- 您現在的位置：買賣IC網 > PDF目錄1891 > AD5934YRSZ (Analog Devices Inc)IC NTWK ANALYZER 12B 1MSP 16SSOP PDF資料下載
參數資料
| 型號： | AD5934YRSZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 8/32頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC NTWK ANALYZER 12B 1MSP 16SSOP |
| 產品培訓模塊： | Direct Digital Synthesis Tutorial Series (1 of 7): Introduction Direct Digital Synthesizer Tutorial Series (7 of 7): DDS in Action Direct Digital Synthesis Tutorial Series (3 of 7): Angle to Amplitude Converter Direct Digital Synthesis Tutorial Series (6 of 7): SINC Envelope Correction Direct Digital Synthesis Tutorial Series (4 of 7): Digital-to-Analog Converter Direct Digital Synthesis Tutorial Series (2 of 7): The Accumulator |
| 標準包裝： | 1 |
| 分辨率（位）： | 12 b |
| 主 fclk： | 16.776MHz |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SSOP（0.209"，5.30mm 寬） |
| 供應商設備封裝： | 16-SSOP |
| 包裝： | 管件 |
| 產品目錄頁面： | 797 (CN2011-ZH PDF) |
| 配用： | EVAL-AD5934EBZ-ND - BOARD EVALUATION FOR AD5934 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
AD5934
Data Sheet
Rev. C | Page 16 of 32
2-POINT CALIBRATION
Alternatively, it is possible to minimize this error by assuming
that the frequency variation is linear and adjusting the gain
factor with a 2-point calibration. Figure 19 shows an impedance
profile based on a 2-point gain factor calculation.
101.5
98.5
54
66
05325-
086
FREQUENCY (kHz)
IM
PE
DANCE
(k
)
101.0
100.5
100.0
99.5
99.0
56
58
60
62
64
VDD = 3.3V
CALIBRATION FREQUENCY = 60kHz
TA = 25°C
MEASURED CALIBRATION IMPEDANCE = 100k
Figure 19. Impedance Profile Using a 2-Point Gain Factor Calculation
2-POINT GAIN FACTOR CALCULATION
This is an example of a 2-point gain factor calculation assuming
the following:
Output excitation voltage = 2 V p-p
Calibration impedance value, ZUNKNOWN= 100.0 k
PGA gain = ×1
Supply voltage = 3.3 V
Current-to-voltage amplifier gain resistor = 100 k
Calibration frequencies = 55 kHz and 65 kHz
Typical values of the gain factor calculated at the two calibration
frequencies read
Gain factor calculated at 55 kHz is 1.031224 × 109.
Gain factor calculated at 65 kHz is 1.035682 × 109.
Difference in gain factor (ΔGF) is
1.035682 × 109 1.031224 × 109 = 4.458000 × 1012.
Frequency span of sweep (ΔF) is 10 kHz.
Therefore, the gain factor required at 60 kHz is given by
9
-
10
1.031224
kHz
5
kHz
10
12
-
4.458000E
×
+
×
The required gain factor is 1.033453 × 109.
The impedance is calculated as previously described in the
Impedance Calculation section.
GAIN FACTOR SETUP CONFIGURATION
When calculating the gain factor, it is important that the receive
stage is operating in its linear region. This requires careful selection
of the excitation signal range, current-to-voltage gain resistor
and PGA gain. The gain through the system shown in Figure 20
is given by
Output Excitation Voltage Range ×
UNKNOWN
Z
Resistor
Setting
Gain
× PGA Gain
05325-
089
VIN
VDD/2
RFB
ADC
LPF
ZUNKNOWN
VOUT
CURRENT-TO-VOLTAGE
GAIN SETTING RESISTOR
PGA
(×1 OR ×5)
Figure 20. System Voltage Gain
For this example, assume the following system settings:
VDD = 3.3 V
Gain setting resistor = 200 k
ZUNKNOWN = 200 k
PGA setting = ×1
The peak-to-peak voltage presented to the ADC input is 2 V p-p.
However, had the user chosen a PGA gain of ×5, the voltage
would saturate the ADC.
GAIN FACTOR RECALCULATION
The gain factor must be recalculated for a change in any of the
following parameters:
Current-to-voltage gain setting resistor
Output excitation voltage
PGA gain
相關PDF資料 |
PDF描述 |
|---|---|
| AD598JR | IC LVDT SGNL COND OSC/REF 20SOIC |
| AD660BR | IC DAC 16BIT MONO W/VREF 24-SOIC |
| AD6620ASZ | IC DGTL RCVR DUAL 67MSPS 80-PQFP |
| AD6623ASZ | IC TSP 4CHAN 104MSPS 128MQFP |
| AD6641BCPZRL7-500 | IC IF RCVR 11BIT 200MSPS 56LFCSP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5934YRSZ-REEL7 | 功能描述:IC CONV 12BIT 250KSPS 16SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 直接數字合成 (DDS) 系列:- 產品變化通告:Product Discontinuance 27/Oct/2011 標準包裝:2,500 系列:- 分辨率（位）:10 b 主 fclk:25MHz 調節字寬（位）:32 b 電源電壓:2.97 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| AD594 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Monolithic Thermocouple Amplifiers with Cold Junction Compensation |
| AD594A | 制造商:AD 制造商全稱:Analog Devices 功能描述:Monolithic Thermocouple Amplifiers with Cold Junction Compensation |
| AD594AD | 制造商:Analog Devices 功能描述:Temp Sensor Analog 14-Pin TO-116 制造商:Rochester Electronics LLC 功能描述:THERMOCOUPLER AMPLIFIER - Bulk 制造商:Analog Devices 功能描述:Special Function IC Package/Case:TO-116 |
| AD594AD/+ | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。