參數資料
型號： AD7927BRU
廠商： Analog Devices Inc
文件頁數： 18/28頁
文件大?。?/td> 0K
描述： IC ADC 12BIT 8CH 200KSPS 20TSSOP
標準包裝： 75
位數： 12
采樣率（每秒）： 200k
數據接口： DSP，MICROWIRE?，QSPI?，串行，SPI?
轉換器數目： 1
功率耗散（最大）： 7.5mW
電壓電源： 單電源
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 20-TSSOP（0.173"，4.40mm 寬）
供應商設備封裝： 20-TSSOP
包裝： 管件
輸入數目和類型： 8 個單端，單極
配用： EVAL-AD7927CBZ-ND - BOARD EVALUATION FOR AD7927
Data Sheet
AD7927
Rev. D | Page 25 of 28
For example, if the ADSP-2189 had a 20 MHz crystal such that
it had a master clock frequency of 40 MHz, then the master
cycle time would be 25 ns. If the SCLKDIV register is loaded
with the value of 3, then an SCLK of 5 MHz is obtained and
eight master clock periods elapse for every one SCLK period.
Depending on the throughput rate selected, if the timer registers
are loaded with the value, of 803, for example, then 100.5 SCLKs
occur between interrupts and subsequently between transmit
instructions. This situation results in sampling that is not equi-
distant as the transmit instruction is occurring on a SCLK edge.
If the number of SCLKs between interrupts is a whole integer
figure of N, then equidistant sampling is implemented by the DSP.
AD7927 TO DSP563xx
The connection diagram in Figure 31 shows how the AD7927
can be connected to the enhanced synchronous serial interface
(ESSI) of the DSP563xx family of DSPs from Motorola. Each
ESSI (two on board) is operated in synchronous mode (SYN
bit in CRB = 1) with internally generated word length frame
sync for both TX and RX (Bit FSL1 = 0 and Bit FSL0 = 0 in
CRB). Normal operation of the ESSI is selected by making
MOD = 0 in the CRB. Set the word length to 16 by setting bits
WL1 = 1 and WL0 = 0 in CRA. The FSP bit in the CRB should
be set to 1 so the frame sync is negative. It should be noted that
for signal processing applications, it is imperative that the frame
synchronization signal from the DSP563xx provides equidistant
sampling.
In the example shown in Figure 31, the serial clock is taken
from the ESSI so the SCK0 pin must be set as an output, SCKD
= 1. The VDRIVE pin of the AD7927 takes the same supply voltage
as that of the DSP563xx. This allows the ADC to operate at a
higher voltage than the serial interface, that is, DSP563xx, if
necessary.
SCK
SRD
STD
SC2
SCLK
DOUT
DIN
AD7927*
DSP563xx*
CS
VDRIVE
VDD
*ADDITIONAL PINS REMOVED FOR CLARITY.
03
08
8-
0
31
Figure 31. Interfacing to the DSP563xx
相關PDF資料
PDF描述
AD7934BRUZ IC ADC 12BIT 4CH 1.5MSPS 28TSSOP
AD7938BCPZ-6 IC ADC 12BIT 8CH 625KSPS 32LFCSP
AD7938BCPZ IC ADC 12BIT 8CH 1.5MSPS 32LFCSP
AD7940BRM IC ADC 14BIT UNIPOLAR 8-MSOP
AD7942BRMZ-RL7 IC ADC 14BIT 250KSPS 10-MSOP
相關代理商/技術參數
參數描述
AD7927BRU-REEL 制造商:Analog Devices 功能描述:ADC Single SAR 200ksps 12-bit Serial 20-Pin TSSOP T/R 制造商:Analog Devices 功能描述:ADC SGL SAR 200KSPS 12-BIT SERL 20TSSOP - Tape and Reel
AD7927BRU-REEL7 制造商:Analog Devices 功能描述:ADC Single SAR 200ksps 12-bit Serial 20-Pin TSSOP T/R
AD7927BRUZ 功能描述:IC ADC 12BIT 8CH 200KSPS 20TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
AD7927BRUZ 制造商:Analog Devices 功能描述:IC 12BIT ADC SMD 7927 TSSOP20
AD7927BRUZ-REEL 功能描述:IC ADC 12BIT 8CH W/SEQ 20TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*