- 您現在的位置：買賣IC網 > PDF目錄1887 > 73S1217F-68MR/F/PE (Maxim Integrated Products)IC SOC SMART CARD READER 68QFN PDF資料下載
參數資料
| 型號： | 73S1217F-68MR/F/PE |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 62/140頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC SOC SMART CARD READER 68QFN |
| 標準包裝： | 2,500 |
| 系列： | * |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁當前第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁
73S1217F Data Sheet
DS_1217F_002
acknowledge this request by setting the SCPWRDN bit in the Smart Card VCC Control/Status Register
(VccCtl) high after it has completed all shutdown activities. When SCPWRDN is set high, the circuit will
deactivate the smart card interface if required and turn off all analog functions and the VDD supply for the
logic and companion circuits. The default state upon application of power is the “OFF” state unless
power is supplied to the VBUS supply. Note that at any time, the firmware may assert SCPWRDN and the
73S1217F will go into the “OFF” state (when VBUS is not present). If the OFF switch function is not
desired and the application does not need to shut down power on VDD, the ON_OFF input can be
permanently grounded which will automatically turn on VDD when power is supplied on any of the VPC,
VBAT or VBUS power supply inputs.
If power is applied to both VBAT and VBUS, the circuit will automatically consume power from only the VBUS
source. The 73S1217F will be unconditionally “ON” when VBUS is applied. If the VBUS source is removed,
the 73S1217F will switchover to the VBAT input supply and remain in the “ON” state. The firmware
should assert SCPWRDN based on no activity or VBUS removal to reduce battery power consumption.
When operating from VBUS, and not calling for VCC, the step-up converter becomes a simple switch
connecting VBUS to VP in order to save power. This condition is appropriate for the USB “SUSPEND”
state. The USB “SUSPEND” state requires the power supply current to be less than 500uA. In order to
obtain and meet this low current limitation, the firmware must configure the 73S1217F into a power-down
condition using less than 20uA from VDD.
Note: When the ON_OFF switch function is not needed, i.e. when the 73S1217F must be in an always-
ON state when using another supply than VBUS (VPC or VBAT), some external discrete components are
needed.
1.7.4 Power Control Modes
The 73S1217F contains circuitry to disable portions of the device and place it into a lower power standby
mode or power down the 73S1217F into its “OFF” mode. The standby mode will stop the core, clock
subsystem and the peripherals connected to it. This is accomplished by either shutting off the power or
disabling the clock going to the block. The miscellaneous control registers MISCtl0, MISCtl1 and the
Master Clock Control register (MCLKCtl) provide control over the power modes. The PWRDN bit in
MISCtl0 will set up the 73S1217F for either standby or “OFF” modes. Depending on the state of the
ON/OFF circuitry and power applied to the VBUS input, the 73S1217F will go into either standby mode or
power “OFF” mode. If system power is provided by, VBUS or the ON/OFF circuitry is in the “ON” state,
the MPU core will placed into standby mode. If the VBUS input is not sourcing power and the ON/OFF
circuitry is in the “OFF” state, setting the PWRDN bit will shut down the converter and VP will turn off.
This in turn will turn off the VDD supply and the 73S1217F will be turned “OFF”. The power down modes
should only be initiated by setting the PWRDN bit in the MISCtl0 register and not by manipulating
individual control bits in various registers. Figure 6 shows how the PWRDN bit controls the various
functions that comprise power down state
28
Rev. 1.2
相關PDF資料 |
PDF描述 |
|---|---|
| 73S8010C-ILR/F | IC SMART CARD INTERFACE 28-SOIC |
| 73S8010R-ILR/F | IC SMART CARD INTERFACE 28-SOIC |
| 73S8014R-IL/F | IC SMART CARD 7816 EMV 20-SOIC |
| 73S8014RN-ILR/F | IC SMART CARD 7816 EMV 20-SOIC |
| 73S8023C-IMR/F | IC SMART CARD INTERFACE 32-QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 73S1217F-EB | 功能描述:開發板和工具包 - 8051 73S1217F Eval Brd (Usb Cable, Doc. Cd) RoHS:否 制造商:Silicon Labs 產品:Development Kits 工具用于評估:C8051F960, Si7005 核心: 接口類型:USB 工作電源電壓: |
| 73S1217F-EB-Lite | 功能描述:開發板和工具包 - 8051 73S1217F EVB Lite w/Plug & Play/Usb RoHS:否 制造商:Silicon Labs 產品:Development Kits 工具用于評估:C8051F960, Si7005 核心: 接口類型:USB 工作電源電壓: |
| 73S1217F-IMR/F | 制造商:TERIDIAN 制造商全稱:TERIDIAN 功能描述:Bus-Powered 80515 System-on-Chip with USB, ISO 7816 / EMV, PINpad and More |
| 73S13B | 制造商:QUARTZCOM 制造商全稱:QUARTZCOM the communications company 功能描述:-20 ~ +70 °C commercia l application -30 ~ +75 °C on request |
| 73S5040G01X0A | 制造商:NEX Computers 功能描述:INTEL 40GB SSD - Bulk |
發布緊急采購，3分鐘左右您將得到回復。