- 您現在的位置：買賣IC網 > PDF目錄376455 > XR17D158IV (EXAR CORP) UNIVERSAL (3.3V AND 5V) PCI BUS OCTAL UART PDF資料下載
參數資料
| 型號： | XR17D158IV |
| 廠商： | EXAR CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | UNIVERSAL (3.3V AND 5V) PCI BUS OCTAL UART |
| 中文描述： | 8 CHANNEL(S), 6.25M bps, SERIAL COMM CONTROLLER, PQFP144 |
| 封裝： | 20 X 20 MM, 1.40 MM HEIGHT, TQFP-144 |
| 文件頁數： | 43/72頁 |
| 文件大?。?/td> | 1520K |
| 代理商： | XR17D158IV |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁當前第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁
xr
REV. 1.2.1
UNIVERSAL (3.3V AND 5V) PCI BUS OCTAL UART
XR17D158
43
FCR[2]: TX FIFO Reset
This bit is only active when FCR bit-0 is active.
Logic 0 = No transmit FIFO reset (default).
Logic 1 = Reset the transmit FIFO pointers and FIFO level counter logic (the transmit shift register is not
cleared or altered). This bit will return to a logic 0 after resetting the FIFO.
FCR[3]: DMA Mode Select
This bit has no effect since TXRDY and RXRDY pins are not available in this device. It is provided for legacy
software. DMA is a legacy term used for block transfer mode. DMA does not stand for "Direct Memory Ac-
cess."
Logic 0 = Set DMA to mode 0 (default).
Logic 1 = Set DMA to mode 1.
FCR[5:4]: Transmit FIFO Trigger Select
(logic 0 = default, TX trigger level = 1)
The FCTR bits 6-7 are associated with these 2 bits by selecting one of the four tables. The 4 user selectable
trigger levels in 4 tables are supported for compatibility reasons. These 2 bits set the trigger level for the
transmit FIFO interrupt. The UART will issue a transmit interrupt when the number of characters in the FIFO
falls below the selected trigger level, or when it gets empty in case that the FIFO did not get filled over the
trigger level on last re-load.
Table 15
below shows the selections. EFR bit-4 must be set to ‘1’ before these
bits can be accessed. Note that the receiver and the transmitter cannot use different trigger tables. Whichever
selection is made last applies to both the RX and TX side.
相關PDF資料 |
PDF描述 |
|---|---|
| XR17D158 | UNIVERSAL (3.3V AND 5V) PCI BUS OCTAL UART |
| XR17D158CV | UNIVERSAL (3.3V AND 5V) PCI BUS OCTAL UART |
| XR17L152IM | CAP .068UF 400V PEN FILM 2825 5% |
| XR17L152 | 3.3V PCI BUS DUAL UART |
| XR17L152CM | 3.3V PCI BUS DUAL UART |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XR17D158IV-F | 功能描述:UART 接口集成電路 3.3V-5V 64B FIFO temp -45 to 85C;UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| XR17D158IVTR-F | 制造商:Exar Corporation 功能描述:UART 8-CH 64Byte FIFO 5V 144-Pin LQFP T/R 制造商:Exar Corporation 功能描述:XR17D158IVTR-F |
| XR17L152 | 制造商:EXAR 制造商全稱:EXAR 功能描述:3.3V PCI BUS DUAL UART |
| XR17L152CM | 制造商:EXAR 制造商全稱:EXAR 功能描述:3.3V PCI BUS DUAL UART |
| XR17L152IM | 制造商:EXAR 制造商全稱:EXAR 功能描述:3.3V PCI BUS DUAL UART |
發布緊急采購，3分鐘左右您將得到回復。