- 您現在的位置：買賣IC網 > PDF目錄376463 > XRT83SH38_0609 (Exar Corporation) 8-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT PDF資料下載
參數資料
| 型號： | XRT83SH38_0609 |
| 廠商： | Exar Corporation |
| 英文描述： | 8-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT |
| 中文描述： | 8通道的T1/E1/J1短途線路接口單元 |
| 文件頁數： | 44/78頁 |
| 文件大?。?/td> | 606K |
| 代理商： | XRT83SH38_0609 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁當前第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁
XRT83SH38
41
8-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT
REV. 1.0.7
6.0
MICROPROCESSOR INTERFACE
The microprocessor interface can be accessed through a standard serial interface (BGA Package Only) or a
standard parallel microprocessor interface. The SER_PAR pin is used to select between the two. By default,
the chip is configured in the Parallel Microprocessor interace. For Serial communication, this pin must be
pulled “High”.
6.1
Serial Microprocessor Interface Block
The serial microprocessor uses a standard 3-pin serial port with CS, SCLK, and SDI for programming the LIU.
Optional pins such as SDO, INT, and RESET allow the ability to read back contents of the registers, monitor
the LIU via an interrupt pin, and reset the LIU to its default configuration by pulling reset "Low" for more than
10
μ
S. A simplified block diagram of the Serial Microprocessor is shown in
Figure 32
.
6.1.1
Serial Timing Information
The serial port requires 24 bits of data applied to the SDI (Serial Data Input) pin. The Serial Microprocessor
samples SDI on the rising edge of SCLK (Serial Clock Input). The data is not latched into the device until all 24
bits of serial data have been sampled. A timing diagram of the Serial Microprocessor is shown in
Figure 33
.
N
OTE
:
For applications without a free running SCLK, a minimum of 1 SCLK pulse must be applied when CS is “High”,
befrore pulling CS “Low”.
F
IGURE
32. S
IMPLIFIED
B
LOCK
D
IAGRAM
OF
THE
S
ERIAL
M
ICROPROCESSOR
I
NTERFACE
F
IGURE
33. T
IMING
D
IAGRAM
FOR
THE
S
ERIAL
M
ICROPROCESSOR
I
NTERFACE
Serial
Microprocessor
Interface
CS
SDI
SCLK
SDO
RESET
INT
HW/Host
SER_PAR
R/W
ADDR[0] - ADDR[7]
Don't Care
DATA[0] - DATA[7]
CS
SDI
SCLK
8-Bit Address
8-Bit Data
7-Bit Don't Care
1=Read
0=Write
SDO
DATA[0] - DATA[7]
Readback
相關PDF資料 |
PDF描述 |
|---|---|
| XRT83SH38IB | 8-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT83SL216 | 16-CHANNEL E1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT83SL216_06 | 16-CHANNEL E1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT83SL216IB | 16-CHANNEL E1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT83SL28 | 8-CHANNEL E1 SHORT-HAUL LINE INTERFACE UNIT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT83SH38ES | 功能描述:外圍驅動器與原件 - PCI 8 CHT1/E1LIUSH RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT83SH38IB | 功能描述:外圍驅動器與原件 - PCI RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT83SH38IB-F | 功能描述:外圍驅動器與原件 - PCI RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT83SL216 | 制造商:EXAR 制造商全稱:EXAR 功能描述:16-CHANNEL E1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT83SL216_06 | 制造商:EXAR 制造商全稱:EXAR 功能描述:16-CHANNEL E1 SHORT-HAUL LINE INTERFACE UNIT |
發布緊急采購，3分鐘左右您將得到回復。