generates a single DACCLK cycle-wide
initialization pulse that sets the clock generation state machine
logic to a known state. In pulse mode, this pulse is generated at
every rising edge of the SYNC_I inputs. In PN code mode, the
pulse is generated every time the correct code sequence is
received on the SYNC_I inputs.
This initialization pulse loads the clock generation state machine
with the Clock State [3:0] value (Register 0x03, Bits [7:4]) as its
next state. If the initialization pulse from the synchronization
logic is generated properly, it is active for one DAC clock cycle,
every 32 (or multiple of 32) DAC clock cycles. Because the clock
generation state machine has 32 states operating at the DACCLK
rate, every initialization pulse received after the first pulse loads
the current state (the state to which the state machine is already
set), maintaining the proper clock operation of the device.
The Clock State [3:0] value is the state to which the clock
generation state machine resets upon initialization. By varying
this value, the timing of the internal clocks, with respect to
the SYNC_I signal, can be adjusted. Every increment of the
Clock State [3:0] value advances the internal clocks by one
DACCLK period.
The NCO phase accumulators can be initialized in pulse mode
or PN code mode. In pulse mode, a simultaneous strobe signal
must be sent to the TXENABLE pin of all devices that is
synchronous to the DATACLK signal. This signal resets the
phase accumulator of the NCOs across all devices, effectively
synchronizing the NCOs.
In PN code mode, the phase information of the master device is
sent to the slave devices by the SYNC_I signal. The slave devices
decode this phase information and automatically initialize their
NCO phase accumulators to match the master device.
相關PDF資料
PDF描述
SI5316-C-GM IC PREC JITTER ATTENUATOR 36-QFN
AD7839ASZ IC DAC 13BIT OCTAL V-OUT 44-MQFP
AD5360BSTZ IC DAC 16BIT 16CH SERIAL 52-LQFP
AD5764BSUZ IC DAC 16BIT QUAD VOUT 32-TQFP
VE-J53-MZ-F4 CONVERTER MOD DC/DC 24V 25W
相關代理商/技術參數
參數描述
AD9788BSVZRL 功能描述:IC DAC 16BIT 800MSPS 100TQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:TxDAC® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 設置時間:1µs 位數:8 數據接口:串行 轉換器數目:8 電壓電源:雙 ± 功率耗散（最大）:941mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC W 包裝:帶卷 (TR) 輸出數目和類型:8 電壓，單極 采樣率（每秒）:*
AD9788-DPG2-EBZ 功能描述:BOARD EVALUATION FOR AD9788 RoHS:是 類別:編程器，開發系統 >> 評估板 - 數模轉換器 (DAC) 系列:* 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- DAC 的數量:4 位數:12 采樣率（每秒）:- 數據接口:串行，SPI? 設置時間:3µs DAC 型:電流/電壓 工作溫度:-40°C ~ 85°C 已供物品:板 已用 IC / 零件:MAX5581
AD9788-EBZ 制造商:Analog Devices 功能描述:Evaluation Board For AD9788 制造商:Analog Devices 功能描述:DUAL 16B, D-A CONVERTER - Bulk 制造商:Analog Devices 功能描述:Digital to Analog Eval. Board
AD9788MOD-EBZ 制造商:Analog Devices 功能描述:DUAL 12-/14-/16-BIT 800 MSPS DAC WITH LOW POWER 32-BIT COMPLEX NCO 制造商:Analog Devices 功能描述:DUAL 16B, D-A CONVERTER - Bulk
AD9789BBC 功能描述:數模轉換器- DAC 14 Bit 2.5 GSPS D-A Converter RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*