REV. 1.0.3 HIGH PERFORMANCE DUART WITH 16-BYTE FIFO 4.11 Baud Rate Generator Registers (DLL, DLM and DLD) - Read/Write
參數資料
型號: XR16V2550IM-0B-EB
廠商: Exar Corporation
文件頁數: 27/46頁
文件大?。?/td> 0K
描述: EVAL BOARD FOR V2550 48TQFP
標準包裝: 1
系列: *
XR16V2550
33
REV. 1.0.3
HIGH PERFORMANCE DUART WITH 16-BYTE FIFO
4.11
Baud Rate Generator Registers (DLL, DLM and DLD) - Read/Write
These registers make-up the value of the baud rate divisor. The concatenation of the contents of DLM and DLL
is a 16-bit value. Then the value is added to DLD[3:0]/16 to achieve the fractional baud rate divisor. DLD must
be enabled via EFR bit-4 before it can be accessed. See Table 13 below and “Section 2.10, Programmable
DLD[5:4]: Sampling Rate Select
These bits select the data sampling rate. By default, the data sampling rate is 16X. The maximum data rate will
double if the 8X mode is selected and will quadruple if the 4X mode is selected. See Table 13 below.
TABLE 13: SAMPLING RATE SELECT
SAMPLING RATE
0
16X
0
1
8X
1
X
4X
DLD[7:6]: Reserved
4.12
Device Identification Register (DVID) - Read Only
This register contains the device ID (0x02 for XR16V2550). Prior to reading this register, DLL and DLM should
be set to 0x00 (DLD = 0xXX).
4.13
Device Revision Register (DREV) - Read Only
This register contains the device revision information. For example, 0x01 means revision A. Prior to reading
this register, DLL and DLM should be set to 0x00 (DLD = 0xXX).
4.14
Enhanced Feature Register (EFR)
Enhanced features are enabled or disabled using this register. Bit 0-3 provide single or dual consecutive
character software flow control selection (see Table 14). When the Xon1 and Xon2 and Xoff1 and Xoff2 modes
are selected, the double 8-bit words are concatenated into two sequential characters. Caution: note that
whenever changing the TX or RX flow control bits, always reset all bits back to logic 0 (disable) before
programming a new setting.
EFR[3:0]: Software Flow Control Select
Single character and dual sequential characters software flow control is supported. Combinations of software
flow control can be selected by programming these bits.
DLD[5]
DLD[4]
相關PDF資料
PDF描述
GCA22DCBH CONN EDGECARD 44POS R/A .125 SLD
GEM36DTBH CONN EDGECARD 72POS R/A .156 SLD
GCA22DCBD CONN EDGECARD 44POS R/A .125 SLD
GEM36DTBD CONN EDGECARD 72POS R/A .156 SLD
UPJ1J560MPD6TD CAP ALUM 56UF 63V 20% RADIAL
相關代理商/技術參數
參數描述
XR16V2550IM-F 功能描述:UART 接口集成電路 2.5V-3.6V 16B FIFO temp -45 to 85C;UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR16V2550IMTR-F 制造商:Exar Corporation 功能描述:UART 2-CH 16Byte FIFO 2.5V/3.3V 48-Pin TQFP T/R 制造商:Exar Corporation 功能描述:XR16V2550IMTR-F
XR16V2551 制造商:EXAR 制造商全稱:EXAR 功能描述:HIGH PERFORMANCE DUART WITH 16-BYTE FIFO AND POWERSAVE FEATURE
XR16V2551_07 制造商:EXAR 制造商全稱:EXAR 功能描述:HIGH PERFORMANCE DUART WITH 16-BYTE FIFO AND POWERSAVE FEATURE
XR16V2551IL 制造商:Rochester Electronics LLC 功能描述: 制造商:Exar Corporation 功能描述: