參數資料
型號: VS1001K
廠商: Electronic Theatre Controls, Inc.
元件分類: Codec
英文描述: MPEG AUDIO CODEC
中文描述: MPEG音頻編解碼器
文件頁數: 28/39頁
文件大?。?/td> 415K
代理商: VS1001K
VLSI
Solution
y
DATASHEET
VS1001
K
8. OPERATION
8
Operation
8.1
Clocking
The VS1001k chip operates typically on a single 24.576 MHz fundamental frequency master clock. This
clock can be generated by external circuitry (connected to pin XTALI) or by the internal clock chrystal
interface (pins XTALI and XTALO). This clock is sufficient to support a high quality audio output for
almost all the standard sample rates and bit-rates (see Application Notes for VS10XX).
Note: Oscillators above 24.576 MHz are usually so-called
3
rd
harmonic clocks, which have a fundamen-
tal frequency of 1/3 of the nominal clock frequency. With such an oscillator, VS1001 would be running at
the base frequency, if working at all. Thus, for instance, if you run VS1001 with a 32 MHz
3
rd
harmonic
clock, you usually end up running the chip at 32 MHz / 3 = 10.67 MHz.
8.2
Powerdown
In powerdown mode the chip only monitors the control bus. The analog output drivers are turned off and
the processor remains in hold-state.
8.3
Hardware Reset
When the XRESET -signal is driven low, VS1001k is reset and all the control registers and internal
states are set to the initial values. XRESET-signal is asynchronous to any external clock. The reset mode
doubles as a full-powerdown mode, where both digital and analog parts of VS1001k are in minimum
power consumption stage, and where clocks are stopped. Also XTALO and XTALI are grounded.
After a hardware reset (or at power-up), set the basic software registers such as VOL for volume (and
CLOCKF if the input clock is anything else than 24.576 MHz) before starting decoding.
8.4
Software Reset
Between any two MP3 files, the decoder software has to be reset. This is done by activating bit 2 in SCI’s
MODE register (Chapter 7.5.1). Then wait for at least 2
μ
s, then look at DREQ. DREQ will stay down
for at least 6000 clock cycles, which means an approximate 250
μ
s delay if VS1001k is run at 24.576
MHz. When DREQ goes up, write at least one zero to SDI. After this, you may continue playback as
usual.
If you want to make sure VS1001k doesn’t cut the ending of low-bitrate data streams, it is recommended
to feed 2048 zeros to the SDI bus before activating the reset bit (DREQ must be respected just as with
normal SDI data). This will make sure all frames have been decoded before resetting the chip.
Version 4.11,
2003-09-18
28
相關PDF資料
PDF描述
VS1003 MP3 / WMA AUDIO CODEC
VS100 Interface IC
VS100AE CAMERA MONOCHROME
VS1024 AREA CCD IMAGE ARRAY
VS10P05 Direct ProTek Replacement:VS10P05
相關代理商/技術參數
參數描述
VS1002D 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MP3 AUDIO CODEC
VS1003 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MP3 / WMA AUDIO CODEC
VS1003-BB 制造商:Distributed By MCM 功能描述:VS1003 MP3/WMA BREAKOUT BOARD
VS1003B-L 制造商:CONSONANCE 制造商全稱:CONSONANCE 功能描述:芬蘭VLSI廠家生產的音頻編解碼芯片
VS100-48 制造商:TDK-Lambda Corporation 功能描述:105.6W AC To DC Switching Power Supply - 85-132V/110-175V in - 48V 2.2A out