- 您現在的位置：買賣IC網 > PDF目錄358597 > X9312WP 10K DIGITAL POTENTIOMETER, INCREMENT/DECREMENT CONTROL INTERFACE, 100 POSITIONS, PDIP8 PDF資料下載
參數資料
| 型號： | X9312WP |
| 元件分類： | 數字電位計 |
| 英文描述： | 10K DIGITAL POTENTIOMETER, INCREMENT/DECREMENT CONTROL INTERFACE, 100 POSITIONS, PDIP8 |
| 封裝： | PLASTIC, DIP-8 |
| 文件頁數： | 3/9頁 |
| 文件大?。?/td> | 468K |
| 代理商： | X9312WP |
ObsoeePoduc
X9312
Characteristics subject to change without notice.
3 of 9
REV 1.1.3 8/20/02
www.xicor.com
INSTRUCTIONS AND PROGRAMMING
The INC, U/D and CS inputs control the movement of
the wiper along the resistor array. With CS set LOW
the device is selected and enabled to respond to the
U/D and INC inputs. HIGH to LOW transitions on INC
will increment or decrement (depending on the state of
the U/D input) a seven bit counter. The output of this
counter is decoded to select one of one hundred wiper
positions along the resistive array.
The value of the counter is stored in nonvolatile
memory whenever CS transitions HIGH while the INC
input is also HIGH.
The system may select the X9312, move the wiper
and deselect the device without having to store the
latest wiper position in nonvolatile memory. After the
wiper movement is performed as described above and
once the new position is reached, the system must
keep INC LOW while taking CS HIGH. The new wiper
position will be maintained until changed by the
system or until a powerup/down cycle recalled the
previously stored data.
This procedure allows the system to always power-up
to a preset value stored in nonvolatile memory; then
during system operation minor adjustments could be
made. The adjustments might be based on user
preference, system parameter changes due to
temperature drift, etc...
The state of U/D may be changed while CS remains
LOW. This allows the host system to enable the device
and then move the wiper up and down until the proper
trim is attained.
MODE SELECTION
SYMBOL TABLE
CS
L
INC
U/D
L
X
X
X
Mode
Wiper down
Store wiper position
Standby current
No store, return to standby
H
X
L
H
WAVEFORM
INPUTS
OUTPUTS
Must be
steady
Will be
steady
May change
from Low to
High
May change
from High to
Low
Will change
from Low to
High
Will change
from High to
Low
Don’t Care:
Changes
Allowed
N/A
Changing:
State Not
Known
Center Line
is High
Impedance
相關PDF資料 |
PDF描述 |
|---|---|
| X9313USI3 | 50K DIGITAL POTENTIOMETER, INCREMENT/DECREMENT CONTROL INTERFACE, 32 POSITIONS, PDSO8 |
| XAC | 9 CONTACT(S), MALE, MULTIWAY RACK AND PANEL CONN, PLUG |
| XADR-20V | 20 CONTACT(S), FEMALE, TWO PART BOARD CONNECTOR, CRIMP, RECEPTACLE |
| XADR-22V | 22 CONTACT(S), FEMALE, TWO PART BOARD CONNECTOR, CRIMP, RECEPTACLE |
| XADR-24V | 24 CONTACT(S), FEMALE, TWO PART BOARD CONNECTOR, CRIMP, RECEPTACLE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| X9312WPI | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Terminal Voltage 0V to + 15V, 100 Taps |
| X9312WPM | 制造商:XICOR 制造商全稱:Xicor Inc. 功能描述:E2POT⑩ Nonvolatile Digital Potentiometer |
| X9312WS | 制造商:Intersil Corporation 功能描述: 制造商:XICON 功能描述: 制造商:Xicon Passive Components 功能描述: |
| X9312WSI | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Terminal Voltage 0V to + 15V, 100 Taps |
| X9312WSM | 制造商:XICOR 制造商全稱:Xicor Inc. 功能描述:E2POT⑩ Nonvolatile Digital Potentiometer |
發布緊急采購，3分鐘左右您將得到回復。