- 您現在的位置：買賣IC網 > PDF目錄358597 > X9312WP 10K DIGITAL POTENTIOMETER, INCREMENT/DECREMENT CONTROL INTERFACE, 100 POSITIONS, PDIP8 PDF資料下載
參數資料
| 型號： | X9312WP |
| 元件分類： | 數字電位計 |
| 英文描述： | 10K DIGITAL POTENTIOMETER, INCREMENT/DECREMENT CONTROL INTERFACE, 100 POSITIONS, PDIP8 |
| 封裝： | PLASTIC, DIP-8 |
| 文件頁數： | 2/9頁 |
| 文件大?。?/td> | 468K |
| 代理商： | X9312WP |
ObsoeePoduc
4
5
X9312
Characteristics subject to change without notice.
2 of 9
REV 1.1.3 8/20/02
www.xicor.com
PIN DESCRIPTIONS
R
The high (R
X9312 are equivalent to the fixed terminals of a
mechanical potentiometer. The minimum voltage is 0V
and the maximum is +15V. The terminology of R
and R
H
/V
H
references the relative position of the
terminal in relation to wiper movement direction
selected by the U/D input and not the voltage potential
on the terminal.
H
/V
H
and R
L
/V
/V
L
) and low (R
/V
) terminals of the
L
/V
L
R
R
movable terminal of a mechanical potentiometer. The
position of the wiper within the array is determined by
the control inputs. The wiper terminal series resistance
is typically 40
.
W
w
/V
/V
W
w
is the wiper terminal and is equivalent to the
Up/Down (U/D)
The U/D input controls the direction of the wiper
movement and whether the counter is incriminated or
decremented.
Increment (INC)
The INC input is negative-edge triggered. Toggling
INC will move the wiper and either increment or
decrement the counter in the direction indicated by the
logic level on the U/D input.
Chip Select (CS)
The device is selected when the CS input is LOW. The
current counter value is stored in nonvolatile memory
when CS is returned HIGH while the INC input is also
HIGH. After the store operation is complete the X9312
will be placed in the low power standby mode until the
device is selected once again.
PIN CONFIGURATION
PIN NAMES
PRINCIPLES OF OPERATION
There are three sections of the X9312: the input
control, counter and decode section; the nonvolatile
memory; and the resistor array. The input control
section operates just like an up/down counter. The
output of this counter is decoded to turn on a single
electronic switch connecting a point on the resistor
array to the wiper output. Under the proper conditions
the contents of the counter can be stored in nonvolatile
memory and retained for future use. The resistor array
is comprised of 99 individual resistors connected in
series. At either end of the array and between each
resistor is an electronic switch that transfers the
potential at that point to the wiper.
The wiper, when at either fixed terminal, acts like its
mechanical equivalent and does not move beyond the
last position. That is, the counter does not wrap
around when clocked to either extreme.
The electronic switches on the device operate in a
“make before break” mode when the wiper changes
tap positions. If the wiper is moved several positions,
multiple taps are connected to the wiper for t
V
W
change). The R
TOTAL
value for the device can
temporarily be reduced by a significant amount if the
wiper is moved several positions.
IW
(INC to
When the device is powered-down, the last wiper
position stored will be maintained in the nonvolatile
memory. When power is restored, the contents of the
memory are recalled and the wiper is set to the value
last stored.
R
H
/V
H
V
SS
V
CC
CS
R
L
/V
L
R
W
/V
W
INC
U/D
1
2
3
8
7
6
X9312
DIP/SOIC
Symbol
R
W
/V
R
L
/V
V
SS
V
CC
U/D
INC
CS
Description
Wiper terminal
Low terminal
Ground
Supply voltage
Up/Down control input
Increment control input
Chip select control input
W
L
相關PDF資料 |
PDF描述 |
|---|---|
| X9313USI3 | 50K DIGITAL POTENTIOMETER, INCREMENT/DECREMENT CONTROL INTERFACE, 32 POSITIONS, PDSO8 |
| XAC | 9 CONTACT(S), MALE, MULTIWAY RACK AND PANEL CONN, PLUG |
| XADR-20V | 20 CONTACT(S), FEMALE, TWO PART BOARD CONNECTOR, CRIMP, RECEPTACLE |
| XADR-22V | 22 CONTACT(S), FEMALE, TWO PART BOARD CONNECTOR, CRIMP, RECEPTACLE |
| XADR-24V | 24 CONTACT(S), FEMALE, TWO PART BOARD CONNECTOR, CRIMP, RECEPTACLE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| X9312WPI | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Terminal Voltage 0V to + 15V, 100 Taps |
| X9312WPM | 制造商:XICOR 制造商全稱:Xicor Inc. 功能描述:E2POT⑩ Nonvolatile Digital Potentiometer |
| X9312WS | 制造商:Intersil Corporation 功能描述: 制造商:XICON 功能描述: 制造商:Xicon Passive Components 功能描述: |
| X9312WSI | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Terminal Voltage 0V to + 15V, 100 Taps |
| X9312WSM | 制造商:XICOR 制造商全稱:Xicor Inc. 功能描述:E2POT⑩ Nonvolatile Digital Potentiometer |
發布緊急采購，3分鐘左右您將得到回復。