![](http://datasheet.mmic.net.cn/Exar-Corporation/XRT83SH314IB-F_datasheet_100154/XRT83SH314IB-F_66.png)
XRT83SH314
62
14-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT
REV. 1.0.4
TABLE 17: MOTOROLA MODE: MICROPROCESSOR INTERFACE SIGNALS
XRT83SH314S
PIN NAME
MOTOROLA
EQUIVALENT PIN
TYPE
DESCRIPTION
ALE_TS
TS
I
Transfer Start:
This active high signal is used to latch the contents on the
address bus ADDR[7:0]. The contents of the address bus are latched into the
ADDR[7:0] inputs on the falling edge of TS.
WR_R/W
R/W
I
Read/Write:
This input pin from the local
P is used to inform the LIU
whether a Read or Write operation has been requested. When this pin is
pulled “High”, WE will initiate a read operation. When this pin is pulled
“Low”, WE will initiate a write operation.
RD_WE
WE
I
Write Enable:
This active low input functions as the read or write signal from the
local
P dependent on the state of R/W. When WE is pulled “Low” (If CS
is “Low”) the LIU begins the read or write operation.
No Pin
OE
I
Output Enable:
This signal is not necessary for the XRT83SH314S to interface
to the MPC8260 or MPC860 Power PCs.
PCLK
CLKOUT
I
Synchronous Processor Clock:
This signal is used as the timing reference for
the Power PC synchronous mode.
RDY_TA
TA
O
Transfer Acknowledge:
This active low signal is provided by the LIU device. It
indicates that the current read or write cycle is complete, and the LIU is waiting
for the next command.