- 您現在的位置：買賣IC網 > PDF目錄9196 > X9119TV14Z-2.7 (Intersil)IC XDCP SGL 1024TAP 100K 14TSSOP PDF資料下載
參數資料
| 型號： | X9119TV14Z-2.7 |
| 廠商： | Intersil |
| 文件頁數： | 12/17頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC XDCP SGL 1024TAP 100K 14TSSOP |
| 標準包裝： | 95 |
| 系列： | XDCP™ |
| 接片： | 1024 |
| 電阻（歐姆）： | 100k |
| 電路數： | 1 |
| 溫度系數： | 標準值 ±300 ppm/°C |
| 存儲器類型： | 非易失 |
| 接口： | I²C（設備位址） |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 14-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 14-TSSOP |
| 包裝： | 管件 |
4
FN8162.4
July 9, 2008
RW
The wiper pin are equivalent to the wiper terminal of a
mechanical potentiometer.
Bias Supply Pins
SYSTEM SUPPLY VOLTAGE (VCC) AND SUPPLY
GROUND (VSS)
The VCC pin is the system supply voltage. The VSS pin is
the system ground.
Other Pins
NO CONNECT
No connect pins should be left open. These pins are used for
Intersil manufacturing and testing purposes.
Principals of Operation
The X9119 is an integrated microcircuit incorporating a
resistor array and its associated registers and counters and
the serial interface logic providing direct communication
between the host and the digitally controlled potentiometer.
This section provides detail description of the following:
Resistor Array Description
Serial Interface Description
Instruction and Register Description
Resistor Array Description
The X9119 is comprised of a resistor array. The array
contains, in effect, 1023 discrete resistive segments that are
connected in series (Figure 1). The physical ends of each
array are equivalent to the fixed terminals of a mechanical
potentiometer (RH and RL inputs).
At both ends of each array and between each resistor
segment is a CMOS switch connected to the wiper (RW)
output. Within each individual array only one switch may be
turned on at a time. These switches are controlled by the
Wiper Counter Register (WCR). The 10-bits of the WCR
(WCR[9:0]) are decoded to select, and enable, one of 1024
switches.
The WCR may be written directly. The Data Registers and
the WCR can be read and written by the host system.
Serial Interface Description
SERIAL INTERFACE
The X9119 supports a bidirectional bus oriented protocol.
The protocol defines any device that sends data onto the
bus as a transmitter and the receiving device as the receiver.
The device controlling the transfer is a master and the
device being controlled is the slave. The master will always
initiate data transfers and provide the clock for both transmit
and receive operations. Therefore, the X9119 will be
considered a slave device in all applications.
CLOCK AND DATA CONVENTIONS
Data states on the SDA line can change only during SCL
LOW periods. SDA state changes during SCL HIGH are
reserved for indicating start and stop conditions (Figure 3).
START CONDITION
All commands to the X9119 are preceded by the start
condition, which is a HIGH to LOW transition of SDA while
SCL is HIGH. The X9119 continuously monitors the SDA
and SCL lines for the start condition and will not respond to
any command until this condition is met (Figure 3).
SERIAL DATA PATH
FROM INTERFACE
REGISTER 0
SERIAL
BUS
INPUT
PARALLEL
BUS
INPUT
COUNTER
REGISTER
R H
R L
R
W
10
C
O
U
N
T
E
R
D
E
C
O
D
E
IF WCR = 000[HEX] THEN RW = RL
IF WCR = 3FF[HEX] THEN RW = RH
WIPER
(WCR)
(DR0)
CIRCUITRY
REGISTER 1
(DR1)
REGISTER 2
(DR2)
REGISTER 3
(DR3)
FIGURE 1. DETAILED POTENTIOMETER BLOCK DIAGRAM SERIAL INTERFACE DESCRIPTION
R
X9119
相關PDF資料 |
PDF描述 |
|---|---|
| VI-2T0-MW | CONVERTER MOD DC/DC 5V 100W |
| VI-2W0-MY-F2 | CONVERTER MOD DC/DC 5V 50W |
| IDT23S08E-4DCGI | IC CLK MULT ZD STD DRIVE 16-SOIC |
| VI-21H-MY-F4 | CONVERTER MOD DC/DC 52V 50W |
| VI-21H-MY-F3 | CONVERTER MOD DC/DC 52V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| X91RP4 | 功能描述:消費電池與相機電池 AA 2900mAh 4 PK Titanium Alkaline RoHS:否 制造商:FDK Batteries 電池大小:CR1/3N 輸出電壓:3 V 容量:160 mAh 化學性質:Lithium 端接類型:Pressure Contacts 可再充電/不可再充電:Non-Rechargeable |
| X91RP6 | 功能描述:消費電池與相機電池 AA 3135mAh 6 PK Titanium Alkaline RoHS:否 制造商:FDK Batteries 電池大小:CR1/3N 輸出電壓:3 V 容量:160 mAh 化學性質:Lithium 端接類型:Pressure Contacts 可再充電/不可再充電:Non-Rechargeable |
| X91RP8 | 功能描述:消費電池與相機電池 AA 3135mAh 8 PK Titanium Alkaline RoHS:否 制造商:FDK Batteries 電池大小:CR1/3N 輸出電壓:3 V 容量:160 mAh 化學性質:Lithium 端接類型:Pressure Contacts 可再充電/不可再充電:Non-Rechargeable |
| X92000001-01 | 功能描述:以太網模塊 XPress-Pro SW 92000 8-Port 10/100TX RoHS:否 制造商:Lantronix 產品:Device Servers 數據速率:300 bps to 921.6 kbps, 10 Mbps, 100 Mbps 接口類型:Ethernet, Serial 工作電源電壓:5 V to 15 V 工作電源電流:133 mA to 400 mA 最大工作溫度:+ 70 C |
| X92012011-01 | 功能描述:以太網模塊 XPress-Pro SW 92012F 8-Port 10/100TX RoHS:否 制造商:Lantronix 產品:Device Servers 數據速率:300 bps to 921.6 kbps, 10 Mbps, 100 Mbps 接口類型:Ethernet, Serial 工作電源電壓:5 V to 15 V 工作電源電流:133 mA to 400 mA 最大工作溫度:+ 70 C |
發布緊急采購，3分鐘左右您將得到回復。