參數資料
型號: 90E32ERGI
廠商: INTEGRATED DEVICE TECHNOLOGY INC
元件分類: 模擬信號調理
英文描述: SPECIALTY ANALOG CIRCUIT, PQFP48
封裝: TQFP-48
文件頁數: 65/67頁
文件大?。?/td> 777K
代理商: 90E32ERGI
7
August 24, 2011
90E32
Preliminary Information*
2011 Integrated Device Technology, Inc.
*Notice: The information in this document is subject to change without notice
Poly-Phase High-Performance
Wide-Span Energy Metering IC
IDT and the IDT logo are trademarks of Integrated Device Technology, Inc.
FEATURES
Metering Features
Metering features fully in compliance with the requirements of
IEC62052-11, IEC62053-22 and IEC62053-23, ANSI C12.1 and
ANSI C12.20; applicable in class 0.5S or class 1 poly-phase
watt-hour meter or class 2 poly-phase var-hour meter.
Accuracy of ±0.1% for active energy and ±0.2% for reactive
energy over a dynamic range of 5000:1.
Temperature coefficient is 6 ppm/ ℃ (typical) for on-chip refer-
ence voltage.
Single-point calibration on each phase over the whole dynamic
range for active energy; no calibration needed for reactive/
apparent energy.
±1 ℃ (typical) temperature sensor accuracy.
Electrical parameters measurement: less than ±0.5% fiducial
error for Vrms, Irms, mean active/ reactive/ apparent power, fre-
quency, power factor and phase angle.
Active (forward/reverse), reactive (forward/reverse), apparent
energy with independent energy registers. Active/ reactive/
apparent energy can be output by pulse or read through energy
registers to adapt to different applications.
Programmable startup and no-load power threshold, special
designed of startup and no-load circuits to eliminate crosstalk
among phases achieving better accuracy especially at low
power conditions.
Dedicated ADC and different gains for phase A/B/C current sam-
pling circuits. Current sampled over current transformer (CT) or
Rogowski coil (di/dt coil); phase A/B/C voltage sampled over
resistor divider network or potential transformer (PT).
Programmable power modes: Normal mode (N mode), Idle
mode (I mode), Detection mode (D mode) and Partial Measure-
ment mode (M mode).
Fundamental (CF3, 0.2%) and harmonic (CF4, 1%) active
energy with dedicated energy and power registers.
Event detection: sag, phase loss, reverse voltage/ current phase
sequence, reverse flow, calculated neutral line current INC over-
current and THD+N over-threshold.
Other Features
3.3V single power supply. Operating voltage range: 2.8V~3.6V.
Metering accuracy guaranteed within 3.0V~3.6V.
Four-wire SPI interface.
Parameter diagnosis function and programmable interrupt output
of the IRQ interrupt signals and the WarnOut signal.
Programmable voltage sag detection and zero-crossing output.
CF1/CF2/CF3/CF4 output active/ reactive/ apparent energy
pulses and fundamental/ harmonic energy pulses respectively.
Crystal oscillator frequency: 16.384 MHz. On-chip two capacitors
and no need of external capacitors.
TQFP48 package.
Operating temperature: -40 ℃ ~ +85 ℃ .
APPLICATION
Poly-phase energy meters of class 0.5S and class 1 which are
used in three-phase four-wire (3P4W, Y0) or three-phase three-
wire (3P3W, Y or ) systems.
Power monitoring instruments which need to measure voltage,
current, mean power, etc.
GENERAL DESCRIPTION
The 90E32 is a poly-phase high performance wide-dynamic range
metering IC. The 90E32 incorporates 6 independent 2nd order sigma-
delta ADCs, which could be employed in three voltage channels (phase
A, B and C) and three current channels (phase A, B, C) in a typical
three-phase four-wire system.
The 90E32 has an embedded DSP which executes calculation of
active energy, reactive energy, apparent energy, fundamental and har-
monic active energy over ADC signal and on-chip reference voltage.
The DSP also calculates measurement parameters such as voltage and
current RMS value as well as mean active/reactive/apparent power.
A four-wire SPI interface is provided between the 90E32 and the
external microcontroller.
The 90E32 is suitable for poly-phase multi-function meters which
could measure active/reactive/apparent energy and fundamental/har-
monic energy either through four independent energy pulse outputs
CF1/CF2/CF3/CF4 or through the corresponding registers.
IDT's proprietary ADC and auto-temperature compensation technol-
ogy for reference voltage ensure the 90E32's long-term stability over
variations in grid and ambient environment conditions.
相關PDF資料
PDF描述
90E36ERGI SPECIALTY ANALOG CIRCUIT, PQFP48
90MMCX-S50-0-51/111 MMCX CONNECTOR, JACK
91-21SUBC/S400-A6/TR10 T-3/4 SINGLE COLOR LED, BLUE, 1.9 mm
91-21SURC/S530-A3/TR7 T-3/4 SINGLE COLOR LED, BRILLIANT RED, 1.9 mm
91-21SURC/S530-A3/TR9 T-3/4 SINGLE COLOR LED, BRILLIANT RED, 1.9 mm
相關代理商/技術參數
參數描述
90E32ERGI8 功能描述:電流和電力監控器、調節器 RoHS:否 制造商:STMicroelectronics 產品:Current Regulators 電源電壓-最大:48 V 電源電壓-最小:5.5 V 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:HPSO-8 封裝:Reel
90E36 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:Poly-Phase High-Performance Wide-Span Energy Metering IC
90E36AERGI 功能描述:電流和電力監控器、調節器 RoHS:否 制造商:STMicroelectronics 產品:Current Regulators 電源電壓-最大:48 V 電源電壓-最小:5.5 V 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:HPSO-8 封裝:Reel
90E36AERGI8 功能描述:電流和電力監控器、調節器 RoHS:否 制造商:STMicroelectronics 產品:Current Regulators 電源電壓-最大:48 V 電源電壓-最小:5.5 V 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:HPSO-8 封裝:Reel
90E36ERGI 功能描述:電流和電力監控器、調節器 RoHS:否 制造商:STMicroelectronics 產品:Current Regulators 電源電壓-最大:48 V 電源電壓-最小:5.5 V 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:HPSO-8 封裝:Reel