參數資料
型號： AD7763BSVZ-REEL
廠商： Analog Devices Inc
文件頁數： 15/33頁
文件大?。?/td> 0K
描述： IC ADC 24BIT S/D 625KSPS 64-TQFP
標準包裝： 1,500
位數： 24
采樣率（每秒）： 625k
數據接口： 串行，SPI?
轉換器數目： 1
功率耗散（最大）： 955.5mW
電壓電源： 模擬和數字
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 64-TQFP 裸露焊盤
供應商設備封裝： 64-TQFP-EP（10x10）
包裝： 帶卷 (TR)
輸入數目和類型： 1 個差分，單極；1 個差分，雙極
Data Sheet
AD7763
Rev. B | Page 21 of 32
Sampling Switch SS1 and Sampling Switch SS3 are driven by ICLK,
whereas Sampling Switch SS2 and Sampling Switch SS4 are driven
by ICLK. When ICLK is high, the analog input voltage is connected
to CS1. On the falling edge of ICLK, the SS1 and SS3 switches open,
and the analog input is sampled on CS1. Similarly, when ICLK
is low, the analog input voltage is connected to CS2. On the
rising edge of ICLK, the SS2 and SS4 switches open, and the
analog input is sampled on CS2.
Capacitor CPA, Capacitor CPB1, and Capacitor CPB2 represent
parasitic capacitances that include the junction capacitances
associated with the MOS switches.
Table 11. Equivalent Component Values
Mode
CS1
CS2
CPA
CPB1/CPB2
Normal
51 pF
12 pF
20 pF
Low Power
13 pF
12 pF
5 pF
USING THE AD7763
Following is the recommended sequence for powering up and
using the AD7763.
1. Apply power.
2. Start clock oscillator, applying MCLK.
3. Take RESET low for a minimum of 1 MCLK cycle.
4. Wait a minimum of 2 MCLK cycles after RESET has been
released.
5. Write to Control Register 2 to power up the ADC and the
differential amplifier, as required.
6. Write to Control Register 1 to set up the output data rate.
7. In circumstances where multiple parts are being
synchronized, a SYNC pulse must be applied to the parts;
otherwise, no SYNC pulse is required.
The following are conditions for applying the SYNC pulse:
The issuing of a SYNC pulse to the part must not coincide
with a write to the part.
The SYNC pulse should be applied a minimum
of 2.5 ICLK cycles after the FSI signal for the previous write
to the part has returned to logic high.
Ensure that the SYNC pulse is taken low for a minimum of
2.5 ICLK cycles.
Data can now be read from the part using the default filter,
offset, gain, and overrange threshold values. The conversion
data read is not valid, however, until the settling time of the
filter has passed. When this has occurred, the DVALID bit read
is set, indicating that the data is indeed valid.
The user can then download a user-defined filter, if required
(see Downloading a User-Defined Filter). Values for gain, offset,
and overrange threshold registers can also be written or read at
this stage.
BIAS RESISTOR SELECTION
The AD7763 requires a resistor to be connected between the
RBIAS pin and AGND. The value for this resistor is dependent on
the reference voltage being applied to the device. The resistor
value should be selected to give a current of 25 A through the
resistor to ground. For a 2.5 V reference voltage, the correct
resistor value is 100 kΩ; for a 4.096 V reference voltage, the
correct resistor value is 160 kΩ.
相關PDF資料
PDF描述
MS27468T11F4SC CONN RCPT 4POS JAM NUT W/SCKT
MS3106R28-12SX CONN PLUG 26POS STRAIGHT W/SCKT
23282-31SG-350 CONN PLUG 31POS CABLE SKT
VI-B3J-MW-F4 CONVERTER MOD DC/DC 36V 100W
MS3106R28-12S CONN PLUG 26POS STRAIGHT W/SCKT
相關代理商/技術參數
參數描述
AD7764 制造商:AD 制造商全稱:Analog Devices 功能描述:24-Bit, 8.5 mW, 109 dB, 128/64/32 kSPS ADCs
AD7764_07 制造商:AD 制造商全稱:Analog Devices 功能描述:24-Bit, 312 kSPS, 109 dB ヒ-ツ ADC with On-Chip Buffers and Serial Interface
AD7764BRUZ 功能描述:IC ADC 24BIT S/D 312KSPS 28TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
AD7764BRUZ-REEL7 功能描述:IC ADC 24BIT S/D 312KSPS 28TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極
AD7765 制造商:AD 制造商全稱:Analog Devices 功能描述:24-Bit, 8.5 mW, 109 dB, 128/64/32 kSPS ADCs
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*