參數資料
型號: XR19L200IL32-F
廠商: Exar Corporation
文件頁數: 5/40頁
文件大小: 0K
描述: IC UART/TXRX RS232 32QFN
標準包裝: 490
特點: *
通道數: 1,UART
FIFO's: 16 字節
規程: RS232
電源電壓: 3 V ~ 5.5 V
帶自動流量控制功能:
帶IrDA 編碼器/解碼器:
帶故障啟動位檢測功能:
帶調制解調器控制功能:
安裝類型: 表面貼裝
封裝/外殼: 32-VFQFN 裸露焊盤
供應商設備封裝: 32-QFN 裸露焊盤(5x5)
包裝: 托盤
XR19L200
13
REV. 1.0.2
SINGLE CHANNEL INTEGRATED UART AND RS-232 TRANSCEIVER
2.14.1.2
UART active, charge pump of RS-232 transceiver shut down
If the ACP pin is HIGH and the UART portion of the L200 is not in sleep mode, then the charge pump will
automatically shut down to conserve power if the following conditions are true:
no activity on the TXD output signals
RXD input signal has been idling LOW for approximately 30 seconds
When these conditions are satisfied, the L200 shuts down the charge pump and tri-states the RS-232 drivers
to conserve power. In this mode, the RS-232 receivers are fully active and the internal registers of the L200
can be accessed. The time for the charge pump to resume normal operation after exiting the sleep mode is
typically 45
s. It will wake up by any of the following:
a receive data start bit transition on the RXD input (LOW to HIGH)
a data byte is loaded to the transmitter, THR or FIFO
Because the receivers are fully active when the charge pump is turned off, any data received will be transferred
to/from the UART without any issues.
2.14.2
Full Sleep Mode
In full sleep mode, the L210 shuts down the charge pump and the internal oscillator. The L210 enters the full
sleep mode if the following conditions are satisfied:
the UART portion of the L210 is already in sleep mode (no output on XTAL2)
the ACP (Autosleep for Charge Pump) pin is HIGH
When these conditions are satisfied, both the UART and the charge pump will be in the sleep mode. In this
mode, the RS-232 receivers are fully active and the internal registers of the L200 can be accessed. The L200
exits the full sleep mode if either the ACP pin becomes LOW or the internal oscillator starts up. The time for the
charge pump to resume normal operation after exiting the full sleep mode is typically 45
s.
相關PDF資料
PDF描述
XR19L202IL48-F IC UART/TXRX RS232 48QFN
XR19L210IL40-F IC UART/TXRX RS232 40QFN
XR19L212IL48-F IC UART/TXRX RS232 48QFN
XR19L220IL40-F IC UART/TXRX RS232 40QFN
XR19L222IL64-F IC UART/TXRX RS232 64QFN
相關代理商/技術參數
參數描述
XR19L202 制造商:EXAR 制造商全稱:EXAR 功能描述:TWO CHANNEL INTEGRATED UART AND RS-232 TRANSCEIVER
XR19L202IL48 制造商:EXAR 制造商全稱:EXAR 功能描述:TWO CHANNEL INTEGRATED UART AND RS-232 TRANSCEIVER
XR19L202IL48-0B-EB 功能描述:界面開發工具 Supports L202 48 pin QFN,PCI Interface RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
XR19L202IL48-F 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR19L210 制造商:EXAR 制造商全稱:EXAR 功能描述:SINGLE CHANNEL INTEGRATED UART AND RS-232 TRANSCEIVER