- 您現在的位置：買賣IC網 > PDF目錄24623 > 9248YF-95LF (INTEGRATED DEVICE TECHNOLOGY INC) 124 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 PDF資料下載
參數資料
| 型號： | 9248YF-95LF |
| 廠商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分類： | 時鐘產生/分配 |
| 英文描述： | 124 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
| 封裝： | LEAD FREE ANNEALED, SSOP-48 |
| 文件頁數： | 11/16頁 |
| 文件大小： | 294K |
| 代理商： | 9248YF-95LF |
4
ICS9248-95
310D—04/12/05
1.
The ICS clock generator is a slave/receiver, I
2C component. It can read back the data stored in the latches for
verification. Read-Back will support Intel PIIX4 "Block-Read" protocol.
2.
The data transfer rate supported by this clock generator is 100K bits/sec or less (standard mode)
3.
The input is operating at 3.3V logic levels.
4.
The data byte format is 8 bit bytes.
5.
To simplify the clock generator I
2C interface, the protocol is set to use only "Block-Writes" from the controller. The
bytes must be accessed in sequential order from lowest to highest byte with the ability to stop after any complete byte
has been transferred. The Command code and Byte count shown above must be sent, but the data is ignored for those
two bytes. The data is loaded until a Stop sequence is issued.
6.
At power-on, all registers are set to a default condition, as shown.
General I
2C serial interface information
The information in this section assumes familiarity with I
2C programming.
How to Write:
Controller (host) sends a start bit.
Controller (host) sends the write address D2
(H)
ICS clock will acknowledge
Controller (host) sends a dummy command code
ICS clock will acknowledge
Controller (host) sends a dummy byte count
ICS clock will acknowledge
Controller (host) starts sending first byte (Byte 0)
through byte 5
ICS clock will acknowledge each byte one at a time.
How to Read:
Controller (host) will send start bit.
Controller (host) sends the read address D3
(H)
ICS clock will acknowledge
ICS clock will send the byte count
Controller (host) acknowledges
ICS clock sends first byte (Byte 0) through byte 5
Controller (host) will need to acknowledge each byte
Controller (host) will send a stop bit
Notes:
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D3(H)
ACK
Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Stop Bit
How to Read:
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D2(H)
ACK
Dummy Command Code
ACK
Dummy Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Stop Bit
How to Write:
相關PDF資料 |
PDF描述 |
|---|---|
| 051-928-9019 | RF Coaxial Connectors |
| 9248YG-92GLFT | PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
| 924AB4XM-L2P | PROXIMITY SENSOR-INDUCTIVE, 4.5-9.5mm, 1-9V, CYLINDRICAL |
| 924AB3XM-L2P | PROXIMITY SENSOR-INDUCTIVE, 2-5mm, 1-9V, CYLINDRICAL |
| 9250BF-16LF | 150 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO56 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 9249 | 制造商:Apex Tool Group 功能描述:PUSH ROD FOR 9290 SERIES PNEUMATIC CUTTER |
| 924922-000 | 制造商:TE Connectivity 功能描述:Heat Shrink Flexible Molded Boot ST Polyolefin 制造商:TE Connectivity 功能描述:BOOT FLXBL MOD POLYFN - Bulk 制造商:TE Connectivity 功能描述:BOOT MOLDED |
| 924924-000 | 制造商:TE Connectivity 功能描述:114-WP110X |
| 92495160 | 制造商:Glenair Inc 功能描述:MICRO-D CONNECTORS - Bulk |
| 924961-C | 功能描述:測試引線 Patch Cord Small Pin-Pin RoHS:否 制造商:Pomona Electronics 設備類型:Patch Cords 連接器類型:Banana plug (stackable) on both ends 長度:60 in 顏色:Black |
發布緊急采購，3分鐘左右您將得到回復。