參數資料
型號： AD7682
廠商： Analog Devices, Inc.
英文描述： 16-Bit, 8-Channel, 250 kSPS PulSAR㈢ ADC.
中文描述： 16位，8通道，250 kSPS的PulSAR系列㈢ADC的。
文件頁數： 18/20頁
文件大小： 2041K
代理商： AD7682
AD7689
Preliminary Technical Data
WITH BUSY INDICATOR
This mode is usually used when the AD7689 is connected to an
SPI-compatible digital host using an interrupt input. The
connection diagram is shown in Figure 19,, and the
corresponding timing is given in Figure 20.
A rising edge on CNV initiates a conversion and forces SDO to
high impedance. SDO is maintained in high impedance until
the completion of the conversion irrespective of the state of
CNV. Prior to the minimum conversion time, CNV can be
used to select other SPI devices, such as analog multiplexers,
but CNV must be returned low before the minimum conversion
time elapses and then held low for the maximum possible
conversion time to guarantee the generation of the busy signal
indicator.
Configuring the AD7689 for the (n + 1) conversion is initiated
when SCK is high and a rising edge on CNV. After this mode is
initiated, CNV is a don’t care as the CFG word is written in
MSB first with 14 SCK rising edges. As shown in Figure 20,
CFG is written to during the current (
n
) conversion before the
end of conversion, or t
CONV
minimum time. At the end of
conversion, the register is updated. In this mode, the new
configuration settings are used for the following (n + 1)
Rev. PrC | Page 18 of 20
acquisition and conversion. Note that SCK must be high when
CNV goes high for this configuration mode. The AD7689 can
also be configured on the first 14 SCK of the data reading (not
shown), thus reducing the number of SCK bursts. However, this
new CFG setting is for the (n + 2) conversion.
When the conversion is complete, SDO goes from high
impedance to low impedance. With a pull-up on the SDO line,
this transition can be used as an interrupt signal to initiate the
data reading controlled by the digital host. The AD7689 then
enters the acquisition phase and powers down. The data bits are
clocked out, MSB first, by subsequent SCK falling edges. The
data is valid on both SCK edges. Although the rising edge can
be used to capture the data, a digital host using the SCK falling
edge will allow a faster reading rate, provided it has an
acceptable hold time. After the optional 17
th
SCK falling edge or
when CNV goes high (whichever occurs first), SDO returns to
high impedance.
If multiple AD7689s are selected at the same time, the SDO
output pin handles this contention without damage or induced
latch-up. Meanwhile, it is recommended to keep this contention
as short as possible to limit extra power dissipation.
DATA IN
CFG DATA
CLK
CONVERT
CNV
SCK
SDO
DIN
AD7689
DIGITAL HOST
-
VIO
IRQ
Figure 19. With Busy Indicator Connection Diagram
D15
D14
D13
D3
D2
t
DIS
SCK
1
2
3
1
2
3
13
14
t
SCK
t
SCKL
t
SCKH
t
HSDO
t
DSDO
t
SDIN
t
HDIN
t
CSCK
CONVERSION
(n)
CONVERSION
(n + 1)
ACQUISITION
(n)
ACQUISITION
(n + 1)
t
(MAX)
t
(MIN)
t
CYC
t
ACQ
-
CNV
14
15
16
D1
D0
DIN
SDO
C13
C12
C11
C1
C0
17
4
Figure 20. Wwith Busy Indicator Serial Interface Timing
相關PDF資料
PDF描述
AD7689 16-Bit, 8-Channel, 250 kSPS PulSAR㈢ ADC.
AD7699 16-Bit, 8-Channel, 250 kSPS PulSAR㈢ ADC.
ADA4851-4 Low Cost, High Speed, Rail-to-Rail, Output Op Amps
ADA4851-2 Low Cost, High Speed, Rail-to-Rail, Output Op Amps
ADA4899-1 Unity Gain Stable, Ultralow Distortion, 1 nV/ Hz Voltage Noise, High Speed Op Amp
相關代理商/技術參數
參數描述
AD7682BCBZ-RL7 功能描述:16 Bit Analog to Digital Converter 4 Input 1 SAR 20-WLCSP (2.39x2.39) 制造商:analog devices inc. 系列:PulSAR? 包裝:帶卷（TR） 零件狀態:有效 位數:16 采樣率（每秒）:250k 輸入數:4 輸入類型:差分，單端 數據接口:SPI，DSP 配置:MUX-S/H-ADC 無線電 - S/H:ADC:1:1 A/D 轉換器數:1 架構:SAR 參考類型:外部， 內部 電壓 - 電源，模擬:2.3 V ~ 5.5 V 電壓 - 電源，數字:* 特性:溫度傳感器 工作溫度:-40°C ~ 85°C 封裝/外殼:20-UFBGA，WLCSP 供應商器件封裝:20-WLCSP（2.39x2.39） 標準包裝:1,500
AD7682BCPZ 功能描述:IC ADC 16BIT 4CH 250KSPS 20LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
AD7682BCPZRL7 功能描述:IC ADC 16BIT 4CH 250KSPS 20LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
AD7683 制造商:AD 制造商全稱:Analog Devices 功能描述:16-Bit, 100 kSPS PulSAR ADC in MSOP/QFN
AD7683ACPZRL 功能描述:IC ADC 16BIT SRL 100KSPS 8LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*