- 您現在的位置：買賣IC網 > PDF目錄375230 > AD10265AZ (ANALOG DEVICES INC) LJT 10C 10#20 SKT RECP PDF資料下載
參數資料
| 型號： | AD10265AZ |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | ADC |
| 英文描述： | LJT 10C 10#20 SKT RECP |
| 中文描述： | DUAL 3-CH 12-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, CQFP68 |
| 封裝： | CERAMIC, LCC-68 |
| 文件頁數： | 6/18頁 |
| 文件大?。?/td> | 267K |
| 代理商： | AD10265AZ |
AD10265
–6–
REV. 0
Output Propagation Delay
The delay between the 50% point of the rising edge of ENCODE
command and the time when all output data bits are within
valid logic levels.
Power Supply Rejection Ratio
The ratio of a change in input offset voltage to a change in
power supply voltage.
Signal-to-Noise-and-Distortion (SINAD)
The ratio of the rms signal amplitude (set at 1 dB below full
scale) to the rms value of the sum of all other spectral compo-
nents, including harmonics but excluding dc.
Signal-to-Noise Ratio (without Harmonics)
The ratio of the rms signal amplitude (set at 1 dB below full
scale) to the rms value of the sum of all other spectral compo-
nents, excluding the first five harmonics and dc.
Spurious-Free Dynamic Range
The ratio of the rms signal amplitude to the rms value of the
peak spurious spectral component. The peak spurious compo-
nent may or may not be a harmonic. May be reported in dBc
(i.e., degrades as signal levels is lowered) or in dBFS (always
related back to converter full scale).
Two-Tone Intermodulation Distortion Rejection
The ratio of the rms value of either input tone to the rms value
of the worst third order intermodulation product; reported in
dBc.
Two-Tone SFDR
The ratio of the rms value of either input tone to the rms value
of the peak spurious component. The peak spurious compo-
nent may or may not be an IMD product. May be reported
in dBc (i.e., degrades as signal levels is lowered) or in dBFS
(always related back to converter full scale).
DEFINITION OF SPECIFICATIONS
Analog Bandwidth
The analog input frequency at which the spectral power of the
fundamental frequency (as determined by the FFT analysis) is
reduced by 3 dB.
Aperture Delay
The delay between the 50% point of the rising edge of the
ENCODE command and the instant at which the analog input
is sampled.
Aperture Uncertainty (Jitter)
The sample-to-sample variation in aperture delay.
Differential Nonlinearity
The deviation of any code from an ideal 1 LSB step.
Encode Pulse Width/Duty Cycle
Pulse width high is the minimum amount of time that the
ENCODE pulse should be left in logic “1” state to achieve rated
performance; pulse width low is the minimum time ENCODE
pulse should be left in low state. At a given clock rate, these
specs define an acceptable
Encode
duty cycle.
Harmonic Distortion
The ratio of the rms signal amplitude to the rms value of the
worst harmonic component.
Integral Nonlinearity
The deviation of the transfer function from a reference line
measured in fractions of 1 LSB using a “best straight line” de-
termined by a least square curve fit.
Minimum Conversion Rate
The encode rate at which the SNR of the lowest analog signal
frequency drops by no more than 3 dB below the guaranteed
limit.
Maximum Conversion Rate
The encode rate at which parametric testing is performed.
相關PDF資料 |
PDF描述 |
|---|---|
| AD10677 | 16-Bit, 65 MSPS A/D Converter |
| AD10677BWS | 16-Bit, 65 MSPS A/D Converter |
| AD120 | 3-Level / 258 Outputs TFT LCD Gate Driver |
| AD120T | 3-Level / 258 Outputs TFT LCD Gate Driver |
| AD1380JD | Low Cost 16-Bit Sampling ADC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD10265PCB | 制造商:AD 功能描述:10265 ANALOG DEVICE S8M6A |
| AD102JY | 制造商:Analog Devices 功能描述:IC AMP ISOLATION 102J DIP9 |
| AD103 | 制造商:Microsemi Corporation 功能描述:THYRISTOR SCR 300V 15A 3PIN TO-39 - Bulk |
| AD-103 | 制造商:B&K Precision Corporation 功能描述: |
| AD1036-12FS | 制造商:MPD 制造商全稱:MicroPower Direct, LLC 功能描述:Very Low Cost, 36 - 48W DIN Rail Mount Single Output AC/DC Power Supplies |
發布緊急采購，3分鐘左右您將得到回復。