- 您現在的位置：買賣IC網 > PDF目錄10569 > AD7938BSUZ-6REEL7 (Analog Devices Inc)IC ADC 12BIT 8CHAN 32TQFP PDF資料下載
參數資料
| 型號： | AD7938BSUZ-6REEL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 16/32頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 12BIT 8CHAN 32TQFP |
| 標準包裝： | 1 |
| 位數： | 12 |
| 采樣率（每秒）： | 625k |
| 數據接口： | 并聯 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 7.5mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-TQFP |
| 供應商設備封裝： | 32-TQFP（7x7） |
| 包裝： | 標準包裝 |
| 輸入數目和類型： | 8 個單端，單極；4 個差分，單極；4 個偽差分，單極；7 偽差分，單極 |
| 產品目錄頁面： | 780 (CN2011-ZH PDF) |
| 配用： | EVAL-AD7938CBZ-ND - EVAL BOARD FOR AD7938 |
| 其它名稱： | AD7938BSUZ-6REEL7DKR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
Data Sheet
AD7938-6
Rev. C | Page 23 of 32
At the end of the conversion, BUSY goes low and can be used to
activate an interrupt service routine. The CS and RD lines are
then activated in parallel to read the 12 bits of conversion data.
When power supplies are first applied to the device, a rising
edge on CONVST is necessary to put the track-and-hold into
track. The acquisition time of 125 ns minimum must be allowed
before CONVST is brought low to initiate a conversion. The
ADC then goes into hold on the falling edge of CONVST and
back into track on the 13th rising edge of CLKIN after this (see
). When operating the device in autoshutdown or
autostandby mode, where the ADC powers down at the end of
each conversion, a rising edge on the
CONVST signal is used to
power up the device.
PARALLEL INTERFACE
The AD7938-6 has a flexible, high speed, parallel interface. This
interface is 12-bits wide and is capable of operating in either
word (W/B tied high) or byte (W/B tied low) mode. The
CONVST signal is used to initiate conversions, and when
operating in autoshutdown or autostandby mode, it is used to
initiate power-up.
A falling edge on the CONVST signal is used to initiate
conversions and it puts the ADC track-and-hold into track.
Once the CONVST signal goes low, the BUSY signal goes high
for the duration of the conversion. In between conversions,
CONVST must be brought high for a minimum time of t1. This
must happen after the 14th falling edge of CLKIN; otherwise, the
conversion is aborted and the track-and-hold goes back into track.
t2
t3
t20
t14
t11
t9
t13
t12
t10
tCONVERT
tACQUISITION
tQUIET
t1
12
3
4
5
12
13
14
B
A
DATA
OLD DATA
DB0 TO DB11
RD
THREE-STATE
CS
INTERNAL
TRACK/HOLD
BUSY
CLKIN
CONVST
WITH CS AND RD TIED LOW
04
75
1-
00
4
Figure 35. AD7938-6 Parallel Interface—Conversion and Read Cycle Timing in Word Mode (W/B = 1)
相關PDF資料 |
PDF描述 |
|---|---|
| VI-B5J-IV-F4 | CONVERTER MOD DC/DC 36V 150W |
| VI-B5J-IV-F3 | CONVERTER MOD DC/DC 36V 150W |
| VI-250-MX | CONVERTER MOD DC/DC 5V 75W |
| AD7450ABRTZ-REEL7 | IC ADC 12BIT DIFF 1MSPS SOT23-8 |
| VE-JTN-MW-F4 | CONVERTER MOD DC/DC 18.5V 100W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7938BSUZ-REEL7 | 功能描述:IC ADC 12BIT 8CHAN 32TQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| AD7939 | 制造商:AD 制造商全稱:Analog Devices 功能描述:8-Channel, 1.5 MSPS, 12-Bit and 10-Bit Parallel ADCs with a Sequencer |
| AD7939BCP | 制造商:Analog Devices 功能描述:ADC Single SAR 1.5Msps 10-bit Parallel 32-Pin LFCSP EP |
| AD7939BCP-REEL | 制造商:Analog Devices 功能描述:ADC SGL SAR 1.5MSPS 10-BIT PARALLEL 32LFCSP EP - Tape and Reel |
| AD7939BCP-REEL7 | 制造商:Analog Devices 功能描述:ADC Single SAR 1.5Msps 10-bit Parallel 32-Pin LFCSP EP T/R 制造商:Analog Devices 功能描述:ADC SGL SAR 1.5MSPS 10-BIT PARALLEL 32LFCSP EP - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。