參數資料
型號： AD1843JST
廠商： ANALOG DEVICES INC
元件分類： 消費家電
英文描述： Serial-Port 16-Bit SoundComm Codec
中文描述： SPECIALTY CONSUMER CIRCUIT, PQFP100
封裝： PLASTIC, TQFP-100
文件頁數： 40/64頁
文件大?。?/td> 848K
代理商： AD1843JST
REV. 0
–40–
AD1843
res
Reserved for future expansion. To ensure future compatibility, write “0” to all reserved bits.
Initial default state after reset: 0000 0000 0000 0000 (0000 hex). Cleared to default and cannot be written to when:
the
RESET
pin is asserted LO; when the
PWRDWN
pin is asserted LO; or when the G1EN bit in Control Register
Address 28 is reset to “0” (clock generator 1 disabled).
Address 19
Clock Generator 2 Control—Mode
Data 15
Data 14
Data 13
Data 12
Data 11
Data 10
Data 9
Data 8
C2REF
C2VID
C2PLLG
C2P200
C2X8/7
C2C128
res
res
Data 7
Data 6
Data 5
Data 4
Data 3
Data 2
Data 1
Data 0
C2M7
C2M6
C2M5
C2M4
C2M3
C2M2
C2M1
C2M0
C2REF
Clock Generator 2 Reference Select. Selects the fundamental clock reference used by Clock Generator 2 to
synthesize its “Conversion” (sample) and “Bit” clock rates.
0
= Clocks are referenced to the input on pin XTALI (crystal or master clock input).
Sample clock frequency is defined by Control Register Address 20 and Bit C2X8/7.
Sample clock phase may be shifted by Control Register Address 21.
Bit clock frequency is defined by bits C2M7:0 and C2P200.
Bit C2VID is ignored.
1 = Clocks are referenced to the input on pin SYNC2 (Sync 2 Clock Input).
Sample clock frequency is defined by C2VID and C2M7:0.
Sample clock phase is locked to SYNC2 and cannot be shifted.
Bit clock frequency is defined by bits C2M7:0 and C2P200 unless in Video Lock Mode (C2VID set to “1”)
where the Bit clocks are not produced.
Control Register Addresses 17, 18 and the C2X8/7 bit are ignored.
Clock Generator 2 Video Lock Mode. This bit is used to select between lock modes when the Clock Generator 2 is
referenced to SYNC2 (C2REF set to “1”). This bit should be reset to “0” if C2REF is reset to “0.” When reset to
“0,” Clock Generator 2 is in
normal
lock mode where the Conversion clock will be frequency and phase locked to
SYNC2, and the Bit clock frequency is chosen using bits C2M7:0 and C2P200. When set to “1,” Clock Generator 2
is in
video
lock mode, where the Conversion clock frequency is selected using bits C2M7:0, and a Bit clock is not produced.
Clock Generator 2 PLL Loop Gain Select. If reset to “0,” this bit selects finite PLL loop gain, and if set to “1,” this
bit selects infinite PLL loop gain. This bit should nominally be reset to “0.” Setting it to “1” may enhance the PLL’s
ability to lock to certain SYNC2 inputs, but it may also increase conversion noise.
Clock Generator 2 Bit Clock +200 Frequency Modifier. When set to “1,” the Bit clock driven out of pin BIT2 will
have a frequency that is 200 Hertz greater than the frequency selected through bit C2M7:0. This bit is ignored when
in Video Lock Mode (C2VID set to “1”). C2P200 only modifies the bit clock driven on the BIT2 pin.
Clock Generator 2 Conversion Clock 8/7 Frequency Modifier. When set to “1,” the Conversion clock frequency gen-
erated will be 8/7 times the value programmed in Control Register Address 20. This bit is ignored when clocks are
referenced to SYNC2 (C2REF set to “1”).
Clock Generator 2 Conversion Clock Pin (CONV2) Frequency Select. When set to “1,” the frequency driven on to
the CONV2 pin will be 128 times the conversion rate. When reset to “0,” the frequency driven on to the CONV2 pin
will be the same as the conversion rate. C2C128 only modifies the clock frequency driven on the CONV2 pin.
Reserved for future expansion. To ensure future compatibility, write “0” to all reserved bits.
Clock Generator 2 Clock Rate Modifiers.
When not in Video Lock Mode (C2REF and C2VID are not both set to “1”):
Bits C2M7:0 select the Bit clock rate which will be driven out on pin BIT2. Using the following table, the least sig-
nificant four bits (C2M3:0) are programmed to the desired Bit clock rate, and the most significant four bits
C2VID
C2PLLG
C2P200
C2X8/7
C2C128
res
C2M7:0
overwritten even if all previously programmed phase advance/retard has not been processed. When written, the con-
tents of this register (just prior to the write) are transmitted during slot 1 of the following frame (as with all Control
Register writes).
相關PDF資料
PDF描述
AD1846JP Low Cost Parallel-Port 16-Bit SoundPort Stereo Codec
AD1849KP Serial-Port 16-Bit SoundPort Stereo Codec
AD1851 16-Bit, 16×Fs PCM Audio DACs(16位,單片PCM音頻D/A轉換器)
AD1892JR Integrated Digital Receiver/Rate Converter
AD1892JRRL Integrated Digital Receiver/Rate Converter
相關代理商/技術參數
參數描述
AD1845 制造商:AD 制造商全稱:Analog Devices 功能描述:Parallel-Port 16-Bit SoundPort Stereo Codec
AD1845JP 制造商:Analog Devices 功能描述:Audio Codec 2ADC / 2DAC 16-Bit 68-Pin PLCC 制造商:Rochester Electronics LLC 功能描述:16 BIT AUDIO CODEC - Bulk 制造商:Analog Devices 功能描述:IC CODEC 16-BIT AUDIO
AD1845JP-REEL 制造商:Analog Devices 功能描述:Audio Codec 2ADC / 2DAC 16-Bit 68-Pin PLCC T/R
AD1845JPZ 制造商:Analog Devices 功能描述:Audio Codec 2ADC / 2DAC 16-Bit 68-Pin PLCC
AD1845JST 制造商:Analog Devices 功能描述:Audio Codec 2ADC / 2DAC 16-Bit 100-Pin LQFP 制造商:Analog Devices 功能描述:IC CODEC 16-BIT AUDIO
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*