參數資料
型號: XC164TM
廠商: INFINEON TECHNOLOGIES AG
英文描述: 16-Bit Single-Chip Microcontroller with C166SV2 Core
中文描述: 16位單片機與C166SV2核心
文件頁數: 58/65頁
文件大?。?/td> 587K
代理商: XC164TM
XC164TM
Derivatives
Electrical Parameters
Data Sheet
56
V1.0, 2005-11
The used mechanism to generate the master clock is selected by register PLLCON.
CPU and EBC are clocked with the CPU clock signal f
CPU
. The CPU clock can have the
same frequency as the master clock (
f
CPU
=
f
MC
) or can be the master clock divided by
two:
f
CPU
=
f
MC
/ 2. This factor is selected by bit CPSYS in register SYSCON1.
The specification of the external timing (AC Characteristics) depends on the period of the
CPU clock, called “TCP”.
The other peripherals are supplied with the system clock signal
f
SYS
which has the same
frequency as the CPU clock signal
f
CPU
.
Bypass Operation
When bypass operation is configured (PLLCTRL = 0x
B
) the master clock is derived from
the internal oscillator (input clock signal XTAL1) through the input- and output-
prescalers:
f
MC
=
f
OSC
/ ((PLLIDIV+1)
×
(PLLODIV+1)).
If both divider factors are selected as ‘1’ (PLLIDIV = PLLODIV = ‘0’) the frequency of
f
MC
directly follows the frequency of
f
OSC
so the high and low time of
f
MC
is defined by the duty
cycle of the input clock
f
OSC
.
The lowest master clock frequency is achieved by selecting the maximum values for both
divider factors:
f
MC
=
f
OSC
/ ((3 + 1)
×
(14 + 1)) =
f
OSC
/ 60.
Phase Locked Loop (PLL)
When PLL operation is configured (PLLCTRL = 11
B
) the on-chip phase locked loop is
enabled and provides the master clock. The PLL multiplies the input frequency by the
factor
F
(
f
MC
=
f
OSC
×
F
) which results from the input divider, the multiplication factor, and
the output divider (
F
= PLLMUL+1 / (PLLIDIV+1
×
PLLODIV+1)). The PLL circuit
synchronizes the master clock to the input clock. This synchronization is done smoothly,
i.e. the master clock frequency does not change abruptly.
Due to this adaptation to the input clock the frequency of
f
MC
is constantly adjusted so it
is locked to
f
OSC
. The slight variation causes a jitter of
f
MC
which also affects the duration
of individual TCMs.
The timing listed in the AC Characteristics refers to TCPs. Because
f
CPU
is derived from
f
MC
, the timing must be calculated using the minimum TCP possible under the respective
circumstances.
The actual minimum value for TCP depends on the jitter of the PLL. As the PLL is
constantly adjusting its output frequency so it corresponds to the applied input frequency
(crystal or oscillator) the relative deviation for periods of more than one TCP is lower than
for one single TCP (see formula and
Figure 4-6
).
相關PDF資料
PDF描述
XC167CI-16F 16-Bit Single-Chip Microcontroller with C166SV2 Core
XC167CI 16-Bit Single-Chip Microcontroller Preliminary
XC167CS-32F 16-Bit Single-Chip Microcontroller with C166SV2 Core
XC866 8-bit Microcontroller with 2/4/8K Bytes In-System Programmable Flash
XC866-2FR 8-bit Microcontroller with 2/4/8K Bytes In-System Programmable Flash
相關代理商/技術參數
參數描述
XC164TM8F40FAAFXQMA1 制造商:Infineon Technologies AG 功能描述:IC MCU 16BIT 64KB TQFP-64-8
XC166EASYKIT 制造商:Infineon Technologies AG 功能描述:
XC167-16 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16-Bit Single-Chip Microcontroller with C166SV2 Core Volume 2 (of 2): Peripheral Units
XC167CI 制造商:Infineon Technologies AG 功能描述:
XC167CI_02 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16-Bi t Single-Chip Microcontroller Preliminary