- 您現在的位置：買賣IC網 > PDF目錄24803 > 935163100551 (NXP SEMICONDUCTORS) ATM/SONET/SDH SUPPORT CIRCUIT, PQFP48 PDF資料下載
參數資料
| 型號： | 935163100551 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 數字傳輸電路 |
| 英文描述： | ATM/SONET/SDH SUPPORT CIRCUIT, PQFP48 |
| 封裝： | 7 X 7 X 1.40 MM, PLASTIC, LQFP-48 |
| 文件頁數： | 8/30頁 |
| 文件大?。?/td> | 179K |
| 代理商： | 935163100551 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
2000 Sep 29
16
Philips Semiconductors
Product specication
SDH/SONET STM16/OC48 main ampliers
OQ2538HP; OQ2538U
Notes
1. No special cooling is required in the application if the total thermal resistance Rth(j-a) is less than 90 K/W.
2. The temperature of the PCB in the vicinity of the IC is taken to be the ambient temperature.
3. The input signal must be AC-coupled to the inputs through a coupling capacitance >22 nF.
4. Vi(p-p) is the input signal on IN and INQ for full output clipping. It is assumed that both inputs carry a complementary
signal of the specified peak-to-peak value. The lower specified limit is usually called the input sensitivity. This value
is defined as a 20% increase in rise and fall times when compared to rise and fall times with a complementary input
signal of 10 mV (p-p) applied to IN and INQ.
5. The DC voltage is fixed internally; only AC-coupling of the input signal is allowed.
6. VIO = V IN V INQ
7. See Section “RF input matching circuit” for detailed information.
8. All signal ports are AC-matched to 50
and are measured at 1 GHz (see Fig.7). Flatness deviations are within ±3dB
9. See Section “RF gain and group delay measurements”.
10. F is the noise figure for a differential application and is measured at 1 GHz. See Section “Noise figure
measurements”.
11. An external 100 nF capacitor is connected at each output to remove any spurious high frequency signals.
Any circuitry driven from these pins must have an input impedance >50 k
.
12. Voltage difference between AGC (LOS) and AGCDC (LOSDC), measured with a differential square wave input
signal of 600 mV (p-p) on IN and INQ.
13. The offset is measured with inputs IN and INQ shorted together.
14. The band gap voltage may not be used as an external reference.
15. Both outputs are connected to ground through a 50
load resistance and carry complementary signals.
16. The output levels are dependent on load impedance. The specified values assume an external load impedance of
50
. If the external 100 matching resistors are connected at pins OUT and OUTQ, the output levels will fall to
75% of the specified values (see also Section “RF gain and group delay measurements”).
Band gap reference decoupling: CAPA
VO
decoupling voltage
referenced to VEE;
open output
2.9
V
Main amplier outputs: OUT and OUTQ; note 15
VOH
HIGH-level output voltage
20
50
mV
VOL
LOW-level output voltage
note 16
280
200
140
mV
tr
differential output rise time
input signal >2.5 mV (p-p)
100
150
ps
tf
input signal >2.5 mV (p-p)
100
150
ps
Zo
single-ended output impedance
see Fig.6
83
100
117
SYMBOL
PARAMETER
CONDITIONS
MIN.
TYP.
MAX.
UNIT
相關PDF資料 |
PDF描述 |
|---|---|
| 0780362001 | COPPER ALLOY, TIN (36) FINISH, WIRE TERMINAL |
| 0781720411 | COPPER NICKEL SILICON, GOLD FINISH, WIRE TERMINAL |
| 935262379551 | 16-BIT, OTPROM, 30 MHz, MICROCONTROLLER, PQFP80 |
| 935262385557 | 16-BIT, 30 MHz, MICROCONTROLLER, PQFP80 |
| 935262383512 | 16-BIT, 30 MHz, MICROCONTROLLER, PQCC68 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 93516-PIX | 制造商:FCI 功能描述: |
| 93517-090001 | 制造商:FCI 功能描述:PCMCIA REV CARD FRAME 9P |
| 93517-150000 | 制造商:FCI 功能描述: |
| 93518097J | 制造商:Fiskars Brands Inc 功能描述:Fiskars 45mm Rotary Blades - Pinking (Fits Models 195800/154570/19680/19583) (Fr |
| 935181002005 | 功能描述:電容套件 HiTmpSilCap Kit 0402 1nF 10nF 33nF BD11V RoHS:否 制造商:Nichicon 電容范圍:10 uF to 680 uF 公差范圍: 電壓范圍:6.3 V to 25 V 產品:Aluminum Organic Polymer Capacitor Kit |
發布緊急采購，3分鐘左右您將得到回復。