- 您現在的位置：買賣IC網 > PDF目錄376444 > x60250 (Intersil Corporation) Micro Power Programmable Voltage Reference(微功耗可編程電壓基準) PDF資料下載
參數資料
| 型號： | x60250 |
| 廠商： | Intersil Corporation |
| 英文描述： | Micro Power Programmable Voltage Reference(微功耗可編程電壓基準) |
| 中文描述： | 微功率可編程電壓參考（微功耗可編程電壓基準） |
| 文件頁數： | 15/16頁 |
| 文件大小： | 382K |
| 代理商： | X60250 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁
15
FN8146.1
September 14, 2005
Since this is a single pole rolloff, the actual noise
bandwidth is 1.57 times this, or 97Hz. This should
reduce typical output noise to about 45μV rms. Note that
if the wiper is set to the highest tap positon (tap# = 255)
to give a V
OUT
of 1.25V, the resulting R
DCP
= R
WIPER
or
600
, and the filter bandwidth will now be 2.6kHz,
increasing noise significantly. If tap positions near
V
REFOUT
will be used, then a series resistor R
OUT
should
be added to better control noise bandwidth.
Figure 10. Reducing Output Noise
Higher Reference Voltages
If a reference voltage higher than 1.25V is required, then
an opamp can be added to amplify the V
OUT
voltage.
There are many micropower opamps available, such as
the LMV341, which can produce an output at very close
to either supply rail. Figure 11 shows a circuit for a 0V to
5.0V adjustable reference, which has 8 bits of control.
Note that if the auxiliary resistor is connected to ground
instead of V
REFL
, then the output voltage range will be
2.5V to 5.0V, but resolution will double. Total current
draw from that circuit will be 156μA (typically, with
V
OUT
= 5V) including reference and opamp circuitry.
Note that due to V
CC
supply variations, the output may
not span up to 5.00V which would result in missing codes
at the top end of the DCP range.
Figure 11. Increasing Reference Output Voltage
R
1
C
FILTER
R
OUT
(optional)
V
REFOUT
1.25V
Reference
100K
100K
V
REFL
GND
V
OUT
Filtered
Reference
Voltage
–
+
LMV341
R
1
+5V
0 to
5.0V
4
2
100K
33K
6
1
3
5
20K
C
FILTER
V
REFOUT
1.25V
Reference
100K
100K
V
REFL
GND
X60250
相關PDF資料 |
PDF描述 |
|---|---|
| X60250V8I | Micro Power Programmable Voltage Reference |
| X60250V8IZ | Micro Power Programmable Voltage Reference |
| X79002 | NV DAC with Selectable Output Range and Memory |
| X79000 | NV DAC with Selectable Output Range and Memory |
| X79000V20I | NV DAC with Selectable Output Range and Memory |
相關代理商/技術參數 |
參數描述 |
|---|---|
| X60250V8I | 功能描述:IC VREF SERIES ADJ 8-TSSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電壓基準 系列:- 標準包裝:3,000 系列:- 基準類型:旁路，精度 輸出電壓:5V 容差:±0.5% 溫度系數:100ppm/°C 輸入電壓:- 通道數:1 電流 - 陰極:80µA 電流 - 靜態:- 電流 - 輸出:15mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:TO-236-3，SC-59，SOT-23-3 供應商設備封裝:SOT-23-3 包裝:帶卷 (TR) 其它名稱:LM4040CIM3-5.0MLTRLM4040CIM3-5.0MLTR-ND |
| X60250V8IZ | 功能描述:IC VREF SERIES ADJ 8-TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電壓基準 系列:- 標準包裝:1 系列:- 基準類型:串聯，精度 輸出電壓:4.5V 容差:±800µV 溫度系數:1ppm/°C 輸入電壓:13.5 V ~ 22 V 通道數:1 電流 - 陰極:- 電流 - 靜態:7mA 電流 - 輸出:10mA 工作溫度:-55°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:20-LCC 供應商設備封裝:20-CLCC 包裝:管件 |
| X60M000000L006 | 制造商:AEL Crystals Limited 功能描述:CRYSTAL 60MHZ HC49/U |
| X60R75 | 制造商:Teledyne Relays 功能描述:RELAY SSR 30MA 30V DC-IN 75A 690V AC-OUT 4-PIN - Bulk 制造商:Teledyne Industrial 功能描述: 制造商:Teledyne Relays 功能描述:SOLID STATE RELAY |
發布緊急采購，3分鐘左右您將得到回復。