- 您現在的位置：買賣IC網 > PDF目錄24803 > 935163100551 (NXP SEMICONDUCTORS) ATM/SONET/SDH SUPPORT CIRCUIT, PQFP48 PDF資料下載
參數資料
| 型號： | 935163100551 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 數字傳輸電路 |
| 英文描述： | ATM/SONET/SDH SUPPORT CIRCUIT, PQFP48 |
| 封裝： | 7 X 7 X 1.40 MM, PLASTIC, LQFP-48 |
| 文件頁數： | 27/30頁 |
| 文件大?。?/td> | 179K |
| 代理商： | 935163100551 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁
2000 Sep 29
6
Philips Semiconductors
Product specication
SDH/SONET STM16/OC48 main ampliers
OQ2538HP; OQ2538U
FUNCTIONAL DESCRIPTION
The OQ2538HP is comprised of four DC-coupled amplifier
stages along with additional circuitry for offset
compensation and level detection.
The first amplifier stage contains a modified
Cherry/Hooper amplifying cell with high gain
(approximately 20 dB) and a wide bandwidth. Special
attention is paid to minimizing the equivalent input noise at
this stage, thus reducing the overall noise level. Additional
feedback is applied at the second and third stages,
improving isolation and reducing the gain to 14 dB per
stage. The last stage is an output buffer, a unity gain
amplifier, with an output impedance of 100
.
The total gain of the OQ2538HP amounts to 48.5 dB, thus
providing a constant CML-compatible output signal over a
wide input signal range.
Two rectifier circuits are used to measure the input signal
level. Two separate RF preamplifiers are used to generate
the voltage gain needed to obtain a suitable rectifier output
voltage. For rectifier A the gain is approximately 18 dB, for
rectifier B it is about 14 dB. The output of rectifier A can be
used for AGC at the preamplifier stage in front of the
OQ2538HP. The output of rectifier B can be used for LOS
detection. There is a linear relationship between the
rectifier output voltage and the input signal level provided
the amplifiers are not saturated.
Because the four gain stages are DC-coupled and provide
a high overall gain, the effect of the input offset can be
considerable. The OQ2538HP features an internal offset
compensation circuit for eliminating the input offset.
The bandwidth of the offset control loop is determined by
an external capacitor.
COFF and COFFQ offset compensation
Automatic offset compensation eliminates the input offset
of the OQ2538HP. This offset cancellation influences the
low frequency gain of the amplifier stages. With a
capacitance of 100 nF between COFF and COFFQ the
loop bandwidth will be less than 1.5 kHz, small enough to
have no influence on amplifier gain over the frequencies of
interest. If the capacitor was omitted, the loop bandwidth
would be greater than 30 MHz, which would influence the
input signal gain. The loop bandwidth can be calculated
from the following formula:
(1)
where Cext is the capacitance connected between COFF
and COFFQ.
f
loop
1
2
π 1250
×
C
ext
×
------------------------------------------------
=
REF and CAPA band gap output and decoupling
capacitance
To reduce band gap noise levels, a 1 nF decoupling
capacitor on CAPA is recommended. Since the band gap
is referenced to the negative power supply, the decoupling
capacitor should be connected between CAPA and VEE.
The band gap voltage is present on pin REF for test
purposes only. It is not intended to serve as an external
reference.
RF input and output connections
Striplines, or microstrips, with an odd mode characteristic
impedance of Zo(odd) =50 must be used for the
differential RF connections on the PCB. This applies to
both the input signal pair IN and INQ and to the output
signal pair OUT and OUTQ. The two lines in each pair
should have the same length.
RF input matching circuit
The input circuit for pins IN and INQ contains internal
100
resistors decoupled to ground via an internal
common mode 6 pF capacitor. The topology is depicted in
Fig.3.
Fig.3 RF input topology.
handbook, halfpage
MGM114
IN
INQ
GND
100
6 pF
100
相關PDF資料 |
PDF描述 |
|---|---|
| 0780362001 | COPPER ALLOY, TIN (36) FINISH, WIRE TERMINAL |
| 0781720411 | COPPER NICKEL SILICON, GOLD FINISH, WIRE TERMINAL |
| 935262379551 | 16-BIT, OTPROM, 30 MHz, MICROCONTROLLER, PQFP80 |
| 935262385557 | 16-BIT, 30 MHz, MICROCONTROLLER, PQFP80 |
| 935262383512 | 16-BIT, 30 MHz, MICROCONTROLLER, PQCC68 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 93516-PIX | 制造商:FCI 功能描述: |
| 93517-090001 | 制造商:FCI 功能描述:PCMCIA REV CARD FRAME 9P |
| 93517-150000 | 制造商:FCI 功能描述: |
| 93518097J | 制造商:Fiskars Brands Inc 功能描述:Fiskars 45mm Rotary Blades - Pinking (Fits Models 195800/154570/19680/19583) (Fr |
| 935181002005 | 功能描述:電容套件 HiTmpSilCap Kit 0402 1nF 10nF 33nF BD11V RoHS:否 制造商:Nichicon 電容范圍:10 uF to 680 uF 公差范圍: 電壓范圍:6.3 V to 25 V 產品:Aluminum Organic Polymer Capacitor Kit |
發布緊急采購，3分鐘左右您將得到回復。